Packing List Specifications Before you begin installing your card, please make sure that the following materials have been shipped: Standard SBC Functions • CPU: Intel LGA 775 Pentium 4® up to 3.8 GHz, Celeron® D up to 3.06 GHz, FSB 533/800 MHz • AIMB-760 Pentium® 4 / Celeron® D processor based industrial motherboard • BIOS: Award 4 Mb flash memory BIOS • 1 AIMB-760 startup manual • System Memory: Up to 4 GB; four 240-pin DIMM sockets. Supports dual channel DDRII 400/533 SDRAM. • 1 CD with driver utility and manual • Chipset: Intel 915GV with ICH6 Note: Due to the inherent limitations of PC architecture, the system may not fully detect 4 GB RAM when 4 GB RAM is installed. • 1 FDD cable p/n:1700340640 • 2 Ultra ATA 66/100 HDD cables p/n: 1701400452 • 2 Serial ATA HDD data cable p/n: 1700071000 • 2 Serial ATA HDD power cable p/n: 1703150102 • 1 ATX 12 V power converter cable p/n:170304015K • 1 COM port cable kit p/n: 1701090401 • FDD interface: Supports one FDD • 1 I/O port bracket p/n: 1960004027 • Serial ports: Two serial RS-232 ports • 1 Jumper package p/n: 9689000068 • Parallel port: One parallel port, supports SPP/EPP/ ECP mode • 1 Warranty card p/n: 2190000902 If any of these items are missing or damaged, contact your distributor or sales representative immediately. Note: Acrobat Reader is required to view any PDF file. Acrobat Reader can be downloaded at: www.adobe.com/Prodindex/acrobat/readstep.html (Acrobat is a trademark of Adobe). • SATA/IDE Interface: Four on-board serial ATA connectors with a data transmission rate of up to 150 MB/s supporting Advanced Host Controller Interface (AHCI) technology. One IDE hard disk drive or two enhanced IDE devices. Supports PIO mode 4 (16.67 MB/s data transfer rate) and ATA 33/66/100 (33/66/100 MB/s data transfer rate) BIOS enabled/disabled. • Keyboard/mouse connector: Supports one standard PS/2 keyboard and mouse • Watchdog timer: 255 level timer intervals • USB 2.0: Supports up to eight USB 2.0 ports VGA Interface • Chipset: Chipset integrated VGA controller • Display memory: Dynamically shared system memory up to 128 MB • Resolution: Up to 2048 x 1536 @ 85 MHz refresh rate Ethernet Interface • Single 10/100/1000Base-T: Broadcom BCM5721 x 1 • Dual 10/100/1000Base-T: Broadcom BCM5721 x 2 For more information on this and other Advantech products, please visit our website at: Mechanical and Environmental http://www.advantech.com http://www.advantech.com/eplatform For technical support and service, please visit our support website at: http://www.advantech.com/support • Dimensions (L x W): 304.8 x 243.8 mm • Power supply voltage: +5 V, ± 12 V • Power requirements: Maximum: +5 V @ 6.64 A, +12 V @ 12.59 A (3.4 GHz Intel Pentium 4 with 800 MHz FSB, 2 x 256 MB, 2 x 512 MB DDRII 533 SDRAM) This manual is for the AIMB-760 series Rev. A1 • Operating temperature: 0 ~ 60° C (depending on CPU’s speed and cooler solution) Part No. 2002076011 Printed in Taiwan • Weight: 0.5 kg (weight of board) 2nd Edition January 2006 AIMB-760 Startup Manual 1 AIMB-760 Socket LGA 775 Intel® Pentium® 4 / Celeron® D 800 MHz FSB Industrial ATX Motherboard with PCI-E, DDR2 and Dual GbECA-6184-B1 Socke AIMB-760 Socket LGA 775 Intel® Pentium® 4 / Celeron® D 800 MHz FSB Industrial ATX Motherboard with PCI-E, DDR2 and Dual GbE Jumpers and Connectors The board has a number of jumpers that allow you to configure your system to suit your application. The table below lists the function of each of the jumpers and connectors. J1: CMOS clear function Pins Result 1-2 Keep CMOS data* 2-3 Clear CMOS data J1: CMOS clear function Closed Pins Result 1-2 Keep CMOS data* 2-3 Clear CMOS data J12: ATX, AT mode selector Label Function CN1 Primary IDE connector CN3 FDD connector, Supports 360 KB / 1.2 MB / 720 KB / 1.44 MB FDD x 2 CN4 Parallel port, Parallel port x 1, supports SPP/ EPP/ECP mode CN6 USB port 4, 5 CN7 VGA connector CN9 Serial port: COM1; RS-232 (D-sub 9-pin connector) CN10 Serial port: COM2; RS-232 (9-pin connector) CN11 PS/2 keyboard and mouse connector Cable length: 20 meters CN12 External keyboard connector (6-pin) CN13 Infrared connector CN14 CPU FAN connector CN15 System FAN connector 1 CN16 Power LED CN17 External speaker CN18 Reset connector CN19 HDD LED connector CN21 ATX soft power switch (PS_ON) CN22 HW Monitor Alarm Close: Enable OBS Alarm Open: Disable OBS Alarm CN29 SM bus connector CN31 LAN1; USB ports 0, 1 CN32 LAN2; USB ports 2, 3 CN37 System FAN connector 2 CN55 Line Out, Mic IN connector CN56 CD IN (Audio input from CD-ROM) CN57 AUX IN connector CN59 Front panel audio connector CN62 8-pin Alarm Board Connector CN63 USB ports 6, 7 CN64 Case Open CN65 Front Panel LAN indicator connector SA0 Serial ATA0 SA1 Serial ATA1 SA2 Serial ATA2 SA3 Serial ATA3 ATX1 ATX 12 V auxiliary power connector (for CPU) ATX3 24-pin ATX power connector 2 AIMB-760 Startup Manual *default setting J2: Watchdog timer output option Closed pins Result 1-2 IRQ11 2-3 System reset * Software Installation The CD disc contains a driver installer program that will lead you through the installation of various device drivers needed to take full advantage of your motherboard. Caution The computer is supplied with a battery-powered Real-time Clock circuit. There is a danger of explosion if battery is incorrectly replaced. Replace only with same or equivalent type recommended by the manufacturer. Discard used batteries according to manufacturer's instructions. Safety Information This device complies with the requirements in Part 15 of the FCC rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference 2. This device must accept any interference received, including interference that may cause undesired operation Board Layout: Jumper and Connector Locations AIMB-760 Startup Manual 3