DC Solid State Relay NEW! Series C62

NEW! Series C62
DC Solid State Relay
NORMALLY ON, OPTICALLY ISOLATED 0.2 A, 200 VDC
Part Number
Relay Description
C62-20
0.2A, 200 Vdc, DC Solid State Relay, Normally on
6 Pin DIP Plastic (for surface mount add “s” prefix)
ELECTRICAL SPECIFICATION
( -20°C TO +85°C, Ambient Temperature UNLESS OTHERWISE SPECIFIED)
INPUT (CONTROL) SPECIFICATION
Min
Input Current
Typ
8
Max Units
50
Turn-On
FEATURES
mA dc
0.1 mA dc
Turn-Off
8.0
•
•
•
•
•
•
mA dc
OUTPUT (LOAD) SPECIFICATION
Min
Typ
Max Units
Current Rating (Continuous)
0.20
Adc
Operating Voltage (Continuous)
200
Vdc
0.80
Vdc
o
Output Voltage Drop @ 25 C
Low on resistance
Normally on without Input
Optical Isolation
Paralleling capability
Small Package
SMT
APPLICATIONS
• Protection circuits
• Normally on switch
@ Rated Load Current (Input Current = 0 mA)
DESCRIPTION
ON Resistance
@ TJ = 25 oC
4.0
ohm
@ TJ = 85 oC
6.7
ohm
25
µA
Leakage Current @ V = 200 Vdc
(See Note 2)
Turn-On Time
4.50 mSec
Turn-Off Time
400 µSec
Insulation Resistance @ 500 Vdc
100
3
pF
Output Capacitance @ 25 Vdc,
© 2000 TELEDYNE RELAYS
Opto isolated control feature, high
reliability, small size and low weight
makes this normally on solid state switch
a good replacement for the
electromechanical switch.
Meg Ohm
Isolation (Input to Output Capacitance)
100 KHz, IIN= 15 mA
Normally On solid state switches are
electronic replacements for the
conventional normally On
electromechanical-relay.
BLOCK DIAGRAM
100
pF
800-284-7007 • www.teledynerelays.com
Page 51
C62
ENVIRONMENTAL SPECIFICATIONS
OUTPUT (LOAD) SPECIFICATION
Min
Typ
Output high
Max Units
Input
Dielectric Withstanding Voltage
750
Input
Junction Temperature (TJ Max)
125
o
100
o
Vrms
Output Low
Storage Temperature
-40
Thermal Resistance Junction to Ambient (θJA)
125
Weight
1.0
C
C
WIRING DIAGRAM
C/W
Figure 2
o
gm
MECHANICAL SPECIFICATIONS
TYPICAL INPUT FORWARD CURRENT
VS. FORWARD VOLTAGE
Figure 3
TYPICAL TURN-OFF TIME
VS. INPUT CURRENT
Figure 4
NOTES:
1.
2.
3.
4.
Figure 1
Page 52
Series resistor is required to limit input current to 50 ma maximum.
The input current is 15 ma tests unless otherwise specified.
Loads may be connected to positive or negative referenced power supplies.
Inductive loads must be diode suppressed.
Continuous load current is rated under the conditions of still air and mounted on a
printed circuit board.
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE
© 2000 TELEDYNE RELAYS