P10GG

P10GG-xxxxE(Hxx)LF
PMF-SERIES
Rev.02-2009
2 Watt
Regulated
Single Output
SIP 12 Case
1 kV up to 5.2kV DC I/O Isolation
Cont. Short Circuit Protection
Mainzer Straße 151–153
D-55299 Nackenheim
Tel. +49 6135 7026-0
Fax: +49 6135 931070
www.peak-electronics.de
[email protected]
The PMF series P10GG-xxxxE(Hxx)LF is a family of cost effective 2 W
regulated single output DC/DC converters. These converters are in an ultra
miniature SIP12 case. Devices are encapsulated. High performance
features: Regulated Output, 1000VDC up to 5200VDC input/output
isolation, high efficiency operation, output voltage accuracy of ±2%
maximum and input range of ±10% tolerance.
All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified
Input Specifications
Voltage Range
Input Filter
Input Reflected Ripple Current¹
± 10%
Capacitors
20 mA pk-pk
Output Specifications
Voltage Accuracy
Short Circuit Protection
Line Regulation
Load Regulation (0% - 100%)
Ripple and Noise (20Mhz bandwidth)
Temperature Coefficient
± 2%
Indefinite (Automatic Recovery)
± 0.5%
± 0.5% (3.3Vout Models: ± 1.5%)
75 mV pk-pk
± 0.02% / °C
General Specifications
Efficiency
I/O Isolation Voltage (3 sec.)
I/O Isolation Capacity
I/O Isolation Resistance
Switching Frequency
Humidity
Reliability Calculated MTBF (MIL-HDBK-217F)
See Table
1000 VDC (up to 5200 VDC optional*)
60 pF, typ.
1000 M Ohm
50 kHz (typ.)
95% rel H
> 1.12 Mhrs
Physical Specifications
Case Material
Potting Material
Weight
Non Conductive Black Plastic (UL94V-0 rated)
Epoxy (UL94V-0 rated)
~ 7.2g, typ.
Environment Specifications
Operating Temperature
Maximum Case Temperature
Storage Temperature
Cooling
RoHS Conform
-25 to +71°C (ambient)
100°C
-40 to +125°C
Free Air Convection
Soldering 260°C, max. (1.5mm from case 10s.)
PMF-Series – P10GG-xxxxE(Hxx)LF – Single Output – SIP12 - Plastic Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 1/3
Selection Guide
Single Output
Order #
SINGLE OUTPUT
P10GG-053R3ELF
P10GG-0505ELF
P10GG-057R2ELF
P10GG-0509ELF
P10GG-0512ELF
P10GG-0515ELF
P10GG-0518ELF
P10GG-0524ELF
P10GG-123R3ELF
P10GG-1205ELF
P10GG-127R2ELF
P10GG-1209ELF
P10GG-1212ELF
P10GG-1215ELF
P10GG-1218ELF
P10GG-1224ELF
P10GG-243R3ELF
P10GG-2405ELF
P10GG-247R2ELF
P10GG-2409ELF
P10GG-2412ELF
P10GG-2415ELF
P10GG-2418ELF
P10GG-2424ELF
A)
)
)
mA ad (mA
d (m
(
a
)
o
d
²
)
Loa
ull L
uF)
VDC
ll L o
DC
nt F
)
ad (
ge (
t No rent Fu
e (V
e
o
a
n
r
%
g
t
r
(
L
l
e
a
r
u
r
t
o
r
r
l
o
cy
V
C
t Vo
t Cu put Cu
acit
put
put
cien
Inpu
Inpu
In
Out
Out
Effi
Cap
5
5
5
5
5
5
5
5
12
12
12
12
12
12
12
12
24
24
24
24
24
24
24
24
70
70
70
70
80
80
80
80
30
30
30
45
45
45
50
50
25
25
25
25
25
25
25
25
515
606
606
597
597
597
597
579
214
252
252
248
248
248
245
245
107
124
124
122
122
122
120
120
3.3
5
7.2
9
12
15
18
24
3.3
5
7.2
9
12
15
18
24
3.3
5
7.2
9
12
15
18
24
500
400
277.7
222.2
166.6
133.3
111.1
83.3
500
400
277.7
222.2
166.6
133.3
111.1
83.37
500
400
277.7
222.2
166.6
133.3
111.1
83.3
64
66
66
67
67
67
67
69
64
66
66
67
67
67
68
68
64
67
67
68
68
68
69
69
330
330
330
330
330
330
330
330
330
330
330
330
330
330
330
330
330
330
330
330
330
330
330
330
If you need other specifications, please enquire.
*OPTIONS:
H30 = 3000 VDC ISOLATION
H52 = 5200 VDC ISOLATION
For other I/O Isolation please see
table on the left hand side and add
“Hxx” before LF
(P10GG-2412EH52LF for 5.2kV)
Notes:
PMF-Series – P10GG-xxxxE(Hxx)LF – Single Output – SIP12 - Plastic Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 2/3
Package / Pinning / Derating
3.40
(0.13)
0.30
(0.01)
2.50
(0.10)
0.50
(0.02)
All dimensions are typical in millimeters (inches).
- Pin diameter: 0.5 +/-0.05 (0.02 +/-0.002)
- Pin pitch tolerance: +/-0.35 (+/-0.014)
- Case tolerance +/-0.5 (+/-0.02)
Specification may change without notice.
0.68
(0.03)
8.00
(0.32)
32.00
(1.26)
14.00
(0.55)
PEAK
3.05
(0.12)
Modelcode
Datecode
12
0.50
(0.02)
1
2.54
(0.10)
3.40
(0.13)
27.94
(1.10)
PIN CONNECTIONS
SINGLE ≥3kV
#
SINGLE
1 +Vin
+Vin
2 N.C.
- Vin
3 N.C.
N.C.
9 N.C.
N.C.
10 - Vout
- Vout
11 +Vout
+Vout
12 - Vin
N.C.
App Notes:
¹ = Measured Input reflected ripple current with a simulated source inductance of 12uH.
² = Tested by minimal Vin and constant resistive load.
PMF-Series – P10GG-xxxxE(Hxx)LF – Single Output – SIP12 - Plastic Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 3/3