RJ45 TERMINATION INSTRUCTIONS NON-SHIELDED

RJ45 TERMINATION INSTRUCTIONS NON-SHIELDED CABLE
COMPONENTS
STEP 4:
Flatten conductors, cut the conductors
straight, and insert the conductors into
the load bar.
STEP 1:
Strip cable jacket approximately 1¼
inches [31.75mm].
STEP 2:
Organize conductors.
STEP 3:
Maintain twists near the cable jacket.
STEP 5:
Push the load bar up against the
twists.
STEP 6:
Cut the conductors flush to
approximately ½ inch [12.7mm].
STEP 7:
Pull the load bar to the end of the
conductors.
0.5
STEP 8:
Insert the plug housing. Push forward
until the conductors engage their
openings.
STEP 9:
When the conductors are fully in
their openings, the plug is ready to
terminate.
STEP 10:
Terminate/crimp the plug with one of
the recommended tools (see customer
drawing).
TERMINATED PLUG