Before you begin installing your card, please make sure that the following materials have been shipped: Industrial VGA card specifications • GPU: XGI Volari™ Z9s • Bus: PCI 2.2 • Memory: 16bit, 350MHz 32MB DDRII SDRAM • 1 PCA-5612 Industrial VGA card • CRT1 output: 1600 x 1200, up to 60Hz vertical rate • DVI: Single Link TMDS up to UXGA (1600x1200@60Hz) • 1 PCA-5612 Startup Manual • Dual Display Mode: CRT + DVI in windows XP/2K/ Linux, supporting mirror only, NOT supporting extension mode. • 1 CD with driver utility • Warranty certificate If any of these items are missing or damaged, contact your distributor or sales representative immediately. Note: Acrobat Reader is required to view any PDF file. Acrobat Reader can be downloaded at: www.adobe.com/products/acrobat/readstep2.html • OS’s Supported: Microsoft® Windows XP/2K/Linux/ Unix/FreeBSD. 1. Connectors The VGA card has a number of connectors that allow you to configure your system to suit your application. Label Function Software Installation The CD disc contains a driver installer program that will lead you through the installation of your VGA card. Caution CON2 Reserve for SDVO module (SDVO module NOT available yet) CRT1 VGA port VCN4 DVI port CRT1 : VGA connector The computer is provided with a battery-powered Real-time Clock circuit. There is a danger of explosion if battery is incorrectly replaced. The battery doesn’t need to be charged. Replace only with same or equivalent type recommended by the manufacturer. Discard used batteries according to manufacturer's instructions. FCC This device complies with the requirements in part 15 of the FCC rule. Operation is subject to the following two conditions: 5 1 10 6 15 Pin 1 2 3 4 5 6 7 8 11 Signal RED GREEN BLUE N/C GND GND GND GND Pin 9 10 11 12 13 14 15 Signal VCC GND N/C SDT H-SYNC V-SYNC SCK Pin 2 4 6 8 10 12 14 16 18 20 22 24 C2 C4 C6 Signal TMDS2+ N/C DDC2_SCLOUT N/C TMDS1+ N/C 5V HP0_DETECT TMDS0+ N/C TMDSSD TMDSCLKN/C N/C N/C 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. For more information on this and other Advantech products, please visit our website at: http://www.advantech.com http://www.advantech.com/network For technical support and service, please visit our support website at: http://www.advantech.com.tw/support This manual is for the PCA-5612 series Rev. A1. Part No. 2002561210 Printed in Taiwan 1st Edition May 2006 DVI1: DVI port Pin 1 3 5 7 9 11 13 15 17 19 21 23 C1 C3 C5 Signal TMDS2TMDSSD N/C DDC2_SDAOUT TMDS1TMDSSD N/C GND TMDS0TMDSSD N/C TMDSCLK+ N/C N/C N/C PCA-5612 Startup Manual 1 PCA-5612 Industrial VGA Card with XGI Volari™ Z9s PCA-5612 Industrial VGA Card with XGI Volari™ Z9s 2. Board Layout Board Layout: Jumper and Connector Locations 2 PCA-5612 Startup Manual