Datasheet 0F-12 R Module

more than you expect
Würth Elektronik ICS GmbH & Co. KG
Intelligent Connecting Systems
Zeilbaumweg 15 · 74613 Öhringen · Germany
Tel. +49 (0) 79 41 92 05-0 · Fax +49 (0) 79 41 92 05-39
[email protected] · www.we-online.com
Central Electrical Unit
0F-12μR Module
Ref. ICS-95890
REDLINE
Features
• Power supply 12 V or 24 V
• 12 micro relay bases
• Footprint for fly wheel diodes (in THT or SMD) and
for zero Ohm resistors (in SMD)
• JPT/MCP compatible, 3 row, 21 way connectors for
inputs / outputs on the rear side of the module
Front View
Options
• Fly wheel diode (SM4007) in parallel of relay coil
• Solder bridges to interconnect ground signal
• Standard micro relays 12 V or 24 V with resistors
Rear View
Applications
• Based on the REDline product range, this board will give you the ability
to switch up to 15 A on each relay
• Each connection to the relay is available in the JPT connector
• Solder bridges gives you the possibility to join all the coil’s ground signals
• The dimensions of the module are twice of size for the REDline
additional module
Page 1 of 4
more than you expect
Central Electrical Unit
0F-12μR Module
4,2 mm
121 mm
Dimensions
102 mm
≈ 38 mm
17,3 mm
≈ 50 mm
Approximate component
size (depending on
components)
Technical Data
Temperature range
-40°C to +85°C
Max. supply current per circuit
(all circuit loaded)
Max. 15 A by 60°C ambient
Max. 8 A by 85°C ambient
Relay’s coil connection,
Input/output connection
JPT/MCP compatible, 3 row / 21 way colored connectors
Recommended wire section*
Current I ≤ 15 A : 7.5 A per mm2
Current I > 15 A : 5 A per mm2
* Refer to the selected cable specification
Page 2 of 4
more than you expect
Central Electrical Unit
0F-12μR Module
Electrical Schematic
Page 3 of 4
more than you expect
Central Electrical Unit
0F-12μR Module
Connector: JPT 21 (X301)
Connector: JPT 21 (X302)
Connector: JPT 21 (X303)
Female connector required for cable harness connection (view on cable entry)
Pin outs on the connector correspond to the associated component on the board.
(e.g.: K311.30 is connected to pin 7 from connector X303)
Page 4 of 4