75 Ohm SMC Jack Bulkhead Connector Clamp/Solder Attachment For RG180, RG195, .285 inch D Hole TECHNICAL DATA SHEET PE4283 75 Ohm SMC Jack Bulkhead Connector Clamp/Solder Attachment For RG180, RG195, .285 inch D Hole Configuration Connector Connector Interface Type Cable Attachment Method (Shield/Contact) Body Style Mount Method SMC Jack RG180,RG195 Clamp/Solder Straight Bulkhead Electrical Specifications Impedance, Ohms 75 Mechanical Specifications Size Length, in [mm] Width/Dia., in [mm] 0.845 [21.46] 0.342 [8.69] Weight, lbs [g] 0.013 [5.9] Connector Type Contact Material and Plating Body Material and Plating Dielectric Type SMC Jack Gold Brass, Nickel PTFE . Compliance Certifications (visit www.Pasternack.com for current document) RoHS Compliant Yes Plotted and Other Data Notes: Values at 25 °C, sea level 75 Ohm SMC Jack Bulkhead Connector Clamp/Solder Attachment For RG180, RG195, .285 inch D Hole from Pasternack Enterprises has same day shipment for domestic and International orders. Our RF, microwave and fiber optic products maintain a 99% availability and are part of the broadest selection in the industry. Click the following link (or enter part number in “SEARCH” on website) to obtain additional part information including price, inventory and certifications: 75 Ohm SMC Jack Bulkhead Connector Clamp/Solder Attachment For RG180, RG195, .285 inch D Hole PE4283 URL: http://www.pasternack.com/smc-jack-standard-rg180-rg195-connector-pe4283-p.aspx PE4283 REV 01 1 © 2013 Pasternack Enterprises All Rights Reserved PE4283 REV 01 3. SOLDER CONTACT (5) TO CENTER CONDUCTOR. INSERT CABLE ASSEMBLY INTO BODY & TIGHTEN. 2. SLIDE BRAID CLAMP (3) OVER DIELECTRIC & UNDER BRAID. PUSH INTO WASHER UNTIL IT STOPS. STRIP CABLE AS SHOWN IN B. TRIM EXCESS BRAID FLUSH WITH SURFACE OF COMPRESSION WASHER (2). INSERT INSULATOR (4) OVER DIELECTRIC WITH CENTER CONDUCTOR PROTRUDING THROUGH HOLE. 1. SLIDE CLAMP NUT (1) OVER CABLE. STRIP CABLE AS SHOWN IN A. SLIDE COMPRESSION WASHER (2) OVER BRAID & SEAT AGAINST JACKET. FLAIR BRAID OVER COMPRESSION WASHER (2). ASSEMBLY PROCEDURES REV. - CAD FILE 042409 SCALE N/A SIZE A 2233 NOTES: 1. UNLESS OTHERWISE SPECIFIED ALL DIMENSIONS ARE NOMINAL. 2. ALL SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE AT ANY TIME. 3. DIMENSIONS ARE IN INCHES [mm]. 4. FITS MIL-C-17 AND EQUIVALENT CABLES. FSCM NO. 53919 PE4283 DWG TITLE 75 Ohm SMC Jack Bulkhead Connector Clamp/Solder Attachment For RG180, RG195, .285 inch D Hole PE4283 CAD Drawing 2