Tape Information www.vishay.com Vishay Siliconix SC-70: 5- and 6-Leads (T1 and T3 Methods) see note 6 2.000 0.050 1.750 0.100 Ø 1.500 see note 1 4.000 0.100 see note 6 3.500 0.100 0.500 0.25 ± 0.05 B0 see note 4 2.500 ± 0.100 0.1000 8.000 0.300 Ø 1.000 ± 0.2500 4.000 0.100 K0 see note 5 1.200 ± 0.100 10° max. A0 see note 4 2.400 ± 0.100 Notes (1) 10 sprocket hole pitch cumulative tolerance ± 0.2 mm. (2) Camber not to exceed 1 mm in 100 mm, also not to exceed 1.5 cm in 1 m actually. (3) Material: black conductive or black static dissipative. (4) A and B measured on a plane 0.3 mm above the bottom of the pocket except 3M carrier tape. 0 0 (5) K measured from a plane on the inside bottom of the pocket to the top surface of the carrier. 0 (6) Should be measured from: a) sprocket hole to pocket center, and b) sprocket hole to pocket hole. (7) All size in mm unless specified. (8) Tolerances will be ± 0.1 mm unless specified. (9) Vishay part number must be labeled at all reels of carrier tape. (10) Surface resistivity: 104 to 1011 Ω. QUANTITY PER REEL T1 3000 T3 (1) 10 000 Note Not standard offering. Please contact local sales office for availability. (1) ECN: C15-0523-Rev. J, 08-Jun-15 DWG: 93-5213-X Revision: 08-Jun-15 Document Number: 71205 1 For technical questions, contact: [email protected] THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000