RFMD + TriQuint = Qorvo RFRX1702 RFRX1702 GaAs MMIC IQ Downconverter 17.7GHz to 19.7GHz RFMD's RFRX1702 is a 17.7GHz to 19.7GHz GaAs pHEMT Downconverter, incorporating a low-noise amplifier, an integrated X2 LO frequency multiplier and buffer amplifier, and an image rejection mixer. The combination of high performance part and low cost packaging makes the RFRX1702 a cost effective solution, ideally suited to both current and next generation Point-to-Point Microwave Radio and Satellite Applications. RFRX1702 is packaged in a 5mm x 5mm QFN to simplify both system level board design and volume assembly. Package: QFN, 32-pin, 5mm x 5mm x 0.95mm Features ■ RF Frequency: 17.7GHz to 19.7GHz ■ LO Frequency: 6.85GHz to 11.85GHz ■ IF Frequency: DC to 4GHz ■ Conversion Gain: 12dB ■ Noise Figure: 2dB ■ IIP3: 6dBm ■ Image Rejection: 15dBc ■ Low Cost 5mm x 5mm QFN Package Applications ■ Point-to-Point Radio ■ Point-Multipoint Radio ■ Satellite Communications ■ Radar ■ Electronic Warfare Functional Block Diagram Ordering Information RFRX1702S2 Sample bag with 2 pieces RFRX1702SB Bag with 5 pieces RFRX1702SQ Bag with 25 pieces RFRX1702SR 100 Pieces RFRX1702TR7 7" Reel with 750 pieces RFRX1702PCBA-410 Evaluation board Revision DS20150617 © 2015 RF Micro Devices, Inc. 1 of 10 Disclaimer: Subject to change without notice www.rfmd.com / www.qorvo.com RFRX1702 RFMD + TriQuint = Qorvo Caution! ESD sensitive device. Absolute Maximum Ratings Parameter Rating Unit LNA Drain Voltage +6.0 V LOA Voltage +6.0 V RF Input Power +10 dBm LO Input Power +15 dBm Operating Temperature Range -40 to +85 °C Storage Temperature Range -40 to +150 °C Class 1A V ESD Rating - Human Body Model (HBM) RFMD Green: RoHS status based on EU Directive 2011/65/EU (at time of this document revision), halogen free per IEC 61249-2-21, < 1000ppm each of antimony trioxide in polymeric materials and red phosphorus as a flame retardant, and <2% antimony in solder. Exceeding any one or a combination of the Absolute Maximum Rating conditions may cause permanent damage to the device. Extended application of Absolute Maximum Rating conditions to the device may reduce device reliability. Specified typical performance or functional operation of the device under Absolute Maximum Rating conditions is not implied. Electrical Specifications Parameter Specification Min Typ Unit Condition Max Test conditions unless otherwise noted: IF = 2.5GHz, RF Power = -20dBm, IIP3 is measured with a 2-tone input of -23dBm power for each tone and Δf = 10MHz, Vd1 = 2.8V, Vd2 = 4V, Vd3 through Vd5 = 4.5V, MixerBias = 0V, 50 Ω system RF Frequency Range 17.7 19.7 GHz LO Frequency Range 6.85 11.85 GHz IF Frequency Range DC 4.0 GHz LO Input Power +5 dBm Conversion Gain 13 dB NF (17.7 – 19.7 GHz) 2 dB IIP3 6 dBm Image Rejection 15 dB LO-to-RF Isolation 40 dB LO-to-IF Isolation 15 dB LO Return Loss 12 dB RF Return Loss 12 dB VD 2.8 to 4.5 V ID 350 mA Revision DS20150617 © 2015 RF Micro Devices, Inc. 2 of 10 Disclaimer: Subject to change without notice www.rfmd.com / www.qorvo.com RFRX1702 RFMD + TriQuint = Qorvo Typical Performance Measurements performed on part soldered on evaluation board with SMA connectors and IF ports connected to an external 90° Hybrid Combiner and LO Power of +5dBm and at 25°C, unless otherwise noted. IF = 2.5GHz, RF Power = -20dBm, IIP3 is measured with a 2-tone input of -23dBm power for each tone and Δf = 10MHz, Vd1 = 2.8V, Vd2 = 4V, Vd3 through Vd5 = 4.5V, MixerBias = 0V. Revision DS20150617 © 2015 RF Micro Devices, Inc. 3 of 10 Disclaimer: Subject to change without notice www.rfmd.com / www.qorvo.com RFRX1702 RFMD + TriQuint = Qorvo Typical Performance (continued) Revision DS20150617 © 2015 RF Micro Devices, Inc. 4 of 10 Disclaimer: Subject to change without notice www.rfmd.com / www.qorvo.com RFRX1702 RFMD + TriQuint = Qorvo Typical Performance (continued) Spur tables are |M fLO + N fRF | mixer spurious products for -20 dBm RF input power. All values in dBc below the IF output power level. M x N Spurious Outputs for LSB, IF = 1.5 GHz, IF = 2LO – RF M N 1 2 3 4 5 -2 69 70 61 36 72 -1 37 0 56 71 62 0 29 27 34 31 -- 1 67 56 55 -- -- 2 57 -- -- -- -- M x N Spurious Outputs for USB, IF = 1.5 GHz, IF = RF – 2LO M N 1 2 3 4 5 -2 69 71 75 47 54 -1 55 0 29 41 66 0 21 26 67 40 59 1 69 49 56 -- -- 2 54 -- -- -- -- Revision DS20150617 © 2015 RF Micro Devices, Inc. 5 of 10 Disclaimer: Subject to change without notice www.rfmd.com / www.qorvo.com RFRX1702 RFMD + TriQuint = Qorvo Evaluation Board Schematic C4 1uF C3 100 pF C14 4.7uF C2 1uF C1 100 pF C16 4.7uF LSB C10 1uF C7 100pF C9 100pF USB C13 4.7uF C8 1uF C15 4.7uF C5 100 pF C6 1uF C11 100pF C12 1uF C17 4.7uF C18 4.7uF Evaluation Board Bill of Materials (BOM) Description Reference Designator Manufacturer Manufacturer's P/N CAP, 100pF, 5%, 25V, C0G, 0201 C1, C3, C5, C7, C9, C11 Taiyo Yuden (USA), Inc. RM TMK063 CG101JT-F CAP, 1uF, 10%, 6.3V, X5R, 0402 C2, C4, C6, C8, C10,C12 Taiyo Yuden (USA), Inc. RM JMK105BJ105KVLF C13 thru C18 Murata Electronics GRM188R60J475KE19D CONN, SMA, HI-FREQ END LNCH, SQ 4-HOLE J1,J3,J4 Emerson Network Power 142-0761-811 CONN, 2.92MM, END LAUNCH, 40GHz, SQ FLG J2 Southwest Microwave, Inc 1092-01A-5 CAP, 4.7uF, 10%, 6.3V, X5R, 0603 Revision DS20150617 © 2015 RF Micro Devices, Inc. 6 of 10 Disclaimer: Subject to change without notice www.rfmd.com / www.qorvo.com RFRX1702 RFMD + TriQuint = Qorvo Evaluation Board Assembly Drawing GND Vd2(4V) GND Vd3(4.5V) Vd4(4.5V) Vd1(2.8V) GND Vd5(4.5V) RFRX 1702 YYWW Trace Code Mixer(0V) Test Conditions LO Power RF Power Vd1 Vd2 Vd3, Vd4, Vd5 Mixer Bias Revision DS20150617 © 2015 RF Micro Devices, Inc. +5dBm -20dBm 2.8V 4.0V 4.5V 0V 7 of 10 Disclaimer: Subject to change without notice www.rfmd.com / www.qorvo.com RFRX1702 RFMD + TriQuint = Qorvo Pin Out Package Outline and Branding Drawing (Dimensions in millimeters) Revision DS20150617 © 2015 RF Micro Devices, Inc. 8 of 10 Disclaimer: Subject to change without notice www.rfmd.com / www.qorvo.com RFRX1702 RFMD + TriQuint = Qorvo Pin Names and Descriptions Pin Name 1-4 N/C Not Connected 5 GND Ground 6 RF 7 GND Ground 8-9 N/C Not Connected 10 GND Ground 11 IF1 12 GND 13 IF2 14 GND 15 Mixer Bias Mixer Bias = 0V 16 N/C Not Connected 17 GND Ground 18 LO 19 GND Ground 20-24 N/C Not Connected 25 Vd5 Vd5 (LOA bias) = 4.5V 26 Vd4 Vd5 (LOA bias) = 4.5V 27 N/C Not Connected 28 Vd3 Vd5 (LOA bias) = 4.5V 29 N/C Not Connected 30 Vd2 LNA drain bias2 = 4V 31 N/C Not Connected 32 Vd1 LNA drain bias2 = 2.8V Revision DS20150617 © 2015 RF Micro Devices, Inc. Description RF Input, AC coupled and matched to 50Ω IF1 Output Ground IF2 Output Ground LO Input, AC coupled and matched to 50Ω 9 of 10 Disclaimer: Subject to change without notice www.rfmd.com / www.qorvo.com RFRX1702 RFMD + TriQuint = Qorvo Contact Information For the latest specifications, additional product information, worldwide sales and distribution locations: Web: www.rfmd.com Email: [email protected] Tel: 1-844-890-8163 For information about the merger of RFMD and TriQuint as Qorvo: Web: www.qorvo.com Important Notice The information contained herein is believed to be reliable. RFMD makes no warranties regarding the information contained herein. RFMD assumes no responsibility or liability whatsoever for any of the information contained herein. RFMD assumes no responsibility or liability whatsoever for the use of the information contained herein. The information contained herein is provided "AS IS, WHERE IS" and with all faults, and the entire risk associated with such information is entirely with the user. All information contained herein is subject to change without notice. Customers should obtain and verify the latest relevant information before placing orders for RFMD products. The information contained herein or any use of such information does not grant, explicitly or implicitly, to any party any patent rights, licenses, or any other intellectual property rights, whether with regard to such information itself or anything described by such information. RFMD products are not warranted or authorized for use as critical components in medical, life-saving, or life-sustaining applications, or other applications where a failure would reasonably be expected to cause severe personal injury or death. Revision DS20150617 © 2015 RF Micro Devices, Inc. 10 of 10 Disclaimer: Subject to change without notice www.rfmd.com / www.qorvo.com