CCS575S SAW Clock Oscillator CCS575S Model 5×7.5 mm SMD, 3.3V, True Sinewave Model CCS575S is a True Sinewave SAW(surface acoustic wave) based Clock Oscillator. It is an ideal choice for applications requiring Low Phase Noise and Jitter source. It is housed in the industry standard 5×7.5×2.5mm SMD package. Rev: G Date: 17-Feb-2015 Page 1 of 2 CRYSTEK CORPORATION 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com CCS575S SAW Clock Oscillator CCS575S Model 5×7.5 mm SMD, 3.3V, True Sinewave Performance Specification MIN Nominal Frequency: Customer Specified Frequency Stability: TYP MAX UNITS 315 1000 MHz -150 +125 ppm Output Phase Noise: @1kHz Offset -113 dBc/Hz @10kHz Offset -137 dBc/Hz @100kHz Offset -151 dBc/Hz @1MHz Offset -160 dBc/Hz @10MHz Offset -160 Jitter: 12kHz-20MHz 2nd Harmonic -14 Sub-Harmonics Supply Voltage: pS, RMS -10 dBc Denotes pad 1 0.099 (2.50) dBm 3.15 Supply Current, Icc: Start-Up Time: 3.30 3.45 V 20 25 mA 10 mSec Operating Temperature: -20 2 +70 °C Storage Temperature: -45 +90 °C 0.046 (1.16) 0.058 (1.47) Mechanical Shock MIL-STD-883, Method 2002 Mechanical Vibration MIL-STD-883, Method 2007 Solderability MIL-STD-883, Method 2003 Resistance to Solvents MIL-STD-883, Method 2015 #2 #4 #3 260°C Critical Temperature Zone Ramp-Down 6°C/Sec. 217°C 0.046 (1.16) 0.200 (5.08) PIN Connection 1 2 3 4 N/C GND Output Vcc SUGGESTED PAD LAYOUT RECOMMENDED REFLOW SOLDERING PROFILE TEMPERATURE #1 Conditions Ramp-Up 3°C/Sec Max. 0.200 ±0.015 (5.08 ±0.38) dBc +7 Parameter CCS575S Freq. Date Code dBc/Hz 1 none Output Power into 50 Ω Load: 0.295 -0.008 +0.035 (7.50 -0.20 +0.89) via to ground 0.050 (1.27) 0.01µF 200°C 4 3 0.154 (3.91) 150°C 0.071 (1.80) Preheat 180 Secs. Max. 90 Secs. Max. 8 Minutes Max. 260°C for 10 Secs. Max. NOTE: Reflow Profile with 240°C peak also acceptable. CRYSTEK CORPORATION 1 2 0.200 (5.08) Rev: G Date: 17-Feb-2015 Page 2 of 2 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com