Primary

Packing List
Specifications
Before you begin installing your card, please make
sure that the following materials have been shipped:
Standard SBC Functions
• CPU: Intel LGA 775 Celeron D up to 3.06 GHz, Pentium
4 up to 3.8 GHz, FSB 533/800 MHz.
• 1 PCA-6190 Pentium® 4/Celeron® D processorbased single board computer
• BIOS: Award 4 Mb Flash memory BIOS
• 1 PCA-6190 Startup Manual
• System Memory: Up to 4 GB; four 240-pin DIMM sockets. Supports dual channel DDRII 400/533 SDRAM.
Note: Due to the inherent limitations of PC architecture,
the system canNOT fully detect 4 GB RAM capacity
when 4 GB RAM is installed.
• 1 CD with driver utility and manual (in PDF format)
• Chipset: Intel 915GV with ICH6
• 1 FDD cable
p/n: 1700340640
• 1 Ultra ATA 66/100 HDD cables
p/n: 1701400452
• 4 Serial ATA HDD data cables
p/n: 1700071000
• 4 Serial ATA HDD power cables
p/n: 1703150102
• 1 ATX 12V power converter
cable
p/n: 170304015K
• 1 Printer (parallel) port & COM
port cable kit
p/n: 1701260305
• 1 Dual COM port cable kit (G200A1 and G2-D0A1 only)
p/n: 1701092300
• Parallel port: One parallel port, supports SPP/EPP/
ECP mode
• 1 Y cable for PS/2 keyboard and
PS/2 mouse
p/n: 1700060202
• Keyboard/mouse connector: Supports one standard
PS/2 keyboard and mouse
• 2 USB cable with 4 ports
p/n:1700000719
• 1 DVI cable
(PCA-6190G2-D0A1 only)
p/n: 1700000821
• SATA/IDE Interface: Four on-board serial ATA connectors with data transmission rate up to 150 MB/Sec and
supporting Advanced Host controller interface (AHCI)
technology. One IDE hard disk drives or two enhanced
IDE devices. Supports PIO mode 4 (16.67MB/s data
transfer rate) and ATA 33/66/100 (33/66/100MB/s data
transfer rate.) BIOS enabled/disabled.
• FDD interface: Supports one FDD
• Serial ports: Two serial RS-232 ports
• Watchdog timer: 255 level timer intervals
• USB (2.0): Supports up to eight USB 2.0 ports with the
two USB 2.0 cable kits included
VGA/LCD Interface
• Warranty Card
• Chipset: Chipset integrated VGA controller
If any of these items are missing or damaged, contact
your distributor or sales representative immediately.
• Display memory: Dynamically shared system memory
up to 128 MB.
• Resolution: Up to 2048x1536@ 85 MHz refresh
Note:
Acrobat Reader is required to view any PDF
file. Acrobat Reader can be downloaded at:
www.adobe.com/Prodindex/acrobat/readstep.html (Acrobat is a trademark of Adobe).
For more information on this and other Advantech
products, please visit our website at:
http://www.advantech.com
Ethernet Interface
• Controller: Broadcom BCM5721
• Single 10/100/1000Base-T:Broadcom BCM5721
• Dual 10/100/1000Base-T: Broadcom BCM5721 X 2
Note: PCA-6190VG-00A1 uses on-board LAN2 controller
Mechanical and Environmental
• Dimensions (L x W): 338 x 122 mm
http://www.advantech.com/eplatform
• Power supply voltage: +5 V ± 12 V
For technical support and service, please visit our
support website at:
• Power requirements: Maximum: +5V:6.64A,
+12V:12.59A (Intel Pentium4 3.4GHz with 800MHz
FSB, 2 X256 MB, 2 X 512 MB DDRII 533 SDRAM)
http://www.advantech.com/support
This manual is for the PCA-6190 series Rev. A1
Part No. 2002619010
Printed in Taiwan
1st Edition
September 2005
• Operating temperature: 0 ~ 60° C (depending on
CPU)
• Weight: 0.5 kg (weight of board)
PCA-6190 Startup Manual
1
PCA-6190 Full-sized PCI/ISA-bus LGA775 Pentium® 4/Celeron® D Processor
Card with VGA/Dual Gigabit LAN/HISA/DVI (800 MHz FSB)CA-6184-B1 Socket
PCA-6190 Full-sized PCA/ISA-bus LGA775
Pentium® 4/Celeron® D Processor Card with
VGA/Dual Gigabit LAN/HISA/DVI (800 MHz
FSB)
Jumpers and Connectors
The board has a number of jumpers that allow you to
configure your system to suit your application.The
table below lists the function of each of the jumpers
and connectors.
J1: CMOS clear function
Pins
Result
1-2 (closed) Keep CMOS data*
2-3 (short) Clear CMOS
J1: CMOS clear function
Pins
Result
1-2 (closed) Keep CMOS data*
2-3 (short) Clear CMOS
Label
CN1
CN3
CN4
CN6
CN7
CN8
CN9
CN10
CN11
CN12
CN13
CN16
CN17
CN18
CN19
CN20
CN21
CN22
CN29
CN24
CN30
CN43
CN63
CN64
CN65
CN66
CN67
CN68
CN91
CN93
SA0
SA1
SA2
SA3
ATX1
VCN1
2
Function
Primary IDE connector
FDD connector, Supports 360K/1.2M/720K/
1.44M FDD x 2
Parallel port, Parallel port x 1, supports SPP/
EPP/ECP mode
USB port 1,2
VGA connector
Ethernet connector 1
Serial port: COM1; RS232 (D-sub 9-pin connector)
Serial port: COM2; RS232 (9-pin connector)
PS/2 keyboard and mouse connector
Cable length: 20 meters
External keyboard connector (6-pin)
Infrared connector
Power LED
External speaker
Reset connector
HDD LED connector
ATX feature connector
ATX soft power switch (PS_ON)
HW Monitor Alarm
Close: Enable OBS Alarm
Open: Disable OBS Alarm
SM bus connector
2 LAN ports
SCSI daughterboard
AC97 Audio connector
USB ports 3,4
Case Open
Front Panel LAN indicator connector
USB port 5,6
USB port 7,8
CPU FAN connector (4-pin)
Serial port: COM1; RS232 (9-pin connector)
GPIO pin header (SMD pitch-2.0 mm)
Serial ATA0
Serial ATA1
Serial ATA2
Serial ATA3
ATX 12V Auxiliary power connector
(for CPU)
DVI connector (DF13-20DP-1.25mm TMDS)
PCA-6190 Startup Manual
*default setting
J2: Watchdog timer output option
Closed pins Result
1-2
IRQ11
2-3
System reset *
Software Installation
The CD disc contains a driver installer program that
will lead you through the installation of various device
drivers needed to take full advantage of your CPU
card.
Caution
The computer is supplied with a battery-powered
Real-time Clock circuit. There is a danger of explosion if battery is incorrectly replaced. Replace only
with same or equivalent type recommended by the
manufacturer. Discard used batteries according to
manufacturer's instructions.
1. This device may not cause harmful interference,
and
Safety Information
2. This device must accept any interference received,
including interference that may cause undesired operation
CN12
CN11
CN22
CN43
CN30
5
6
7
8
B
ATX1
CN68
CN19
CN17
CN16
CN21CN18 CN29
DDRII 4
DDRII 3
DDRII 2
DDRII 1
CN93
4
3
2
1
VCN1
CN6 CN63 CN66
CN4
CN24
CN20
J2
CN64
CN7
CN13 J1
CN67
CN65
CN91
CN9
CN1
SA0 SA1 CN3 SA2 SA3 SA3
CN10
This device complies with the requirements in Part 15
of the FCC rules. Operation is subject to the following
two conditions:
Board Layout: Jumper and Connector Locations
PCA-6190 Startup Manual
3