Filename: tfs 86a.doc Version 1.4 VI TELEFILTER 22.03.2007 Filter specification Measurement condition Ambient temperature: Input power level: Terminating impedance: * Input: Output: 23 0 °C dBm 850 850 || -2 pF || -2 pF TFS 86A 1/5 Characteristics Remark: The reference level for the relative attenuation arel of TFS 86A is the minimum of the pass band attenuation amin. This minimum is defined as the insertion loss ae. The nominal frequency fN is fixed at 86,85 MHz without any tolerance. The given values for the relative attenuation arel and the group delay ripple have to be reached at the frequencies given below, even if the centre frequency fc is shifted due to the temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the centre frequency fc. Data typ. value Insertion loss (Reference level) ae = amin 2,7 Nominal frequency fN - Pass band PB tolerance / limit dB 86,85 fN ± 13 - Pass band ripple max. 4 1,0 dB 1,5 dB MHz kHz max. 1,5 Relative attenuation arel fN ... fN ± 15 fN ± 60 kHz ... fN ± 120 kHz dB max. 3 dB kHz 26 dB min. 20 dB fN + 120 kHz ... fN + 150 kHz 58 dB min. 40 dB fN + 150 kHz ... fN + 400 ... fN + 1000 kHz 59 dB min. 30 dB kHz 60 dB min. 40 dB fN - 1000 kHz ... fN - 940 fN - 940 kHz ... fN - 880 kHz 71 dB min. 50 dB kHz 71 dB min. 70 dB fN - 880 kHz ... fN - 400 fN - 400 kHz ... fN - 120 kHz 63 dB min. 50 dB kHz 55 dB min. 40 dB Group delay ripple in fN ± 11 kHz 5 µs max. 10 µs fN + 400 kHz Intermodulation Intermodulation in the composite signal by fN ± 60 kHz and fN ± 120 kHz each of -20 dBm - max. -90 dBm Operating temperature range - 20 °C ... + 70 °C Storage temperature range - 40 °C ... + 85 °C Temperature coefficient of frequency Frequency inversion temperature TC dB - 0,036 ppm/K² 25 °C No DC voltage permitted *) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values only. Should there be additional questions, do not hesitate to ask for an application note or contact our design team. Generated: Checked / Approved: Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 86a.doc Version 1.4 VI TELEFILTER 22.03.2007 Filter specification TFS 86A 2/5 Filter characteristic 0 0 -10 -1 -30 magnitude in dB magnitude in dB -20 -40 -50 -60 -70 -80 -2 -3 -4 -90 -100 86 86.18 86.36 86.54 86.72 86.9 87.08 87.26 87.44 87.62 87.8 frequency in MHz -5 86.83 86.84 86.85 86.86 86.87 frequency in MHz 86.88 86.89 Construction and pin connection (All dimensions in mm) TFS 86A V12 Date code 1 2 3 4 5 6 7 8 9 10 Ground Ground Ground Output Output RF Return Ground Ground Ground Input Input RF Return Date code: V W X ... Year + week 2007 2008 2009 Base material ceramic; plating Au 0,75µm over Ni 1,27µm … 8,89µm 50 Test circuit 9 L1 C1 4 L2 SAW C2 1, 2, 3, 5, 6, 7, 8, 10 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 86a.doc Version 1.4 VI TELEFILTER 22.03.2007 Filter specification TFS 86A 3/5 Stability characteristics, reliability After the following tests the filter shall meet the whole specification: 1. Shock: 500g, 1 ms, half sine wave, 3 shocks each plane; DIN IEC 68 T2 - 27 2. Vibration: 10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans; DIN IEC 68 T2 - 6 3. Change of temperature: 4. Resistance to solder heat (reflow): -55 °C to 125°C / 30 min. each / 10 cycles DIN IEC 68 part 2 – 14 Test N reflow possible: three times max.; for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4; This filter is RoHS compliant (2002/95/EG, 2005/618/EG) Packing Tape & Reel: IEC 286 – 3, with exception of value for N and minimum bending radius; tape type II, embossed carrier tape with top cover tape on the upper side; max. pieces of filters per reel: reel of empty components at start: reel of empty components at start including leader: trailer: 3000 min. 300 mm min. 500 mm min. 300 mm Pull Off Direction Tape (all dimensions in mm) W : 24,00 ± 0,3 Po : 4,00 ± 0,1 Do : 1,50 +0,1/-0 E : 1,75 ± 0,1 F : 11,50 ± 0,1 G(min) : 0,60 P2 : 2,00 ± 0,1 P1 : 8,00 ± 0,1 D1(min) : 1,50 Ao : 5,60 ± 0,1 Bo : 11,80 ± 0,1 Ct : 21,5 ± 0,1 P1 Date Code Po Do P2 W G Ct Bo F G E t Ko Typ PIN Marker D1 Ao W 2 Reel (all dimensions in mm) A : 330 W1 : 24,4 +2/-0 W2(max) : 30,4 N(min) : 60 C : 13,0 +0,5/-0,2 A C N W 1 The minimum bending radius is 45 mm. Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 86a.doc Version 1.4 VI TELEFILTER 22.03.2007 Filter specification TFS 86A 4/5 Air reflow temperature conditions Conditions Average ramp-up rate (30°C to 217°C) > 100°C > 150°C > 217°C Peak temperature Time within 5°C of actual peak temperature Cool-down rate (Peak to 50°C) Time from 30°C to Peak temperature Exposure less than 3°C/second between 300 and 600 seconds between 240 and 500 seconds between 30 and 150 seconds max. 260°C between 10 and 30 seconds less than 6°C/second no greater than 300 seconds Chip-mount air reflow profile Temperature / °C max. 260°C 217°C max. 300 s 10 ... 30 s Time / s 30 ... 150 s Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 86a.doc VI TELEFILTER Version 1.4 Filter specification 22.03.2007 TFS 86A 5/5 History Version Reason of Changes Name Date 1.2 changing DC voltage changing label Pfeiffer 13.02.2002 1.3 changing of construction M.Springfeldt 13.05.2004 1.4 reworked construction reworked matching circuit reworked air reflow temperature conditions added plating information added filter characteristic added typical values added RoHS information Martens 22.03.2007 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.