W005 THRU W10 SINGLE-PHASE 1.5AMP. SILICON BRIDGE RECTIFIER WOB FEATURE .360(9.1) .217(5.5) .340(8.6) .197(5.0) .Surge overload ratings-40 Amperes .Good for printed circuit board assembly .220(5.6) .180(4.6) MECHANICAL DATA .Case: Molded plastic .Epoxy: UL 94V-0 rate flame retardant .Lead: MIL-STD- 202E, Method 208 guaranteed .Polarity: As marked .Mounting position: Any .Weight: 1.20 grams .220(5.6) 1.0 .180(4.6) 25.4 MIN. 1.2 MIN. (30.5) .032(0.8) .026(0.65) + ~~ - Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (single-phase, half-wave, 60HZ, resistive or inductive load rating at 25°C, unless otherwise stated) Type Number Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC blocking Voltage Maximum Average Forward rectified Output Current at TA=50°C Peak Forward Surge Current 8.3ms single half sine-wave superimposed on rate load (JEDEC method) Maximum Forward Voltage Drop per element at 1.0A DC Maximum DC Reverse Current Ta =25°C at rated DC blocking voltage Ta =100°C I2t Rating for Fusing (t﹤8.3ms) Typical Junction Capacitance (Note 1) Typical Thermal Resistance (Note 2) Storage Temperature Operating Junction Temperature SYM BOL VRRM VRMS VDC W005 W01 W02 W04 W06 W08 W10 units 50 100 200 400 600 800 1000 V 35 70 140 280 420 560 700 V 50 100 200 400 600 800 1000 V IF(AV) 1.5 A IFSM 40 A VF 1.0 V IR 10.0 500.0 uA uA I2 t CJ R(JA) TSTG TJ 10 A2Sec 24 pF 36 °C /W -55 to +150 °C -55 to +125 °C Note: 1. Measured at 1.0 MHz and applied reverse voltage of 4.0Vdc 2.Thermal Resistance from Junction to lead mounted on P.C.B with 0.5×0.5”(13×13mm) copper pads - 107 - RATING AND CHARACTERISTIC CURVES (W005 THRU W10) FIG.1-TYPICAL FORWARD CURRENT DERATING CURVE FIG.2-TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS 1.5 INSTANEOUS FORWARD CURRENT,(A) AVERGE FORWARD RECTIFIED CURRENT,(A) 10.0 0.75 Single Phase Half Wave 60Hz Resistive or inductive Load 0 0 50 100 150 1.0 .1 .01 200 TJ=25℃ Pulse Width=300μs 1% Duty Cycle 1.0 .8 .6 AMBIENT TEMPERTURE,(℃) 1.2 1.4 INSTANEOUS FORWARD VOLTAGE,(V) FIG.4-TYPICAL REVERSE CHARACTERISTICS FIG.3-MAXIMUN NON-REPETITIVE FORWARD SURGE CURRENT 10 8.3ms Single Half Sine-Wave (JEDEC Method) 60 INSTANEOUS REVERSE CURRENT,(μA) PEAK FORWARD SURGE CURRENT,(A) 80 40 20 0 0 10 100 1.0 TJ=25℃ .1 .01 0 20 40 60 80 100 120 PERCENT OF RATED PEAK REVERSE VOLTAGE,(%) NUMBER OF CYCLES AT 60Hz - 108 - 140