Drive Application Software Application Set Application Set Title Drive Product File Name for (AS) Date / Firmware Rev. Analog Speed Ref PowerFlex 700S AC Drive Phase II AS_PF700SII_AnalogSpdRef_A.dno 02/03/06 3.01 Attention: This document and related file(s) are designed to supplement configuration of the listed drive product. The information provided does not replace the drive products user manual and is intended for qualified personnel only. Description: Analog speed reference with 3Wire Start/Stop Control. Limitations: Options & Notes: 1. See option in the parameter table. 2. Default configuration for 3Wire Control through digital inputs may be changed to 2Wire Control or for operation through 20-COMM-x module. Drive Input & Output Connections: Inputs Function DI 1 DI 2 DI 3 DI 4 Start DI 5 Stop DI 6 HW Enable AI 1 Speed Reference AI 2 AI 3 Outputs Function DO 1 DO 2 DO 3 AO 1 AO 2 AO 3 AS_PF700SII_AnalogSpdRef_A.doc Form Revision – A Page 1 of 2 Description 0-10v Description Drive Application Software Application Set Parameter Configurations Changes from Default Parameter Settings Par Name Value b0 = 0 153 Control Options b6 = 1 b8 = 1 27 Speed Ref A Sel Speed Ref 1 10 Speed Ref 1 11 Spd Ref1 Divide **** Optional - 32 33 828 829 802 804 805 808 810 811 30 Accel Time Decel Time DigIn4 Sel DigIn5 Sel Anlg In1 Scale AI 1 Filt Gain Anlg In1 Filt BW Anlg In2 Scale AI 2 Filt Gain Anlg In2 Filt BW Min Spd Ref Lim 10 10 Start Normal Stop 10 0.25 50 10 0.25 50 0 31 Max Spd Ref Lim Dflt= 2170 AS_PF700SII_AnalogSpdRef_A.doc Form Revision – A Page 2 of 2 Link 800 100 Description Bipolar SRef Stop in Torq – Stop function if in torque control mode 3Wire Control Base Speed reference 0 to 100% of Motor base speed Speed Reference scale Use to scale the sections machine speed to the desired value (or Motor Rpm). At 100% speed the motor will run base speed. The speed reference value is scaled so 1pu = base speed motor Rpm. Set scaling of speed reference in p11 to 100 and then use p38 [Speed Ref Scale] to scale the final speed reference. A setting of 1 in p38 will = mtr base speed. A setting of 1.1 in p38 will = 110% mtr base speed. Etc. Example(1750*1.1=1925rpm) Set per application requirements Set per application requirements Start input for 3wire control Stop input for 3wire control Scale AI1 for 0 to 10v = 0 to 100 (% Speed) Light filtering Light filtering Scale AI1 for 0 to 10v = 0 to 100% Light filtering Light filtering Forward operation only Adjust as need to allow required speed – should be within 10% of max speed required