PENB1020A Universal 19.2W Gigabit PoE Adapter 3 Year Warranty •10/100/1000 (MbPS) Data Rates •Self-contained Injector •100-240Vac Universal Input •Green DC Power LED •Overload and Short Circuit Protection •Regulated Output with Low Ripple •Compliant to UL/IEC/EN60950-1 •LPS (Limited Power Source) Compliant •RoHS Compliant Description The PENB1020A Series of Power-over-Ethernet (PoE) adapters operate from a 90 to 264Vac input range, and provide up to 19.2W of output power at an output voltage of 48Vdc. These models are capable of operating with Gigabit Data rates, and include features include diagnostic LED, and overvoltage, overload, and short circuit protection. This non-compliant adapter does not require a “handshake” signal to enable the output voltage. Specifications All specifications are typical at nominal input, full load at 25°C unless otherwise stated AC Input 100-240Vac +/- 10%, 47-63 Hz single phase Input Current MTBF >60,000 hours, calculated (7 years) 0.5A @ 90Vac 0.25A @ 180Vac 60A peak, cold start Hold-Up Time Internal Primary Current Fuse provided, 250Vac/3.15A Dialectric Withstand 4242Vdc Primary – Secondary, 2,150Vdc Primary–GND, 500Vdc Secondary - GND Earth Leakage Current <250µA @ 264Vac, 60Hz Turn-on Time Output Power Input Inrush Current Input Protection 19.2W continuous, convection cooled Ripple and Noise See Chart below Output Voltage Transient Response 48Vdc Typical 0.5msec for 50% load change typical Regulation See chart below Case Material 94V-0 Black Polycarbonate 18mS min. @ 115Vac, 60Hz 60mS min. @ 230Vac, 60Hz 65% minimum Efficiency 2.0 seconds max., at 115v230Vac, 60Hz Rise Time 100mS max.@ 115/230Vac, 60Hz Short Circuit Protection 10 minutes max. @ 265Vac, 60Hz Operating Temperature 0° to +40°C Storage Temperature -30° to +85°C Relative Humidity 5% to 95%, non-condensing Altitude 0 to 10,000 ft Safety Standards UL/IEC/EN60950-1, CE, CB Dimensions W: 1.9” x L: 4.44” x H: 1.3”. Weight: 120g Models Model Number Output Voltage Output Current Ripple & Noise¹ Max. Power Regulation IEEE802.3af Line Load Compliant? PENB1020A4800F01 48Vdc 0.4A 480mV pk-pk 15.4W ±2% ±5% No IEC60320, C14 PENB1020A4800N01 48Vdc 0.4A 480mV pk-pk 15.4W ±2% ±5% No IEC60320, C8 Note: 1. AC Input Receptacle Measured at 20MHz bandwidth, with noise probe as close to output RJ-45 connector as possible, and load terminated with 0.1μF ceramic and 10μF low ESR electrolytic capacitors. ______________________________________________________________________________________________________________________________ SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 805.832.6131 • Email: [email protected] • www.slpower.com 1 of 2 PENB1020A Universal 19.2W PoE Gigabit 3 Year Warranty EMI/EMC Compliance Conducted Emissions EN55022: 2006+ A1:2007 (Class B) Radiated Emissions EN55022: 2006+ A1:2007 (Class B) Static Discharge Immunity EN55024/IEC61000-4-2, 6kV/8kV, Criteria A Radiated RF Immunity EN55024/IEC 61000-4-3, 3V/m, Criteria A EFT/Burst Immunity EN55024/IEC 61000-4-4, 2kV, 5kHz, Criteria A Line Surge Immunity EN55024/IEC 61000-4-5, 1kV/2kV, Criteria A Conducted RF Immunity EN55024/IEC 61000-4-6, 3V (AM 80%, 1kHz), Criteria A Power Frequency Magnetic Field Immunity Line Harmonic Emissions EN55024/IEC 61000-4-8, 3A/m, Criteria A EN55024/IEC 61000-4-11, 100%, 10mS; 60%, 100mS; 30%, 500mS Criteria A. 100$, 5000mS, Criteria B EN61000-3-2: 2006 Flicker Test EN61000-3-3: 2008 Voltage Dip Immunity Outline Drawing IEC320 C14 input receptacle shown. Other options available. Consult factory for details and availability. PSA pinout Alternative B (IEEE 802.3af 33.2.2): J1 Pins 1 2 3 4 5 6 7 8 Da ta Pa ir 1 Da ta Pa ir 1 Da ta Pa ir 2 +VDC +VDC Da ta Pa ir 2 -VDC -VDC J2 Pins 1 2 3 4 5 6 7 8 Data Pa i r 1 Data Pa i r 1 Data Pa i r 2 No Connecti on No Connecti on Data Pa i r 2 No Connecti on No Connecti on Data Sheet © 2014 SL Power Electronics Corp. The information and specifications contained herein are believed to be correct at the time of publication. Rev. 12/1/2014 However, SL Power accepts no responsibility for consequences arising from reproduction errors or inaccuracies. Specifications are subject to change without notice. ______________________________________________________________________________________________________________________________ SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 805.832.6131 • Email: [email protected] • www.slpower.com 2 of 2