Model GMA-100QB Quad Band On-The-Move Antenna Features: • Quad Band (L, S, C, and Ku) • Bi-Directional in All Bands • RSSI for Rapid Signal Location and Acquisition • Built-In RF Electronics • Churchville B Capable Ground OTM • Self-Contained Automatic Heading Reference Sensor (AHRS) • 2-Axis Directional High Gain Antenna and Omnidirectional Antenna • Serial and Ethernet Command Interfaces The GMA-100QB antenna system provides on-the-move (OTM) line of sight (LOS) bi-directional communications capability for ground vehicles to link to UAVs in L, S, C, and Ku-bands. Capable of Churchville B OTM performance, the GMA-100QB is equipped with high performance motors/ drives on both axes to easily handle the high dynamic loads, and is stabilized by internal AHRS, allowing full independence from vehicle data. The receiver with built in Received Signal Strength Indicator (RSSI) allows the antenna to rapidly scan the sky for all available signals and quickly point to the desired airborne asset, eliminating the delay of external Model GMA-100QB Quad Band On-The-Move Antenna modem decoding of the signal. Embedded amplifiers on transmit/receive at all bands allow a full communications system with only the addition of external DC power and a modem. The GMA-100QB includes both a compact multiband high gain directional antenna array, enabling long range LOS datalinks, and a broadband omnidirectional antenna for close-in/overhead communications. Frequency band and antenna selection is electronically commanded. Model GMA-100QB - Quad Band On-The-Move Antenna Specifications* KEY PERFORMANCE VALUES WITH STANDARD HARDWARE COMPLEMENT L/S-band C-band Ku-band RF/Electrical Parameters 14.4 - 15.35 GHz 1.6 - 2.5 GHz 4.4 - 5.85 GHz Frequency Range 25 dBi 7-9 dBi 12 dBi Gain (Typical) 6° 50° 15° Beamwidth - Azimuth 10° 70° 64° Beamwidth - Elevation 2 dB N/A N/A Axial Ratio RHCP Linear Linear Polarization Mechanical Parameters Positioner Type Velocity Acceleration Azimuth Positioning Range Elevation Positioning Range Pointing Accuracy Weight Size Direct Drive; Brushless DC Motor 250°/sec 500°/sec2 0° to 360°, continuous rotation -9° to 89° <0.25° 30 lbs. 13.3” Diameter x 14.5” Height Electrical Parameters RF Connectors Control Interface Connector Control Interface Operating Voltage Transmit Power Power Consumption (RX/TX) 1 TX Type N; 1 RX Type N: Others Available GlenAir 801 Series, 19 pin RS-422, Ethernet Optional 28 VDC; optional 12 VDC Up to 3W CW each band 30 Watts / 60 Watts at room temperature Environmental Parameters Temperature - Operating Vibration Radome -30°C to +55°C MIL-STD-810G, Figure 514.6C-3 Yes Options Received Signal Strength Indicator (RSSI) Capability * Specifications are subject to change. Model GMA-100QB Quad Band On-The-Move Antenna CPI Malibu Division • 3760-A Calle Tecate, Camarillo, CA 93012-5060 • Tel: (805) 383-1829 • Fax: (805) 383-1859 • www.cpii.com/malibu