Measurement condition

Filename: tfs 130b.doc
Version 1.2
VI TELEFILTER
17.01.2008
Filter specification
TFS 130B
1/5
Measurement condition
Ambient temperature:
Input power level:
Terminating impedance: *
Input:
Output:
23
0
°C
dBm
470 Ω || -12,9 pF
470 Ω || -12,9 pF
Characteristics
Remark:
The reference level for the relative attenuation arel of the TFS 130B is the minimum of the pass band attenuation amin. The minimum of the pass band
attenuation amin is defined as the insertion loss ae. The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 3 dB
filter attenuation level relative to the insertion loss ae. The nominal frequency fN is fixed at 130,38 MHz without any tolerance. The given values for both the
relative attenuation arel and the group delay ripple have to be achieved at the frequencies given below even if the centre frequency fc is shifted due to the
temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the centre frequency fc.
Data
typ. value
Insertion loss
(reference level)
ae
Nominal frequency
fN
Centre frequency at ambient temperature
Passband
PB
2,0
3,1
5,5
6,4
MHz
MHz
MHz
MHz
MHz
max.
8,0
MHz
dB
MHz
fN
±
0,665 MHz
BW
Relative attenuation
20,0
fN 5,75
fN +
9,87
fN +
10,87
fN +
20,0
fN ±
Group delay
130,38
-
dB
dB
dB
dB
fN
dB
130,38
fC
Bandwidth at ambient temperature
1
3
20
40
6,6
tolerance / limit
MHz
MHz
MHz
MHz
arel
… fN
±
…
…
…
…
…
+
+
+
±
fN
fN
fN
fN
fN
0,665 MHz
5,75 MHz
9,87 MHz
10,87 MHz
20,0
MHz
100,0
MHz
mean value in PB
Group delay ripple within PB
p-p
45
45
41
46
55
0,77
dB
dB
dB
dB
dB
µs
50,0
ns
Deviation from linear phase within PB (p-p)
3°
Deviation from linear phase within PB (r.m.s.)
0,7°
max.
1
dB
min.
min.
min.
min.
40
40
38
40
dB
dB
dB
dB
0,77 ± 0,03 µs
max.
2,5°
Triple transit attenuation compared to main signal
50
dB
-
Crosstalk
50
dB
-
VSWR
Operating temperature range
1,5 : 1
OTR
Storage temperature range
Temperature coefficient of frequency
TCf **
max.
2:1
-
- 45 °C ... + 85°C
-
- 40 °C ... + 85°C
- 19
ppm/K
*) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values
only. Should there be additional questions do not hesitate to ask for an application note or contact our design team.
**) ∆fc(Hz) = Tcf(ppm/K) x (T - TA) x fCat (MHz)
Generated:
Checked / Approved:
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 130b.doc
Version 1.2
VI TELEFILTER
17.01.2008
Filter specification
TFS 130B
2/5
0
1.155
-1
1.11
-20
-2
1.065
-30
-3
1.02
-4
0.975
-5
0.93
-6
0.885
-70
-7
0.84
-80
-8
0.795
-90
-9
0.75
-40
-50
-60
-100
123.4 124.8 126.2 127.6
129 130.4 131.8 133.2 134.6
frequency in MHz
136
delay in µs
0
-10
magnitude in dB
magnitude in dB
Filter characteristic
0.705
-10
128.4 128.8 129.2 129.6 130 130.4 130.8 131.2 131.6 132 132.4
frequency in MHz
137.4
Construction and pin connection
(All dimensions in mm)
S 130B
●
U02
3
Date code
2 Max.
1
Ground
Ground
Output RF Return
Output
Ground
Ground
Ground
Ground
Input RF Return
Input
Ground
Ground
Date code:
W
X
A
...
Year + week
2008
2009
2010
1
5,2 Max.
2,54 ±0,2
7,2 Max.
2,54 ±0,2
1
1
2
3
4
5
6
7
8
9
10
11
12
0,80
50 Ω Test circuit
L1
10
9
4
SAW
L2
3
C2
C1
1, 2, 5, 6, 7, 8, 11, 12
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 130b.doc
Version 1.2
VI TELEFILTER
17.01.2008
Filter specification
TFS 130B
3/5
Stability characteristics, reliability
After the following tests the filter shall meet the whole specification:
1. Shock:
500g, 1 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
2. Vibration:
10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans;
DIN IEC 68 T2 - 6
3. Change of
temperature:
4. Resistance to
solder heat (reflow):
-55 °C to 125°C / 30 min. each / 10 cycles
DIN IEC 68 part 2 – 14 Test N
reflow possible: twice max.;
for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4;
This filter is RoHS compliant (2002/95/EG, 2005/618/EG)
Packing
Tape & Reel:
IEC 286 – 3, with exeption of value for N and minimum bending radius;
tape type II, embossed carrier tape with top cover tape on the upper side;
max. pieces of filters peer reel:
reel of empty components at start:
reel of empty components at start including leader:
trailer:
3000
min. 300 mm
min. 500 mm
min. 300 mm
Pull Off Direction
Tape (all dimensions in mm)
W
: 16,00 ± 0,3
Po
: 4,00 ± 0,1
Do
: 1,50 +0,1/-0
E
: 1,75 ± 0,1
F
: 7,50 ± 0,1
G(min)
: 0,60
P2
: 2,00 ± 0,1
P1
: 8,00 ± 0,1
D1(min)
: 1,50
Ao
: 5,50 ± 0,1
Bo
: 7,50 ± 0,1
Ct
: 13,5 ± 0,1
t
P1
Date Code
Po
P2
W
G
Ct
Bo
F
G
E
Do
Ko
Typ
PIN Marker
D1
Ao
W 2
Reel (all dimensions in mm)
A
: 330
W1
: 16,4 +2/-0
W2(max) : 22,4
N(min)
: 50
C
: 13,0 +0,5/-0,2
A
C
N
W 1
The minimum bending radius is 45 mm.
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 130b.doc
Version 1.2
VI TELEFILTER
17.01.2008
Filter specification
TFS 130B
4/5
Air reflow temperature conditions
Conditions
Average ramp-up rate (30°C to 217°C)
> 100°C
> 150°C
> 217°C
Peak temperature
Time within 5°C of actual peak temperature
Cool-down rate (Peak to 50°C)
Time from 30°C to Peak temperature
Exposure
less than 3°C/second
between 300 and 600 seconds
between 240 and 500 seconds
between 30 and 150 seconds
max. 260°C
between 10 and 30 seconds
less than 6°C/second
no greater than 300 seconds
Chip-mount air reflow profile
Temperature / °C
max. 260°C
217°C
max. 300 s
10 ... 30 s
Time / s
30 ... 150 s
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 130b.doc
VI TELEFILTER
Version 1.2
Filter specification
17.01.2008
TFS 130B
5/5
History
Version
Reason of Changes
Name
Date
1.0
- Generation of filter specification
Strehl
07.09.2005
1.1
- operating temperature range extended
- stability characteristics modified
Pfeiffer
10.01.2006
1.2
- pin connections: typing error corrected
Pfeiffer
17.01.2008
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.