Available at Digi-Key M100F / V 2111 Comprehensive Drive Aurora, Illinois 60505 Phone: 630- 851- 4722 Fax: 630- 851- 5040 www.conwin.com US Headquarters: 630-851-4722 European Headquarters: +353-61-472221 High Precision TCXO / VCTCXO Oscillators Description: Features: The Connor-Winfield M100, M170, and M200 models offer precise frequency stability and excellent phase noise in a 5x3.2mm package. Through the use of analog temperature compensation, these TCXO's and VCTCXO's are capable of holding sub 100 ppb and 200ppb stabilities over the commercial or industrial temperature ranges. Models: M100, M170, M200 Series •Package: 5 x 3.2mm, 8 Pads •Frequencies Available: 10, 12.8, 19.2, 20.0, 24.576, or 40.0 MHz •3.3 Vdc Operation •Output Logic: LVCMOS •Frequency Stability: M100: ±100 ppb, 0 to 70°C M170: ±100 ppb -20 to 70°C M200: ±200 ppb, -40 to 85°C •Fixed Frequency - TCXO •Optional Control Voltage - VCTCXO •Low Jitter <0.50 ps RMS •Low Phase Noise •Tape and Reel Packaging •RoHS Compliant / Lead Free M10 0F 12.8 1243 MH Z Applications: Basestation, Communications, DSL / ADSL, Femtocell, IP Timing, LTE, Precision GPS, SONET / SDH, WiMAX / WiBro, WLAN. Absolute Maximum Ratings Parameter Storage Temperature Supply Voltage (Vcc) Input Voltage (Vc) Minimum Nominal Maximum Units -40 -0.5 -0.5 - - - 85 4.6 Vcc + 0.5 °C Vdc Vdc Notes Ordering Information M Type / Package TCXO / VCTCXO Series M = 5.0x3.2 mm 100 F Frequency Stability and Temperature Range TCXO or VCTCXO 100 = ±100 ppb, 0 to 70°C 170 = ±100 ppb, -20 to 70°C 200 = ±200 ppb, -40 to 85°C Supply Voltage = 3.3 Vdc Output Logic = LVCMOS F = TCXO V = VCTCXO - 012.8M Output Frequency Frequency Format -xxx.xM Min -xxx.xxxxxxM Max *Amount of numbers after the decimal point. M = MHz Example: Part Number Bulletin Page Revision Date Tx382 1 of 4 02 25 March 2015 M100F-012.8M = 5x3.2mm package, ±100 ppb, 0 to 70°C, 3.3 Vdc, LVCMOS Output, TCXO, 12.8 MHz M100V-019.2M = 5x3.2mm package, ±100 ppb, 0 to 70°C, 3.3 Vdc, LVCMOS Output, VCTCXO, 19.2 MHz M200F-010.0M = 5x3.2mm package, ±200 ppb, -40 to 85°C, 3.3 Vdc, LVCMOS Output, TCXO, 10 MHz M200V-020.0M = 5x3.2mm package, ±200 ppb, -40 to 85°C, 3.3 Vdc, LVCMOS Output, VCTCXO, 20 MHz 2111 Comprehensive Drive Aurora, Illinois 60505 Phone: 630- 851- 4722 Fax: 630- 851- 5040 www.conwin.com Operating Specifications Parameter Minimum Nominal Maximum Units Notes Maximum Units Notes Maximum Units Notes Output Frequency (Fo)10.0, 12.8, 19.2, 20.0, 24.576, 40.0 MHz Frequency Calibration @ 25 °C -1.0 - 1.0 ppm 1 Frequency Stability(See Ordering Information for full part number) Model M100x and M170x -100 - 100 ppb 2 Model M200x -200 - 200 ppb 2 Frequency vs. Load Stability -0.20 - 0.20 ppm ±5% Frequency vs. Voltage Stability -0.20 - 0.20 ppm ±5% Static Temperature Hysteresis - - 0.40 ppm 3 Freq. shift after reflow soldering -1.0 - 1.0 ppm 4 Long Term Stability -1.0 - 1.0 ppm 5 Aging per Life (20 Years) -3.0 - 3.0 ppm per Day -40 - 40 ppb per Second - 4.63E-13 - pps Operating Temperature Range(See Ordering Information for full part number) Model M100x 0 - 70 °C Model M170x -20 - 70 °C Model M200x -40 - 85 °C Supply Voltage (Vcc) 3.135 3.30 3.465 Vdc Supply Current (Icc) - - 3.3 mA Jitter: Period Jitter - 3.0 5.0 ps RMS Integrated Phase Jitter - 0.5 1.0 ps RMS 6 SSB Phase Noise for Fo=12.8 MHz @ 10 Hz offset - -90 - dBc/Hz @ 100 Hz offset - -120 - dBc/Hz @ 1 KHz offset - -140 - dBc/Hz @ 10 KHz offset - -150 - dBc/Hz @ 100 KHz offset - -150 - dBc/Hz @ 1 MHz offset - -152 - dBc/Hz SSB Phase Noise for Fo=19.2MHz @ 10 Hz offset - -90 - dBc/Hz @ 100 Hz offset - -115 - dBc/Hz @ 1 KHz offset - -135 - dBc/Hz @ 10 KHz offset - -151 - dBc/Hz @ 100 KHz offset - -154 - dBc/Hz @ 1 MHz offset - -155 - dBc/Hz Start-Up Time - - 10 ms Control Voltage Input Characteristics Parameter Minimum Control Voltage 0.3 Frequency Pullability ±10 Control Voltage Slope Monotonic Linearity - Input Impedance 100K Modulation Bandwidth (3dB) 10 Nominal 1.65 3.0 V - - ppm Positive Slope - 10 % - - Ohm - - KHz LVCMOS Output Characteristics Parameter Load (CL) Voltage (High) (Voh) (Low) (Vol) Duty Cycle at 50% of Vcc Rise / Fall Time 10% to 90% Minimum - 90%Vcc - 45 - Nominal 15 - - 50 4 - - 10%Vcc 55 8 pF Vdc Vdc % ns Bulletin Page Revision Date Specifications subject to change without notification. See Connor-Winfield's website for latest revision. All dimensions in inches. © Copyright 2015 The Connor-Winfield Corporation Not intended for life support applications. 7 Tx382 2 of 4 02 25 March 2015 2111 Comprehensive Drive Aurora, Illinois 60505 Phone: 630- 851- 4722 Fax: 630- 851- 5040 www.conwin.com Package Characteristics Package Hermetically sealed ceramic package with grounded metal cover Environmental Characteristics Vibration: Shock: Soldering Process: Vibration per Mil Std 883E Method 2007.3 Test Condition A. Mechanical Shock per Mil Std 883E Method 2002.4 Test Condition B. RoHS compliant lead free. See soldering profile on page 2. Notes: 1.Initial calibration @ 25°C. ±2°C, for VCTCXO's Vc = 1.65V. Specifications at time of shipment after 48 hours of operation. 2.Frequency stability vs. change in temperature. [±(Fmax-Fmin)/2.Fo]. For VCTCXO's - Vc -= 1.65V 3.Frequency change after reciprocal temperature ramped over the operating range. Frequency measured before and after at 25°C 4.Two consecutive reflows after 1 hour recovery @ 25°C. 5.Frequency drift over 1 year @ 25°C. 6.BW = 12 KHz to Fo/2 7.Attention: To achieve optimal frequency stability, and in some cases to meet the specification stated on this data sheet, it is required that the circuit connected to this TCXO output must have the equivalent input capacitance that is specified by the nominal load capacitance. Deviations from the nominal load capacitance will have a graduated effect on the stability of approximately 20 ppb per pF load difference. M100 - M200 Suggested Pad Layout M100 - M200 Package Outline 0.065 (1.65mm) 0.083 Max. (2.1mm) 0.126 (3.2mm) To Output 0.028 (0.71mm) 0.050 (1.27mm) Top View 0.008 Typ. (0.20mm) Keep Out Area* Pad 8 Pad 1 Bottom View Dimensional Tolerance: +/-0.005 (+/-0.127mm) 0.042 (1.07mm) 0.098 (2.5mm) 0.006 Typ. 0.098 (2.49mm) 1 8 0.050 (1.27mm) * Do not route any traces in the keep out area. It is recommended the next layer under the keep out area is to be ground plane. M100 - M200 Design Recommendations 0.028 (0.71mm) 0.042 (1.07mm) 0.016 (0.41mm) 0.050 (1.27mm) 0.008 Typ. (0.20mm) Vcc, should have a large copper area for reduced inductance. Connect a 0.01uF bypass capacitor <0.1”(2.54mm) from the pad. 0.028 (0.71mm) Pad 8 Pad 1 Bottom View 8 7 9 6 2 3 M100 - M200 Test Circuit TCXO = N/C VCTCXO = Vc 6 2 3 Ground Ground, should have a large copper area for reduced inductance. Output 5 4 Top View Ground 50 Ohm Trace Without Output Vias Buffer TOP LAYER GROUND LAYER ....... 1 7 Buffer M100F 1145 10.0 MHZ OSC DNC DNC 8 4 50 Ohm trace <1”by design Vcc 5 4 10 Top View Vcc Supply Voltage 5 0.010”(0.254mm) Recommended clearance inductance for internal copper flood. 0.042 (1.07mm) 1 10 nF Bypass VCTCXO: Control Voltage (Vc) TCXO: N/C Do Not Connect Do Not Connect Ground Output Do Not Connect Do Not Connect Supply Voltage (Vcc) (0.15mm) 40.0 MHz M100F 1411 0.053 (1.35mm) 4 To Ground 0.065 (1.65mm) 0.1 uF Bypass 2: 3: 4: 5: 6: 7: 8: 0.050 (1.27mm) Alternate Package Layout for Select Frequencies 0.197 (5.0mm) 5 Top View External Bypass Capacitor 0.1 uF & 10 nF 0.028 (0.71mm) 0.126 (3.2mm) 1: 0.028 (0.71mm) 0.042 (1.07mm) 0.016 (0.41mm) M100F 1243 12.8 MHZ 0.197 (5.0mm) 0.006 Typ. (0.15mm) M100 - M200 Pad Connections 15 pF BOTTOM LAYER DNC DNC DNC = Do Not Connect Bulletin Page Revision Date Specifications subject to change without notification. See Connor-Winfield's website for latest revision. All dimensions in inches. © Copyright 2015 The Connor-Winfield Corporation Not intended for life support applications. Tx382 3 of 4 02 25 March 2015 2111 Comprehensive Drive Aurora, Illinois 60505 Phone: 630- 851- 4722 Fax: 630- 851- 5040 www.conwin.com Phase Noise Information LVCMOS Output Waveform 1V/Div Solder Profile Temperature 260°C 260°C 220°C 180°C 150°C 120°C 0 Tape and Reel Information 10 s Up to 120 s 60 to 90 s Typical Typical Meets IPC/JEDEC J-STD-020C Meets EIAi481A and EIAJ-1009B 2000 Pieces per Reel Revision History Revision Date Changes 00 01 02 10/31/12 09/02/14 03/25/15 Data sheet released Phase Noise Plot and Specifications Update Updated Frequencies & Alternate Package Bulletin Page Revision Date Specifications subject to change without notification. See Connor-Winfield's website for latest revision. All dimensions in inches. © Copyright 2015 The Connor-Winfield Corporation Not intended for life support applications. Tx382 4 of 4 02 25 March 2015