Tape Information Vishay Siliconix PowerPAK MLP(QFN), 4 x 4/3 x 3 DFN-10, 3 x 3 MLP33-8/10 PPAIR 3 x 3 4.0 see note 1 0.25 2.0 0.05 see note 4 R0.25 ∅ 1.5 + 0.1 /- 0.0 A 1.75 ∅ 1.5 min. 5.5 0.05 see note 4 12.0 0.3 BO R0.3 max. A SECTION A-A Notes 1. 10 sprocket hole pitch cumulative tolerance ± 0.2 mm. 2. Camber not to exceed 1 mm in 100 mm, also not to exceed 1.5 cm in 1 m actually. 3. Material: Black conductive or black static dissipative 4. It should be measured from: a. sprocket hole to pocket center and b. sprocket hole to pocket hole 5. All sizes in mm unless specified. 6. Tolerances will be ± 0.1 mm unless specified. 7. Vishay part number must be labeled at all reels of cover and carrier tape. 8. Surface resistivity - 105 max. /sq. Version Package B0 -1 MLP(QFN), 4 x 4 4.35 ± 0.1 MLP(QFN), 3 x 3 MLP33-8/10 -2 3.30 ± 0.1 DFN-10, 3 x 3 PPAIR, 3 x 3 ECN T11-0383-Rev. I, 29-Aug-11 DWG: 93-5225-X Quantity per Reel Document Number: 71914 Revision: 29-Aug-11 T1 2500 T1 3000 for MLP33-8/10 and PPAIR 3 x 3 www.vishay.com 1 This document is subject to change without notice. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000