DATASHEET Rev. A PSHF150W-SMF SERIES 88~132 / 170~264VAC Input Selectable by Switch Up to 156 Watts Output Power 5, 7.5, 9, 12, 24, 27, & 36VDC Single Outputs AC/DC Switching Power Supplies FEATURES RoHS Compliant Single Outputs ±10% Voltage Adjustment Range Electrolytic Capacitors all 105°C Free Air Convection 7.83” x 3.86” x 1.54” Enclosed Case 85~132/170~264VAC Input Selectable by Switch Up to 156W Output Power Short Circuit, Over Load, and Over Voltage Protection 100% Full Load Burn-in Test High Power Density UL60950, EN60950, GB4943, and CE Approvals DESCRIPTION The PSHF150W-SMF series of AC/DC power supplies offers up to 156W of output power in a 7.83” x 3.86” x 1.54” enclosed case. This series consists of 5, 12, 13.5, 15, 24, and 48VDC single output models with an input voltage range of 85~132/170~264VAC selectable by switch. These supplies have a ±10% output adjustment range and are protected against short circuit, over load, and over voltage conditions. This series is RoHS compliant and has UL60950, EN60950, GB4943, and CE approvals. 12/05/2012 Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833 603-778-2300 www.wallindustries.com Fax 603-778-9797 Page 1 of 4 Rev. A PSHF150W-SMF Series Single Outputs Up to 156 Watts AC/DC Switching Power Supplies SPECIFICATIONS: PSHF150W-SMF SERIES All specifications are based on 25°C, Nominal Input Voltage, and Maximum Output Current unless otherwise noted. We reserve the right to change specifications based on technological advances. SPECIFICATION TEST CONDITIONS Min Nom Max Unit INPUT SPECIFICATIONS Input Voltage Range Selected by switch 85~132 / 170~264VAC Vin = 115VAC 3.5 Input Current A Vin = 230VAC 1.8 Vin = 115VAC 20 Inrush Current Cold start A Vin = 230VAC 40 Input Leakage Current Vin = 230VAC 1 mA Input Frequency 47 63 Hz OUTPUT SPECIFICATIONS Output Voltage See Table Voltage Adjustment Range -10 +10 % 5VDC output model -2 +2 Voltage Tolerance % Others -1 +1 Line Regulation Low line to high line at full load -0.5 +0.5 % Load Regulation 0% to 100% of rated load 0.5 % Output Current See Table Output Power See Table Ripple & Noise See Note 1 See Table Rise Time Full load 50 ms Hold-up Time Full load 20 ms PROTECTION Over Load Protection Shut off, re-power on to recover 110 130 % Over Voltage Protection Shut off, re-power on to recover 115 150 % Short Circuit Protection Shut off, re-power on to recover GENERAL SPECIFICATIONS Efficiency See Table Input to Output 3000 Withstand Voltage All for 1 minute VAC Input to PE 1500 Output to PE 500 ENVIRONMENTAL SPECIFICATIONS Operating Temperature See derating curve -20 +70 °C Operating Humidity non-condensing 20 93 % RH Storage Temperature -20 +85 °C Storage Humidity non-condensing 20 95 % RH Vibration 10~150Hz, 2G 10 min/1 cycle, 30 min each along X, Y, Z axes Cooling Free air convection MTBF > 100,000 hours PHYSICAL SPECIFICATIONS Weight 1.5 lbs (660g) Dimensions (L x W x H) 7.83 x 3.86 x 1.54 inches (199 x 98 x 39 mm) SAFETY & EMC CHARACTERISTICS Safety Standards UL60950, EN60950, GB4943 EMC Standards GB9254, EN55022 Class B, EN55024, EN61000-3-2,3, EN61000-4-2,3,4,5,6,8,11 12/05/2012 Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833 603-778-2300 www.wallindustries.com Fax 603-778-9797 Page 2 of 4 PSHF150W-SMF Series Single Outputs Up to 156 Watts AC/DC Switching Power Supplies Rev. A MODEL SELECTION TABLE Output Voltage Output Current Ripple & Noise (1) Output Power Efficiency PSHF150W-SMF-5 5 VDC 25.0 A 100mVp-p 125W 80% PSHF150W-SMF-12 12 VDC 12.5 A 120mVp-p 150W 84% 85~132 / 170~264 VAC 13.5 VDC 11.1 A 120mVp-p 150W 84% (selectable by switch) 15 VDC 10.0 A 120mVp-p 150W 84% PSHF150W-SMF-24 24 VDC 6.5 A 150mVp-p 156W 85% PSHF150W-SMF-48 48 VDC 3.1 A 150mVp-p 149W 87% Model Number Input Voltage Range PSHF150W-SMF-13.5 PSHF150W-SMF-15 NOTES 1. Ripple & noise is measured at 20MHz using a 12" twisted pair-wire terminated with 0.1µF and 47µF capacitors in parallel. 2. The power supply is considered a component which will be installed into final equipment. The final equipment must be re-confirmed that it still meets EMC directives. MECHANICAL DRAWING Unit: inches (mm) 0.26 (6.5) 0.14 (3.5) 7.48 (190) 0.40 (10.2) 0.71 (18) 0.78 (19.7) 1.13 (28.7) 1.54 (39) Ø0.14 (Ø3.5) 3-M3 0.87 (22) Pin Assignment 1 AC/L 2 AC/N 3 PE 4,5 DC Output (-V) 6,7 DC Output (+V) 6.18 (157) 0.28 (7) Length of assembly screw: 6mm max. 4.72 (120) 0.24 (6) 0.14 (3.5) 0.35 (9) 2.44 (62) 0.37 (9.5) 1 2 5 3.15 (80) 3.37 (85.5) 4 0.31 (8) 3.86 (98) 3 6 7 Vadj LED 6-M3 Ø0.14 (Ø3.5) 0.18 (4.5) 7.58 (192.5) 7.83 (199) 12/05/2012 Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833 603-778-2300 www.wallindustries.com Fax 603-778-9797 Page 3 of 4 PSHF150W-SMF Series Single Outputs Up to 156 Watts AC/DC Switching Power Supplies Rev. A DERATING CURVE 100 Output Power (%) 90 70 50 30 0 -20 -10 0 10 20 30 40 45 50 60 70 Ambient Temperature (°C) COMPANY INFORMATION Wall Industries, Inc. has created custom and modified units for over 50 years. Our in-house research and development engineers will provide a solution that exceeds your performance requirements on-time and on budget. Our ISO9001-2008 certification is just one example of our commitment to producing a high quality, well-documented product for our customers. Our past projects demonstrate our commitment to you, our customer. Wall Industries, Inc. has a reputation for working closely with its customers to ensure each solution meets or exceeds form, fit and function requirements. We will continue to provide ongoing support for your project above and beyond the design and production phases. Give us a call today to discuss your future projects. Contact Wall Industries for further information: Phone: Toll Free: Fax: E-mail: Web: Address: 12/05/2012 (603)778-2300 (888)587-9255 (603)778-9797 [email protected] www.wallindustries.com 5 Watson Brook Rd. Exeter, NH 03833 Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833 603-778-2300 www.wallindustries.com Fax 603-778-9797 Page 4 of 4