PRODUCT DATASHEET ET-5RS REAL-TIME-RING™ ETHERNET SWITCH WITH 5 PORTS The ET-5RS is a 5 port industrial Ethernet switch featuring Sixnet’s Real-Time-Ring™ which provides very fast, fault-tolerant network redundancy and prioritized message delivery needed in critical real-time systems. These Rings self-configure and just run, without the complex configuration steps required by alternative solutions. This advanced technology delivers reliability and performance, saves you money, and makes your job easier. PRODUCT HIGHLIGHTS 5 ports with up to two fiber optic ports Super-fast, fault tolerant ring redundancy Pre-configured for true plug and play simplicity Truly rugged design with -40 to 85°C operation Dual power with MIL-STD-1275 protection IDEAL FOR Real-time control Distributed systems Outdoor / marine use REAL-TIME FAULT-TOLERANT RINGS Recovery time of 30 mS plus 5 mS per hop! Ideal for deterministic systems and PLCs Real-time Modbus over Ethernet monitoring REAL-TIME TRAFFIC PRIORITIZATION Assure delivery of real-time data Improve network utilization User settable priority assignments MANAGED SWITCH FEATURES – At a Lower Cost User configurable port settings Port mirroring for traffic diagnostics Message filtering to prevent broadcast storms TROUBLE FREE OPERATION Firmware upgrades are FREE forever Ultra-reliable 1,000,000 hours MTBF -40 to +85 °C operating range UL/CSA, (CUL), CE, and Hazloc (zone 2) SOLUTIONS FOR YOUR INDUSTRIAL NETWORKING CHALLENGES WWW.SIXNET.COM REAL-TIME-RING™ ETHERNET SWITCH WITH 5 PORTS SPECIFICATIONS ET-5RS ETHERNET COMPLIANCE IEEE 802.3 (10Mbps Ethernet supports legacy devices) IEEE 802.3u (Fast Ethernet 100Mbps for newer devices) Intelligent store & forward Ethernet switch IEEE 802.3x (Full-Duplex with Flow Control) Ethernet protocols supported all IEEE 802.3 IEEE 802.1p (QoS / CoS – Quality & Class of Service) RJ45 ports (shielded) 10/100BaseTX POWER INPUT RJ45 speed (10 or 100 Mbps) auto-negotiation Input power (typical - all ports active at 100 Mbps) 4.0 W (model -1 without fiber) RJ45 MDI/MDIX auto-crossover 5.0 W (model -2 & -3 with 1 fiber) RJ45 TD and RD auto-polarity 6.0 W (models -4 & -5 with 2 fiber) Fiber optic port speed 100BaseFX (100 Mbps) Power Input 10-50 VDC (Derate 1.8°C / V above 30V) Fiber optic port wavelength 1300 nm center typ. MIL-STD-1275 power protection standard Fiber multimode 50- 62.5/125 um (SC or ST) Military surge protection 100 volts for 1 second Transient protection 15,000 watts peak Fiber singlemode 8-10 9/125 um (SC or ST) Spike potection 5,000 watts (10x for 10 uS) or 250 volts (50x Fiber maximum distance (full duplex) 4 km (mm), 20 km for 100 uS) (sm), 40 km (long haul) or more ENVIRONMENTAL Typical latency for 10 Mbps ports 16 us + frame time; Operating temperature range -40 to +85 °C Typical latency for 100 Mbps ports 5 us + frame time; varies Storage temperature range -40 to +85 °C on load and settings Humidity (non-condensing) 5 to 95% RH Full or half duplex operation configurable Vibration IEC60068-2-6 MAC addresses supported 2048 STANDARDS COMPLIANCE Memory bandwidth 3.2 Gbps Electrical safety - UL508/CSA C22.2/4: EN61010-1, CE EMI emissions - FCC part 15, ICES-003; EN61000-6-4, CE Ethernet isolation 1500 VRMS 1 minute EMC immunity - EN61000-6-2, CE REAL-TIME-RING™ FEATURES Hazardous locations: UL1604/CSA C22.2/213 (Class I, Div. Maximum switches in ring: 50+ 2); EN60079-15 (Zone 2, Category 3), CE (ATEX) Dual ring support Eye safety (fiber models) IEC60825-1, Class 1; FDA 21 CFR 1040.10 and 1040.11 Link loss recovery time: 30mS + 5mS/hop PHYSICAL STATUS REPORTING DIN rail or direct panel mounting Modbus Ethernet over UDP Case (UL 94V-0 Lexan & rust-free aluminum case) IP30 “OK” contact output up to 0.5 Amp protection Dimensions - see mechanical drawing ETHERNET PERFORMANCE 5 Ethernet ports total ORDERING GUIDE RJ45 Ports 5 FIBER Ports ET-5RS-2SC-E1 4 1 multimode SC 4 km ET-5RS-2ST-E1 4 1 multimode ST 4 km ET-5RS-3SC-E1 4 1 singlemode SC 20 km ET-5RS-3ST-E1 4 1 singlemode ST 20 km ET-5RS-3SCL-E1 4 1 singlemode SC 40 km ET-5RS-3STL-E1 4 1 singlemode ST 40 km ET-5RS-4SC-E1 3 2 multimode SC 4 km ET-5RS-4ST-E1 3 2 multimode ST 4 km ET-5RS-5SC-E1 3 2 singlemode SC 20 km ET-5RS-5ST-E1 3 2 singlemode ST 20 km ET-5RS-5SCL-E1 3 2 singlemode SC 40 km ET-5RS-5STL-E1 3 2 singlemode ST 40 km ET-5RS-1-E1 All specifications are subject to change. Consult factory for latest info. MECHANICAL DRAWING Note: Contact Sixnet for special or long haul fiber transceivers up to 120 km The suffix 1 means preconfigured for 1 ring. Contact Sixnet for other options. Sixnet Technology Park 331 Ushers Road • Ballston Lake, NY 12019 • USA 1.518.877.5173 • Fax 1.518.877.8346 • [email protected] SOLUTIONS FOR YOUR INDUSTRIAL NETWORKING CHALLENGES Datasheet ET-5RS Rev April 15, 2009 WWW.SIXNET.COM