Stanchion Pole Mount: Stanchion Pole Mount: Volume 16 in3 Volume 16 in3 Class I, Division 2, Groups A, B, C, and D Class II, Division 2, Groups F and G Class II, Division I, Groups E, F, and G Ambient Temperature -40C to 65C, T4 Class I, Division 2, Groups A, B, C, and D Class II, Division 2, Groups F and G Class II, Division I, Groups E, F, and G Ambient Temperature -40C to 65C, T4 General Instructions: General Instructions: 1. 2. 3. 4. 5. Turn off Power. Use only copper wire. Use Teflon tape on all threaded fittings and thread locker on locking screws to ensure 3R rating. Installation and wiring must comply with local electrical codes. Attach system ground wire under head of green screw in box. Installation Instructions: 1. 2. 3. 4. 5. 6. 7. 1. 2. 3. 4. 5. Turn off Power. Use only copper wire. Use Teflon tape on all threaded fittings and thread locker on locking screws to ensure 3R rating. Installation and wiring must comply with local electrical codes. Attach system ground wire under head of green screw in box. Installation Instructions: Install ¾” to ½” NPT reducer onto ½” NPT cable gland. Install reducer, cable gland assembly into ¾” NPT threaded entrance of area light housing. Install ½” NPT cable gland to back of stanchion pole mount. Ensure o-ring is present. Torque cable gland body to 33 in-lbs, and dome nut to 22 in-lbs. ensure o-ring is present. Pull wires into box. Mount to pole using Teflon tape on all threads as necessary, use ¼”-20 screws provided.Torque to 5-6 ft-lbs to ensure fixture is secure. Use of Loctite on hardware is recommended. Install cover using ¼”-20 screws provided. Torque screws to 30 in-lbs. Ensure O-ring is present and not spilling out of intended groove. Install¼”-20 screws provided to mount bracket to stanchion pole mount. Torque to 3-4 ft-lbs. 1. 2. 3. 4. 5. 6. 7. Install ¾” to ½” NPT reducer onto ½” NPT cable gland. Install reducer, cable gland assembly into ¾” NPT threaded entrance of area light housing. Install ½” NPT cable gland to back of stanchion pole mount. Ensure o-ring is present. Torque cable gland to 33 in-lbs, and dome nut to 22 in-lbs. ensure o-ring is present. Pull wires into box. Mount to pole using Teflon tape on all threads as necessary, use ¼”-20 screws provided.Torque to 5-6 ft-lbs to ensure fixture is secure. Use of Loctite on hardware is recommended. Install cover using ¼”-20 screws provided. Torque screws to 30 in-lbs. Ensure O-ring is present and not spilling out of intended groove. Install¼”-20 screws provided to mount bracket to stanchion pole mount. Torque to 3-4 ft-lbs. NEMA 3R Listed UL 50, UL 50E, UL 844 CSA C22.2 No. 94.2 CSA C22.2 No. 137 Junction Box Suitable For Wet Locations Rev-C-28142 NEMA 3R Listed UL 50, UL 50E, UL 844 CSA C22.2 No. 94.2 CSA C22.2 No. 137 Junction Box Suitable For Wet Locations Rev-C-28142