600W Switching Power Supply N SCN600 6 0 0 W W i t h P a r a l lel Function series FEATURES AC input range selectable by switch High reliability and low ripple noise Built-in remote sense function Built-in remote ON/OFF control Programmable output voltage Forced current sharing at parallel operation Output short circuit / over voltage / overload / over temperature protections UL1950, CSA22.2 approved MODEL No . DC VOLTAGE SCN600-05 SCN600-12 SCN600-15 SCN600-24 SCN600-48 5V 12V 15V 24V 48V 50A 40A 25A 12A 600W 600W 600W 576W 150mVp-p 150mVp-p 240mVp-p 480mVp-p RATED CURRENT 100A RATED POWER OUTPUT 500W RIPPLE & NOISE (max.) 150mVp-p VOLTAGE ADJ. RANGE 5.0% typical adjustment by potentiometer; 20% ~ 100% adjustment by 1 ~ 5VDC external control LINE & LOAD REGULATION Less than 1% SETUP, RISE, HOLD TIME VOLTAGE RANGE FREQUENCY RANGE INPUT 800ms, 50ms, 16ms at full load 90 ~ 130VAC / 180 ~ 260VAC, selected by switch 47 ~ 63Hz EFFICIENCY (Typ.) 77% INRUSH CURRENT (Typ.) 80% 81% 85% 87% 60A / 230VAC LEAKAGE CURRENT (max.) < 3.5mA / 240VAC OVER LOAD 105 ~ 115% rated output power (Current limiting, delay shut down output voltage, re-power on to recover) PROTECTION OVER VOLTAGE 110 ~ 135% follow to output set up point (Shut down output voltage, re-power on to recover) OVER TEMPERATURE > 100 C / measure by heat sink, near transformer (Shut down output voltage, re-power on to recover) WORKING TEMP. & HUMIDITY -10 ~ +50 C ; 20% ~ 90% RH non-condensing ENVIRONMENT STORAGE TEMP. & HUMIDITY TEMP. COEFFICIENT -20 ~ +85 C , 10 ~ 95% RH 0.04% / C (0 ~ 50 C ) SAFETY STANDARDS UL1950, IEC60950 Approved WITHSTAND VOLTAGE I/P ~ O/P, I/P ~ FG:1.5KVAC SAFETY & EMC ISOLATION RESISTANCE I/P~O/P, I/P~FG, O/P~FG:100M Ohms / 500VDC EMI CONDUCTION & RADIATION Compliance to FCC part 15 class A HARMONIC CURRENT ----- EMS IMMUNITY ----SPECIAL FUNCTION OTHERS DC voltage Adj., Remote sensing, Remote control, Parallel operation MTBF 120K hrs min. MIL-HDBK-217F(25 C) DIMENSION 290 x 130 x 68mm (L x W x H ) PACKING 2.3kgs; 8sets / 22kgs / CARTON ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 WWW.ASTRODYNE.COM 19 *Note:The specifications are subject to change without notice. S C NS- 6C0N06s0e r0i e s s e r i e s With Parallel Function 6 0 0 W W i t h P a r a600W l lel Function Mechanical Specification Unit:mm 291.0 200.0 50.5 #6-32-4 M3(NUT)x3H-4 AC INPUT VS+ VSVCI VCO GND PAR GND INH N FG 68. 0 L 41.0 15.5 199.5 30.0 V ADJ 15.0 LED POS+ NEG- 291.0 32.0 9.5 M3(NUT)x3H-4 M6.0 7.5 NEG AC INPUT BOTTOM SIDE POS DC OUTPUT Air flow direction 132.0 9.0 115.0 250.0 Derating Curve External DC Control VS Output Voltage Vout 100 OUTPUT VOLTAGE (%) LOAD (%) 100 50 -10 O.V.P. 0 10 20 30 Ta ( WWW.ASTRODYNE.COM 40 ) 50 60 80 60 40 20 V 1 2 3 4 5 EXTERNAL VOLTAGE(Typical) ASTRODYNE USA: 1-800-823-8082 File Name:SCN-600-SPEC 2004-09-23 ASTRODYNE PACIFIC: 886-2-26983458 S C N -S6 C 0 0N s6e r0i e0s 6 0 0 W W i t h P a r600W a l lel With Function Parallel Function series Control terminal instruction manual LOAD LOAD LOAD VS+ VSVCI VCO GND PAR GND INH VS+ VSVCI VCO GND PAR GND INH VS+ VSVCI VCO GND PAR GND INH USING INTERNAL VOLTAGE CONTROL ON/OFF SWITCH ON/OFF CONTROL BY SWITCH REMOTE SENSING LOAD LOAD VS+ VSVCI VCO GND PAR GND INH VS+ VSVCI VCO GND PAR GND INH H:ON L:OFF DC 1-5V OUTPUT VOLTAGE ADJUST WITH DC 1-5V ON/OFF CONTROL BY TRANSISTOR LOAD VS+ VSVCI VCO GND PAR GND INH VS+ VSVCI VCO GND PAR GND INH VS+ VSVCI VCO GND PAR GND INH PARALLEL OPERATION WITH REMOTE SENSING WWW.ASTRODYNE.COM LOAD VS+ VSVCI VCO GND PAR GND INH VS+ VSVCI VCO GND PAR GND INH VS+ VSVCI VCO GND PAR GND INH PARALLEL OPERATION ASTRODYNE USA: 2004-09-23 1-800-823-8082 File Name:SCN-600-SPEC ASTRODYNE PACIFIC: 886-2-26983458