Tape Information www.vishay.com Vishay Siliconix TSOP: 5/6-LEAD (SC-59) Ø 1.5 + 0.1/-0.0 B B 4.0 see note 1 A 1.75 0.05 2.0 see note 6 see note 4 0.25 ± 0.05 3.5 0.05 see note 4 8.0 BO KO see note 5 4.0 0.3 A AO Section A-A see note 4 Ø 1.0 min. Ao = 3.30 mm 0.1 max. Bo = 3.20 mm Ko = 1.40 mm Section B-B Notes (1) 10 sprocket hole pitch cumulative tolerance ± 0.2 mm. (2) Camber not to exceed 1 mm in 100 mm, also not to exceed 1.5 cm in 1 m actually. (3) Material: black conductive or black static dissipative. (4) A and B measured on a plane 0.3 mm above the bottom of the pocket except 3M carrier tape. O O (5) K measured from a plane on the inside bottom of the pocket to the top surface of the carrier. O (6) It should be measured from: a. sprocket hole to pocket center and b. sprocket hole to pocket hole (7) All sizes in mm unless specified. (8) Tolerances will be ± 0.1 mm unless specified. (9) Vishay part number must be labeled at all reels of carrier tape. (10) Surface resistivity: 104 to 1011 Ω. QUANTITY PER REEL T1 3000 T3 (1) 10 000 Note Not standard offering. Please contact local sales office for availability. (1) ECN: C15-0524-Rev. H, 06-Jul-15 DWG: 93-2345-X Document Number: 71219 1 For technical questions, contact: [email protected] THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000 Revision: 06-Jul-15