HP SERIES 600 Watts Brick Style DC/DC Converter Single Output Rev D Size: 6in x 3in x 0.69in (152.4mm x 76mm x 17.4mm) FEATURES • • • • • • • 100% Burn-In Synchronizable Output Trim ±10% 1500VDC Isolation Operation to No Load 600 Watt Output Power (500W below 13VDC input) Very Low Output Ripple • • • • • • • Fast Transient Response Output Current up to 120A Fixed Switching Frequency Remote Sense Compensation Remote ON/OFF (Active High/Low) Short Circuit and Over Temperature Protection 94% Efficient at Half Load, 92% Efficient at Full Load (Typical) DESCRIPTION The HP series is a high-density brick style converter that incorporates the desired features required in today’s demanding low voltage bus applications. Its unique dual interleaved phase-shifted topology minimizes both input and output noise. When performance, reliability, and low cost are needed, the HP series delivers. MODEL SELECTION TABLE Model Number(1) HP12S12-600 HP12S15-600 HP12S20-600 HP12S24-600 HP12S26-600 HP12S28-600 HP12S48-600 5/19/2016 Input Voltage Range Output Voltage Output Current(5) Ripple & Noise No Load Input Current 12/24VDC (10-36VDC) 12VDC 15VDC 20VDC 24VDC 26VDC 28VDC 50A 40A 30A 25A 23A 21.42A 48VDC 12.5A 1% Vout Max. 0.1A Output Power Efficiency 600W 92% Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797 website: www.wallindustries.com • e-mail: [email protected] Page 1 of 5 HP SERIES 600 Watts Brick Style DC/DC Converter Single Output Rev D SPECIFICATIONS All specifications are based on 25°C, Nominal Input Voltage, and Maximum Output Current unless otherwise noted. We reserve the right to change specifications based on technological advances. SPECIFICATION TEST CONDITIONS INPUT SPECIFICATIONS Input Voltage Range UVLO Turn On at UVLO Turn Off at Input Surge Voltage (100ms) Input Current (Low Line) Input Filter Reflected Ripple Current Remote ON/OFF OUTPUT SPECIFICATIONS Output Voltage Voltage Accuracy Line Regulation Load Regulation Voltage Adjustability Output Power (See Note 5) Output Current Ripple & Noise (20MHz bandwidth) Transient Response Recovery Time Min Typ 10 Unit 36 VDC 10 9.5 VDC VDC 50 VDC 70 A 1,000µF low ESR capacitor recommended 20 mA Active High or Active Low Nominal Vin and Full Load See Table ±1 ±0.2 ±0.2 ±10 600 See Table LL to HL at FL NL to FL % % % % W 1 50% Load Step % Vout % Total Devation %/ºC 5 Temperature Coefficient PROTECTION Short Circuit Protection Self Re-Setting Over Temperature Protection Self Re-Setting Current Limit ENVIRONMENTAL SPECIFICATIONS Operating Case Temperature(6) Storage Temperature Humidity MTBF GENERAL SPECIFICATIONS At Half Load Efficiency At Full Load ±0.02 Continuous 110ºC 130% -40 -55 100 125 Fully Potted Construction 1, 293, 794.959 hours 94 92 Switching Frequency Isolation Voltage Isolation Resistance Isolation Capacitance PHYSICAL SPECIFICATIONS Weight Max Input to Output ºC ºC % 300 kHz 0.01 VDC GΩ µF 1500 1 19.4oz (550g) 6in x 3in x 0.69in (152.4mm x 76mm x 17.4mm) Aluminum Alloy Six-Sided Dimensions (L x W x H) Case Material Shielding NOTES (1) (2) (3) (4) (5) (6) 5/19/2016 Model number for Threaded Inserts shown. Unit comes with 3M x 0.5 threaded thru inserts. For 0.125 thru-hole add a “TH” to the model part number. (Ex. HP12S12-600TH) Pin to pin tolerance ±0.01” [±0.25mm]. Pin diameter tolerance: ±0.005” [±0.13mm] Active High Enable is standard; for Active Low Enable add “R” suffix to the model number. (Ex: HP12S24-600R) Due to advances in technology, specifications subject to change without notice. Output power is limited to 500 watts minimum at 13VDC input and below. Mi suffix is for military temp range of -55 to 100ºC Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797 website: www.wallindustries.com • e-mail: [email protected] Page 2 of 5 Rev D HP SERIES 600 Watts Brick Style DC/DC Converter Single Output DERATING CURVES TRIM EQUATIONS 5/19/2016 Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797 website: www.wallindustries.com • e-mail: [email protected] Page 3 of 5 Rev D HP SERIES 600 Watts Brick Style DC/DC Converter Single Output MECHANICAL DRAWINGS THREADED INSERTS (STANDARD) THRU-HOLD INSERTS (“TH” SUFFIX) 5/19/2016 Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797 website: www.wallindustries.com • e-mail: [email protected] Page 4 of 5 Rev D HP SERIES 600 Watts Brick Style DC/DC Converter Single Output COMPANY INFORMATION Wall Industries, Inc. has created custom and modified units for over 50 years. Our in-house research and development engineers will provide a solution that exceeds your performance requirements on-time and on budget. Our ISO9001-2008 certification is just one example of our commitment to producing a high quality, well-documented product for our customers. Our past projects demonstrate our commitment to you, our customer. Wall Industries, Inc. has a reputation for working closely with its customers to ensure each solution meets or exceeds form, fit and function requirements. We will continue to provide ongoing support for your project above and beyond the design and production phases. Give us a call today to discuss your future projects. Contact Wall Industries for further information: Phone: Toll Free: Fax: E-mail: Web: Address: 5/19/2016 (603)778-2300 (888)597-9255 (603)778-9797 [email protected] www.wallindustries.com 37 Industrial Drive Exeter, NH 03833 Wall Industries, Inc. • 37 Industrial Drive, Exeter, NH 03833 • Tel: 603-778-2300 • Toll Free: 888-597-9255 • Fax 603-778-9797 website: www.wallindustries.com • e-mail: [email protected] Page 5 of 5