VIL410 IOT Transmitter 30 kW CW, 1.3 GHz Liquid cooled GaN Solid State Power Amplifier Driver Four Port Circulator (optional) Designed for Superconducting RF Accelerator Applications This high power amplifier utilizes the CPI VKL9130A1 IOT and the CPI VSL3616 GaN SSPA and highly stable power supply for high gain, high efficiency and excellent phase and amplitude stability. VIL-410 VIL-410 with 4 port circulator The information listed above represents typical data for the product . The data should be used for basic information only. Formal, controlled specifications should be obtained from CPI for use in equipment design. For information on this and other CPI products visit our webpage at www.cpii.com, or contact CPI Beverly Microwave Division, 150 Sohier Road, Beverly, MA 01915 Telephone: 1 (978) 922-6000 FAX: 1 (978) 922-2736 email: [email protected] CPI │ IOT Transmitter IOT Transmitter - 1.3 GHz, 30 kW CW Electrical Parameters Electrical, Mechanical and Environmental Parameters Frequency Range 1.2975 to 1.3025 GHz Prime Power 380 VAC (3phase with neutral) 50/60 Hz RF Output 30 kW CW nominal, adjustable from 2 kW to 30 kW Current (service rating) 200 A Duty Cycle CW and pulsed Current draw 122 Arms Power Gain 82 dB minimum Ambient Temperature +15C to +25C operating Shock and Vibration Output VSWR 6:1 maximum Ground Benign (typical transportation) SNR -70dBc min Cooling Amplitude Stability* 0.2% / 20 seconds with constant RF Input with coolant +/- 0.2°C Water, +20 to +35C, 18 GPM (restricted temperature range for tighter stability) RF Input Connection N-type female – front panel RF Output Connection WR650 waveguide Control I/O Ethernet Dimensions (width) 73 inches max (185 cm) (172 inches max with circulator) Dimensions (height) 81 inches max (206cm) Dimensions (depth) 37 inches max (94 cm) (41 inches max with circulator) Amplitude Ripple* 0.1% rms after 20 minute warm up, coolant +/- 0.2°C Phase Ripple* 0.20° rms after 30 minute warm up, coolant +/- 0.2°C Phase Pushing ± 8°max * Stability and Ripple measurements are specified after warm-up is complete and are dependent upon ambient and coolant conditions being well controlled. 06/14 The information listed above represents typical data for the product . The data should be used for basic information only. Formal, controlled specifications should be obtained from CPI for use in equipment design. For information on this and other CPI products visit our webpage at www.cpii.com, or contact CPI Beverly Microwave Division, 150 Sohier Road, Beverly, MA 01915 Telephone: 1 (978) 922-6000 FAX: 1 (978) 922-2736 email: [email protected] CPI │ IOT Transmitter IOT Transmitter - 1.3 GHz, 30 kW CW