Filename: tfs 215c.doc Version 1.1 VI TELEFILTER 4.3.2008 Filter specification Measurement condition Ambient temperature: Input power level: Terminating impedance: * Input: Output: External Coil: 23 0 TFS 215C 1/5 °C dBm 1000 1000 120 || -2,33 pF || -2,08 pF nH Characteristics Remark: The reference level for the relative attenuation arel of the TFS 215C is the minimum of the pass band attenuation amin. The minimum of the pass band attenuation amin is defined as the insertion loss ae. The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 3 dB filter attenuation level relative to the insertion loss ae. The nominal frequency fN is fixed at 215 MHz without any tolerance. The given values for both the relative attenuation arel and the group delay ripple have to be achieved at the frequencies given below even if the centre frequency fc is shifted due to the temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the centre frequency fc. Data typ. value Insertion loss (reference level) ae 3,4 Nominal frequency fN - Centre frequency fC PB Passband dB 300 Relative attenuation ± ± ± ± ± 400 600 800 1,6 3,0 max. 5 215,0 MHz dB MHz fN ± 75,0 kHz dB max. 2 dB kHz min. 150 kHz dB dB dB dB dB dB max. min. min. min. min. min. 3 25 35 40 45 53 dB dB dB dB dB dB BW Bandwidth fN fN fN fN fN fN dB 0,4 Pass band ripple 2 215,015 tolerance / limit … kHz … kHz … kHz … MHz … MHz … fN fN fN fN fN fN ± ± ± ± ± ± 100 600 800 1,6 3,0 30,0 arel kHz kHz kHz MHz MHz MHz Group delay ripple within PB Operating temperature range OTR 0,9 max. - - 30 °C ... + 85°C - Storage temperature range 25 Frequency inversion temperature Temperature coefficient of frequency 0,7 33 53 53 47 55 TCf ** -0,04 1,2 µs - 40 °C ... + 85°C °C ppm/K 2 - *) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team. 2 2 **) f(Hz) = TCf(ppm/K ) x (T-T0) x fTo(MHz) Generated: Checked / Approved: Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 215c.doc Version 1.1 VI TELEFILTER 4.3.2008 Filter specification TFS 215C 2/5 0 10.6 -1 9.55 -2 8.5 -3 7.45 -4 6.4 -5 5.35 -6 4.3 -7 3.25 -8 2.2 -9 1.15 0 -10 magnitude in dB -20 delay in µs magnitude in dB Filter characteristic -30 -40 -50 -10 214.8 214.84 214.88 214.92 214.96 215 215.04 frequency in MHz 215.08 215.12 215.16 -60 0.1 215.2 185 191 197 203 209 215 221 frequency in MHz 227 233 239 245 Construction and pin connection (All dimensions in mm) S 215C W09 Date code 50 1 2 3 4 5 6 7 8 9 10 11 12 Output Output Ground External Coil Ground Ground Input Input RF Return Ground Ground Ground Ground Date code: W X Y ... Year + week 2008 2009 2010 test circuit 7 L1 C1 8 1 L2 SAW 2 L4 4 3, 5, 6, 9, 10, 11, 12 C2 L3 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 215c.doc Version 1.1 VI TELEFILTER 4.3.2008 Filter specification TFS 215C 3/5 Stability characteristics, reliability After the following tests the filter shall meet the whole specification: 1. Shock: 500g, 1 ms, half sine wave, 3 shocks each plane; DIN IEC 68 T2 - 27 2. Vibration: 10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans; DIN IEC 68 T2 - 6 3. Change of temperature: 4. Resistance to solder heat (reflow): -55 °C to 125°C / 30 min. each / 10 cycles DIN IEC 68 part 2 – 14 Test N reflow possible: three times max.; for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4; This filter is RoHS compliant (2002/95/EG, 2005/618/EG) Packing Tape & Reel: IEC 286 – 3, with exception of value for N and minimum bending radius; tape type II, embossed carrier tape with top cover tape on the upper side; max. pieces of filters per reel: reel of empty components at start: reel of empty components at start including leader: trailer: !" Tape (all dimensions in mm) W : 16,00 ± 0,3 Po : 4,00 ± 0,1 Do : 1,50 +0,1/-0 E : 1,75 ± 0,1 F : 7,50 ± 0,1 G(min) : 0,60 P2 : 2,00 ± 0,1 P1 : 8,00 ± 0,1 D1(min) : 1,50 Ao : 5,50 ± 0,1 Bo : 7,50 ± 0,1 Ct : 13,5 ± 0,1 ! + '() 3000 min. 300 mm min. 500 mm min. 300 mm # *! $% &! W 2 Reel (all dimensions in mm) A : 330 W1 : 16,4 +2/-0 W2(max) : 22,4 N(min) : 50 C : 13,0 +0,5/-0,2 A C N W 1 The minimum bending radius is 45 mm. Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 215c.doc Version 1.1 VI TELEFILTER 4.3.2008 Filter specification TFS 215C 4/5 Air reflow temperature conditions Conditions Average ramp-up rate (30°C to 217°C) > 100°C > 150°C > 217°C Peak temperature Time within 5°C of actual peak temperature Cool-down rate (Peak to 50°C) Time from 30°C to Peak temperature Exposure less than 3°C/second between 300 and 600 seconds between 240 and 500 seconds between 30 and 150 seconds max. 260°C between 10 and 30 seconds less than 6°C/second no greater than 300 seconds Chip-mount air reflow profile Temperature / °C max. 260°C 217°C max. 300 s 10 ... 30 s Time / s 30 ... 150 s Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 215c.doc VI TELEFILTER Version 1.1 Filter specification 4.3.2008 TFS 215C 5/5 History Version Reason of Changes Name Date 1.0 - Generation of development specification Strehl 21.06.2007 1.1 - Martens 4.3.2008 Generation of filter specification Added terminating impedances Added typical values Added filter characteristic Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.