MtronPTI XO7080 Pure Sine Output SMT VCXO P/N: XO7080-xxx Features: Pure Sine-Output VCXO Low Height: 0.155’ max Low-g: < 0.3ppb/g worst case axis option available Compatible with automated assembly processes; including post reflow aqueous and non-aqueous cleaning Applications: Avionics SatCom Cyber security and communication systems Electrical Specifications for Representative 125MHz VCXO: Parameter Nominal Frequency vs. Temperature Range vs. Supply Voltage vs. Load Aging 1st Year Output Type Output Load Level Method Tuning Slope Tuning Voltage Tuning Range Modulation Bandwidth Input Impedance SSB Phase Noise Under Static Conditions G-Sensitivity Warm-up Time Unless otherwise specified; T= +25°C, VS = +5VDC, VC = +2.5VDC, Load= 50Ω Symbol Min. Typ. Max. Units FO 10 300 MHz Frequency Stabilities -20 +20 ppm -0.5 +0.5 ppm -0.5 +0.5 ppm -1.0 +1.0 ppm RF Output Sinewave 50 Ω -3 0 +3 dBm Frequency Adjustment External Voltage Tuned Negative VTUNE 0 +5 VDC -25 +25 ppm 3 kHz 10 KΩ Other Parameters -70 -97 -127 -150 -150 0.5 ppb/g ΔF/F Harmonics Spurious Supply Voltage VS 5 Minutes -20 -90 dBc dBc 3 mA -40 +85 °C -55 +105 °C Supply Voltage & Power Consumption 4.75 5.0 5.25 Current Draw Conditions -40°C to +85°C ±5% change in voltage ±5% change in load ±10% In a 50Ω load @ 10Hz Offset @ 100Hz Offset @ 1kHz Offset @ 10kHz Offset @ 100kHz Offset Worst case axis To be within ±100ppb, @ 25˚C, referenced to the frequency after 24-hour power on VDC Environmental Conditions: Operating Temperature OT Non-Operating Temperature 1 of 2 The information contained herein is proprietary to MtronPTI and is submitted in confidence. This information may not be copied or divulged without written permission from MtronPTI. MtronPTI XO7080 Pure Sine Output SMT VCXO P/N: XO7080-xxx Shock and Vibration: Three (3) ½ sine shock pulses of the given force and duration on each of the three (3) axis. The VCXO shall operate during and after the shock pulses. Direction: Force Duration (msec) Vertical: 160 G’s 3 to 5 Front to Back: 80 G’s 3 to 5 Side to Side: 80 G’s 3 to 5 VCXO shall operate for periods up to 2-hours duration when subjected to any of the vibration in the given ranges, with the corresponding input amplitude listed. The requirement shall be met regardless of the direction of the vibration. Frequency (Hz) 4 – 15 16 - 25 26 - 33 Input Amplitude (inches) 0.04 ±0.008 0.03 ±0.006 0.04 ±0.008 Figure 1 - XO7080 Outline Drawing Figure 2 – Recommended PAD Layout Data Sheet Revision Table: Date Rev. 12-28-15 A Orig. DD Figure 3 – Recommended Reflow Profile Details of Revision Preliminary Draft 2 of 2 The information contained herein is proprietary to MtronPTI and is submitted in confidence. This information may not be copied or divulged without written permission from MtronPTI.