ETC TFS456E

Filename: tfs 456e.doc
Version 1.7
VI TELEFILTER
08.12.2006
Filter specification
TFS 456E
1/5
Measurement condition
Ambient temperature:
Input power level:
Terminating impedance: *
Input:
Output:
23
0
°C
dBm
780 Ω || -4,0 pF
660 Ω || -4,0 pF
Characteristics
Remark:
Reference level for the relative attenuation arel of the TFS 456E is the minimum of the pass band attenuation amin. The minimum of the pass band
attenuation amin is defined as the insertion loss ae. The centre frequency fC is the arithmetic mean value of the upper and lower frequencies at the 1dB
filter attenuation level relative to the insertion loss ae. The nominal frequency fN is fixed on 456,0 MHz without tolerance. The given values for the relative
attenuation arel and for the group delay ripple have to be reached at the frequencies given below also if the centre frequency fC is shifted due to the
temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the centre frequency fC.
Data
typ. value
ae = amin
Insertion loss
(reference level)
9,0
Nominal frequency
fN
-
Centre frequency
fC
456,05
dB
tolerance / limit
max.
13,0
456,0
MHz
dB
MHz
-
Passband
-
Pass band ripple
0,3
dB
max.
1,0
dB
1dB bandwidth
3,6
MHz
min.
3,15
MHz
max.
3,75
MHz
Relative attenuation
fN 200
MHz
96
MHz
fN 47
MHz
fN 3,5
MHz
fN +
192
MHz
fN +
Group delay ripple
…
…
…
…
…
fN
fN
fN
fN
fN
+
+
96
47
3,5
192
200
arel
MHz
MHz
MHz
MHz
MHz
Return loss within PB
OTR
Storage temperature range
Frequency inversion temperature
Temperature coefficient of frequency
65
60
43
43
80
150
dB
dB
dB
dB
dB
ns
min.
min.
min.
min.
min.
max.
40
50
40
40
30
200
dB
dB
dB
dB
dB
ns
15
dB
min.
10
dB
max.
15
dBm
-
Input power level
Operating temperature range
fN ± 1,575 MHz
TCf **
-
- 40 °C ... + 85°C
-
- 45 °C ... + 85°C
30
°C
-0,04
ppm/K²
*) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference
values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team.
**) ∆f(Hz) = TCf(ppm/K²) x (T-T0)² x fcat(MHz).
Generated:
Checked / Approved:
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 456e.doc
Version 1.7
VI TELEFILTER
08.12.2006
Filter specification
TFS 456E
2/5
0
1.7
-1
1.55
-20
-2
1.4
-30
-3
1.25
-4
1.1
-5
0.95
-6
0.8
-70
-7
0.65
-80
-8
0.5
-90
-9
0.35
-40
-50
-60
-100
416
424
432
440
448
456
464
frequency in MHz
472
480
488
496
delay in µs
0
-10
magnitude in dB
magnitude in dB
Filter characteristic
0.2
-10
453 453.6 454.2 454.8 455.4 456 456.6 457.2 457.8 458.4 459
frequency in MHz
Construction and pin connection
(All dimensions in mm)
S 456E
● U49
Date code
1
2
3
4
5
6
7
8
9
10
Ground
Ground
Ground
Output
Output RF Return / Output
Ground
Ground
Ground
Input
Input RF Return / Input
Date code:
U
V
W
...
Year + week
2006
2007
2008
50 Ohm Test circuit
single ended:
9
L1
10
4
SAW
L3
5
L2
L4
1, 2, 3, 6, 7, 8
balanced:
9
C1
L2
4
L2
L1
10
SAW
C2
5
L4
1, 2, 3, 6, 7, 8
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 456e.doc
Version 1.7
VI TELEFILTER
08.12.2006
Filter specification
TFS 456E
3/5
Stability characteristics, reliability
After the following tests the filter shall meet the whole specification:
1. Shock:
500g, 1 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
2. Vibration:
10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans;
DIN IEC 68 T2 - 6
3. Change of
temperature:
4. Resistance to
solder heat (reflow):
-55 °C to 125°C / 30 min. each / 10 cycles
DIN IEC 68 part 2 – 14 Test N
reflow possible: twice max.;
for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4;
This filter is RoHS compliant (2002/95/EG, 2005/618/EG)
Packing
Tape & Reel:
IEC 286 – 3, with exeption of value for N and minimum bending radius;
tape type II, embossed carrier tape with top cover tape on the upper side;
max. pieces of filters peer reel:
reel of empty components at start:
reel of empty components at start including leader:
trailer:
3000
min. 300 mm
min. 500 mm
min. 300 mm
Pull Off Direction
Tape (all dimensions in mm)
W
: 16,00 ± 0,3
Po
: 4,00 ± 0,1
Do
: 1,50 +0,1/-0
E
: 1,75 ± 0,1
F
: 7,50 ± 0,1
G(min)
: 0,60
P2
: 2,00 ± 0,1
P1
: 8,00 ± 0,1
D1(min)
: 1,50
Ao
: 5,50 ± 0,1
Bo
: 7,50 ± 0,1
Ct
: 13,5 ± 0,1
t
P1
Date Code
Po
P2
W
G
Ct
Bo
F
G
E
Do
Ko
Typ
PIN Marker
D1
Ao
W 2
Reel (all dimensions in mm)
A
: 330
W1
: 16,4 +2/-0
W2(max) : 22,4
N(min)
: 50
C
: 13,0 +0,5/-0,2
C
A
N
W 1
The minimum bending radius is 45 mm.
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 456e.doc
Version 1.7
VI TELEFILTER
08.12.2006
Filter specification
TFS 456E
4/5
Air reflow temperature conditions
Conditions
Average ramp-up rate (30°C to 217°C)
> 100°C
> 150°C
> 217°C
Peak temperature
Time within 5°C of actual peak temperature
Cool-down rate (Peak to 50°C)
Time from 30°C to Peak temperature
Exposure
less than 3°C/second
between 300 and 600 seconds
between 240 and 500 seconds
between 30 and 150 seconds
max. 260°C
between 10 and 30 seconds
less than 6°C/second
no greater than 300 seconds
Chip-mount air reflow profile
Temperature / °C
max. 260°C
217°C
max. 300 s
10 ... 30 s
Time / s
30 ... 150 s
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 456e.doc
VI TELEFILTER
Version 1.7
Filter specification
08.12.2006
TFS 456E
5/5
History
Version
Reason of Changes
Name
Date
1.0
- Generation of development specification
Noack
17.06.2004
1.1
- Change the passband to +/-1.575MHz from +/-1.65MHz
Noack
30.06.2004
1.2
- Added 1dB bandwidth
Noack
05.07.2004
1.3
- Change Construction and pin connection
Springfeldt
15.07.2004
1.4
- terminating impedance, typical values, filter characteristid added
- matching configuration, pinning, air reflow temperature conditions changed
Pfeiffer
12.10.2004
1.5
- stability characteristics modified
- air reflow temperature conditions corrected
Pfeiffer
16.11.2005
1.6
- matching configuration for single ended applications added
- terminatin impedance corrected
- typical values changed
Pfeiffer
30.11.2005
1.7
- add input power level
Strehl
08.12.2006
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.