Bel Stewart Connector 37 SERIES SHIELDED PLUG ASSEMBLY INSTRUCTIONS 11118 Susquehanna Trail South Glen Rock, PA 17327 37 SERIES SHIELDED PLUG ASSEMBLY INSTRUCTIONS Assembly steps 1 – 16: 1 2 Slide Strain Relief over cable 3 Strip off approx. 1” of cable jacket Fold outer shielding and drain wire back over cable jacket Brown Orange 4 Slip shielding ferrule over outer shield and drain wire 5 6 Crimp ferrule with brown and orange pairs to the outside Remove individual pair shields Even Row 7 Straighten and align pairs (TIA-586 B Wiring Shown) Page 1 of 3 Odd Row 8 A264 Management Bar –Odd and Even rows 9 Pull Even (2, 4, 6, & 8) contacts away MN370055-A0 Bel Stewart Connector 37 SERIES SHIELDED PLUG ASSEMBLY INSTRUCTIONS 11118 Susquehanna Trail South Glen Rock, PA 17327 37 SERIES SHIELDED PLUG ASSEMBLY INSTRUCTIONS Assembly steps 1 – 16 (Cont.): 10 11 Trim Odd wires (1, 3, 5, & 7) at an angle 13 0.5” Trim off excess lead length. Use plug housing as guide Insert Odd wires into Odd row of load bar 14 Ensure wires are inserted fully 12 Lay Even wires into even row 15 Crimp contacts 16 Slide strain relief over plug housing. Assembly is now complete Page 2 of 3 MN370055-A0 Bel Stewart Connector 37 SERIES SHIELDED PLUG ASSEMBLY INSTRUCTIONS 11118 Susquehanna Trail South Glen Rock, PA 17327 37 SERIES SHIELDED PLUG ASSEMBLY INSTRUCTIONS Alternate Steps For 370808M2-MB Management Bar: Even Row 8a 12a Odd Row Odd and Even Rows Page 3 of 3 Trim Even wires 2, 4, 6, & 8 flush with bottom of Management Bar and insert MN370055-A0