P8GG-xxxxE(Hxx)LF PMF-SERIES Rev.02-2009 1.5 Watt Regulated Single Output SIP 12 Case 1 kV up to 5.2kV DC I/O Isolation Cont. Short Circuit Protection Mainzer Straße 151–153 D-55299 Nackenheim Tel. +49 6135 7026-0 Fax: +49 6135 931070 www.peak-electronics.de [email protected] The PMF series P8GG-xxxxE(Hxx)LF is a family of cost effective 1.5 W regulated single output DC/DC converters. These converters are in an ultra miniature SIP12 case. Devices are encapsulated. High performance features: Regulated Output, 1000VDC up to 5200VDC input/output isolation, high efficiency operation, output voltage accuracy of ±2% maximum and input range of ±10% tolerance. All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified Input Specifications Voltage Range Input Filter Input Reflected Ripple Current¹ ± 10% Capacitors 20 mA pk-pk Output Specifications Voltage Accuracy Short Circuit Protection Line Regulation Load Regulation (0% - 100%) Ripple and Noise (20Mhz bandwidth) Temperature Coefficient ± 2% Indefinite (Automatic Recovery) ± 0.5% ± 0.5% (3.3Vout Models: ± 1.5%) 75 mV pk-pk ± 0.02% / °C General Specifications Efficiency I/O Isolation Voltage (3 sec.) I/O Isolation Capacity I/O Isolation Resistance Switching Frequency Humidity Reliability Calculated MTBF (MIL-HDBK-217F) See Table 1000 VDC (up to 5200 VDC optional*) 60 pF, typ. 1000 M Ohm 50 kHz (typ.) 95% rel H > 1.12 Mhrs Physical Specifications Case Material Potting Material Weight Non Conductive Black Plastic (UL94V-0 rated) Epoxy (UL94V-0 rated) ~ 7.2g, typ. Environment Specifications Operating Temperature Maximum Case Temperature Storage Temperature Cooling RoHS Conform -25 to +71°C (ambient) 100°C -40 to +125°C Free Air Convection Soldering 260°C, max. (1.5mm from case 10s.) PMF-Series – P8GG-xxxxE(Hxx)LF – Single Output – SIP12 - Plastic Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 1/3 Selection Guide Single Output Order # SINGLE OUTPUT P8GG-053R3ELF P8GG-0505ELF P8GG-057R2ELF P8GG-0509ELF P8GG-0512ELF P8GG-0515ELF P8GG-0518ELF P8GG-0524ELF P8GG-123R3ELF P8GG-1205ELF P8GG-127R2ELF P8GG-1209ELF P8GG-1212ELF P8GG-1215ELF P8GG-1218ELF P8GG-1224ELF P8GG-243R3ELF P8GG-2405ELF P8GG-247R2ELF P8GG-2409ELF P8GG-2412ELF P8GG-2415ELF P8GG-2418ELF P8GG-2424ELF A) ) ) mA ad (mA d (m ( a ) o d ² ) Loa ull L uF) VDC ll L o DC nt F ) ad ( ge ( t No rent Fu e (V e o a n r % g t r ( L l e a r u r t o r r l o cy V C t Vo t Cu put Cu acit put put cien Inpu Inpu In Out Out Effi Cap 5 5 5 5 5 5 5 5 12 12 12 12 12 12 12 12 24 24 24 24 24 24 24 24 70 70 70 90 90 90 90 130 50 50 50 50 50 50 50 50 25 25 25 25 25 25 25 25 432 454 454 454 447 447 447 441 180 189 186 186 186 183 183 183 88 96 96 96 93 93 93 91 3.3 5 7.2 9 12 15 18 24 3.3 5 7.2 9 12 15 18 24 3.3 5 7.2 9 12 15 18 24 400 300 208.3 166.6 125 100 83.3 62.5 400 300 208.3 166.6 125 100 83.3 62.5 400 300 208.3 166.6 125 100 83.3 62.5 61 66 66 66 67 67 67 68 61 66 67 67 67 68 68 68 62 65 65 65 67 67 67 68 220 220 220 220 220 220 220 220 220 220 220 220 220 220 220 220 220 220 220 220 220 220 220 220 If you need other specifications, please enquire. *OPTIONS: H30 = 3000 VDC ISOLATION H52 = 5200 VDC ISOLATION For other I/O Isolation please see table on the left hand side and add “Hxx” before LF (P8GG-2412EH52LF for 5.2kV) Notes: PMF-Series – P8GG-xxxxE(Hxx)LF – Single Output – SIP12 - Plastic Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 2/3 Package / Pinning / Derating 3.40 (0.13) 0.30 (0.01) 2.50 (0.10) 0.50 (0.02) All dimensions are typical in millimeters (inches). - Pin diameter: 0.5 +/-0.05 (0.02 +/-0.002) - Pin pitch tolerance: +/-0.35 (+/-0.014) - Case tolerance +/-0.5 (+/-0.02) Specification may change without notice. 0.68 (0.03) 8.00 (0.32) 32.00 (1.26) 14.00 (0.55) PEAK 3.05 (0.12) Modelcode Datecode 12 0.50 (0.02) 1 2.54 (0.10) 3.40 (0.13) 27.94 (1.10) PIN CONNECTIONS SINGLE ≥3kV # SINGLE 1 +Vin +Vin 2 N.C. - Vin 3 N.C. N.C. 9 N.C. N.C. 10 - Vout - Vout 11 +Vout +Vout 12 - Vin N.C. App Notes: ¹ = Measured Input reflected ripple current with a simulated source inductance of 12uH. ² = Tested by minimal Vin and constant resistive load. PMF-Series – P8GG-xxxxE(Hxx)LF – Single Output – SIP12 - Plastic Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 3/3