Model A100N50X4 Chip Termination 100 Watts, 50Ω Description The A100N50X4 is high performance Aluminum Nitride (AlN) chip termination intended as an alternative to Beryllium Oxide (BeO). The termination is well suited to all cellular frequency bands such as; AMPS, GSM, DCS, PCS, PHS and UMTS. The high power handling makes the part ideal for terminating circulators and for use in power combiners. The termination is also RoHS compliant! General Specifications Resistive Element Substrate Terminal Finish Operating Temperature Features: • RoHS Compliant • 100 Watts Thick film AlN Ceramic Matte Tin over Nickel Barrier -55 to +150°C (See de rating chart) Tolerance is ±0.010”, unless otherwise specified. Designed to meet of exceed applicable portions of MIL-E-5400. All dimensions in inches. • DC - 2.7 GHz Electrical Specifications • AlN Ceramic Resistance Value: Power: Frequency Range: V.S.W.R. • Non-Nichrome Resistive Element • Low VSWR • 100% Tested 50 Ohms, ± 2% 100 Watts DC – 2.7 GHz 1.1:1 to 2.7 GHz Specification based on unit properly installed using suggested mounting instructions and a 50 ohm nominal impedance. Specifications subject to change. • Small Size Outline Drawing SIDE VIEW TOP VIEW .250 .040 .225 .045 .130 .058 ALL DIMENSIONS IN INCHES A100N50X4 (097) Rev B Available on Tape and Reel For Pick and Place Manufacturing. USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Model A100N50X4 Typical Performance: Power De-rating: Tape & Reel: Mounting Footprint and Procedure: A100N50X4 (097) Rev B USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Available on Tape and Reel For Pick and Place Manufacturing.