P20VG_4:1

P20VG-xxxxE/Z4:1LF
Mainzer Straße 151–153
D-55299 Nackenheim
Tel. +49 6135 7026-0
Fax: +49 6135 931070
www.peak-electronics.de
[email protected]
PMNW-SERIES
Rev.11-2012
20 Watt
4:1 Wide Input
1” x 1” Case
1.6 kV DC I/O Isolation
Reg. Single and Dual Output
Remote ON/OFF Control
Continuous Short Circuit Prot.
The PMNW series is a family of high performance 20W single & dual output
DC-DC converters. These are encapsulated in nickel coated copper 1” x 1”
case with non conductive base.
All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified
Input Specifications
Voltage Range
Input Filter
4:1 Wide Input (see table)
Pi-Type
Output Specifications
Voltage Accuracy
Short Circuit Protection
Output Voltage Adjustable (trim)
Cross Regulation1 (dual output)
Line Regulation
Load Regulation (0% - 100%)
Ripple and Noise (20Mhz bandwidth)
Transient Recovery2
Transient Response Deviation2
Temperature Coefficient
± 1%
Indefinite (hiccup, automatic recovery)
± 10%, max. (only single output)
± 5%
± 0.5%, max.
± 0.5%, max. (single) ± 1%, max. (dual)
3.3 & 5.0 V: 75mV pk-pk, max
Other modules: 100 mV pk-pk, max.
250 us, typ.
± 3%, max.
± 0.02% / °C
General Specifications
Efficiency
I/O Isolation Voltage (3 sec.)
I/O Isolation Resistance
Switching Frequency
Humidity
Reliability Calculated MTBF (MIL-HDBK-217F)
See Table
1600 VDC
1000 MOhm, min.
330 kHz, typ.
95% rel H
> 560 khrs
Physical Specifications
Case Material
Weight
Nickel Coated Copper
~ 19 g, typ.
Environment Specifications
Operating Temperature
Maximum Case Temperature
Storage Temperature
Cooling
RoHS Conform
-40 to +55°C (for 100%)
105°C
-40 to +125°C
Free Air Convection (10 mm distance required)
Soldering 260°C, max. (1.5mm from case 10s.)
PMNW-Series – P20VG-xxxxE/Z 4:1LF – Single and Dual Output – 1”x1” - Metal Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 1/3
Selection Guide
Single and Dual Output (If you need other specifications, please enquire)
Order #
)
A)
)
)
mA
(mA
d (m
(mA
ad (
a
d
o
)
d
o
a
L
a
L
C
)
o
)3
ll
n.
(uF
(VD
o Lo
ull L
VDC
t Mi
t Fu
d
(
N
e
F
)
n
n
a
t
g
t
e
e
e
o
n
a
n
%
r
r
rre
rre
ltag
or L
Volt
cy (
Cur
Cur
t Cu
t Cu
t Vo
acit
put
put
put
cien
Inpu
Inpu
Inpu
Out
Out
Out
Effi
Cap
SINGLE OUTPUT
P20VG-243R3E4:1LF
P20VG-2405E4:1LF
P20VG-2412E4:1LF
P20VG-2415E4:1LF
P20VG-483R3E4:1LF
P20VG-4805E4:1LF
P20VG-4812E4:1LF
P20VG-4815E4:1LF
9-36
9-36
9-36
9-36
18-75
18-75
18-75
18-75
50
50
22
22
30
30
15
15
703
936
936
936
352
468
468
468
3.3
5
12
15
3.3
5
12
15
0
0
0
0
0
0
0
0
4500
4000
1670
1330
4500
4000
1670
1330
88
89
89
89
88
89
89
89
10000
5000
850
700
10000
5000
850
700
DUAL OUTPUT
P20VG-2412Z4:1LF
P20VG-2415Z4:1LF
P20VG-4812Z4:1LF
P20VG-4815Z4:1LF
9-36
9-36
18-75
18-75
25
25
15
15
936
936
468
468
± 12
± 15
± 12
± 15
0
0
0
0
± 833
± 667
± 833
± 667
89
89
89
89
± 470
± 330
± 470
± 330
25.40
(1.00)
20.32
(0.80)
Package / Pinning / Derating
#
1
2
3
4
5
6
PIN CONNECTION
SINGLE
DUAL
+Vin
+Vin
- Vin
- Vin
CTRL
CTRL
+Vout
+Vout
Trim
Common
- Vout
- Vout
PMNW-Series – P20VG-xxxxE/Z 4:1LF – Single and Dual Output – 1”x1” - Metal Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 2/3
App Notes
1 = One load is 25% to 100% load, the other load is 100% load, the output voltage variable rate is within ±5%.
2 = Tested by nominal Vin and 25% load step change (75% - 50% - 25% of Io)
3 = Tested by minimal Vin and constant resistive load.
4 = Input filter meets EN 55022 Class A without external components.
5 = An external filter capacitor is required if the module has to meet EN61000-4-4 and EN61000-4-5
EMC SPECIFICATIONS
Radiated
Emissions
Conducted
4
Emissions
ESD
RS
5
EFT
5
Surge
CS
PFMF
Rtrim-up
EN 55022
CLASS A
EN 55022
CLASS A
EN 61000-4-2
EN 61000-4-3
EN 61000-4-4
EN 61000-4-5
EN 61000-4-6
EN 61000-4-8
Perf. Criteria A
Perf. Criteria A
Perf. Criteria A
Perf. Criteria A
Perf. Criteria A
Perf. Criteria A
Rtrim-down
5
4
6
5
External Output Trimming
Output can be externally trimmed.
(Single output models only!)
Over Voltage Protection (Zender diode clamp)
Under Input Voltage Lockout (typ.)
3.3 Vout:
3.9 V
24 Vin Models
Module ON/OFF 8.6V / 7.9V
5 Vout
6.2 V
48 Vin Models
Module ON/OFF 17.8V / 15.5V
12 Vout
15 V
Remote ON/OFF Control
± 5 Vout
± 6.2 V
± 12 Vout
± 15 V
ON:
± 15 Vout
± 18 V
OFF:
OFF idle current:
3 -12 VDC or open circuit
0 – 1.2 VDC or short circuit
PIN2 and PIN3
5mA, typ.
Notes:
PMNW-Series – P20VG-xxxxE/Z 4:1LF – Single and Dual Output – 1”x1” - Metal Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 3/3