P48WG-xxxxE/Z4:1LF Mainzer Straße 151–153 D-55299 Nackenheim Tel. +49 6135 7026-0 Fax: +49 6135 931070 www.peak-electronics.de [email protected] PM9-SERIES Rev.01-2009 20 Watt 4:1 Ultra Wide Input Regulated Output Single and Dual Output 1.5 kV DC I/O Isolation 2” x 1” Case Over Voltage Protection The PM9 series is a family of cost effective 20 W, single & dual output DC/DC converters with a ultra wide 4:1 Input. These converters are encapsulated in nickel coated copper 2”x1” case with high performance technology like active clamp, high efficiency operation and output voltage accuracy of ±1% maximum. Precise controlled design provides tight line / load regulation All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified Input Specifications Voltage Range Input Filter Input Reflected Ripple Current¹ Start up Time (Nom. Vin and constant resistive load) 4:1 Ultra Wide Input (See Table) PI Type 20 mA pk-pk 20mS, typ. Output Specifications Voltage Accuracy Adjustability (Trim) (Only Single-out Models) Short Circuit Protection Over Current Protection Line Regulation Load Regulation (0% - 100%) Cross Regulation² (dual output) Ripple and Noise (20Mhz bandwidth) Temperature Coefficient Transient Recovery Time3 Transient Response Deviation3 ± 1% ± 10%, max Indefinite (hiccup; Automatic Recovery) 120% of FL, typ. ± 0.5% ± 0.5% (Single-out) ± 1.0% (Dual-out) ± 5% 75 mV pk-pk ± 0.02% / °C 250us, typ. ± 3%, max. General Specifications I/O Isolation Voltage (3 sec.) I/O Isolation Capacitance I/O Isolation Resistance Switching Frequency Humidity Reliability Calculated MTBF (MIL-HDBK-217F) 1500 VDC 1200 pF, typ. 1000 MOhm 330 kHz, typ. 95% rel H > 560 khrs Physical Specifications Case Material Potting Material Weight Nickel Coated Copper Epoxy (UL94V-0 rated) ~ 30g, typ. Environment Specifications Operating Temperature Maximum Case Temperature Storage Temperature Cooling RoHS Conform -40 to +66°C (ambient) 105°C -40 to +125°C Free Air Convection Soldering 260°C, max. (1.5mm from case 10s.) PM9-Series – P48WG-xxxxE/Z4:1LF – Single and Dual Output – 2”x1” - Metal Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 1/4 Selection Guide Single and Dual Output Order # ) ) ) mA A) mA ad ( (mA ad (m 4 ad ( o ) o d L L a C ) o . in Lo ull uF) VD ll L DC ( ( M F o u V t t d ( e F N ) n n a g t t e urre urre olta r Lo y (% rren rren ltag cito enc ut V ut C ut C i t Vo t Cu put Cu a p p p c u u t t t p i f p p u u u In In In O O O Ef Ca SINGLE OUTPUT P48WG-243R3E4:1LF P48WG-2405E4:1LF P48WG-2412E4:1LF P48WG-2415E4:1LF P48WG-483R3E4:1LF P48WG-4805E4:1LF P48WG-4812E4:1LF P48WG-4815E4:1LF 9-36 9-36 9-36 9-36 18-75 18-75 18-75 18-75 50 50 22 22 30 30 15 15 879 957 980 968 440 473 484 484 3.3 5 12 15 3.3 5 12 15 0 0 0 0 0 0 0 0 5500 4000 1670 1330 5500 4000 1670 1330 89 91 89 89 89 91 89 89 10000 6800 1000 680 10000 6800 1000 680 DUAL OUTPUT P48WG-2405Z4:1LF P48WG-2412Z4:1LF P48WG-2415Z4:1LF P48WG-4805Z4:1LF P48WG-4812Z4:1LF P48WG-4815Z4:1LF 9-36 9-36 9-36 18-75 18-75 18-75 65 25 25 40 15 15 969 980 980 484 490 490 ±5 ± 12 ± 15 ±5 ± 12 ± 15 0 0 0 0 0 0 ± 2000 ± 835 ± 665 ± 2000 ± 835 ± 665 89 88 89 89 88 89 ± 2200 ± 470 ± 330 ± 2200 ± 470 ± 330 If you need other specifications, please enquire. Notes: PM9-Series – P48WG-xxxxE/Z4:1LF – Single and Dual Output – 2”x1” - Metal Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 2/4 Package / Pinning / Derating 10.16 (0.40) COM +Vout (if Dual) DIA. 1.00 (0.04) 15.24 (0.60) -Vout 3 20.32 (0.80) Modelcode Datecode Vin: Vout: Iout: 4 Bottom View 1 Vin + 25.40 (1.00) All dimensions are typical in millimeters (inches). - Pin diameter: 1.0 +/-0.05 (0.04 +/-0.002) - Pin pitch tolerance: +/-0.35 (+/-0.014) - Case tolerance +/-0.5 (+/-0.02) Specification may change without notice. 5 2 6 15.24 (0.60) 50.80 (2.00) PEAK - 10.16 10.16 2.54 (0.40) (0.40) (0.10) 2.54 (0.10) 5.08 (0.20) min. 10.16 5.08 10.16 (0.40) (0.20) (0.40) 2" x 1" – METAL CASE # 1 2 3 4 5 6 PIN CONNECTIONS SINGLE DUAL +Vin +Vin - Vin - Vin +Vout +Vout Trim Common - Vout - Vout Ctrl. Ctrl. PM9-Series – P48WG-xxxxE/Z4:1LF – Single and Dual Output – 2”x1” - Metal Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 3/4 App Notes 1 = Measured Input reflected ripple current with a simulated source inductance of 12uH. 2 = One load is 25% to 100% load, the other load is 100% load, the output voltage variable rate is within ±5%. 3 = Tested by nominal Vin and 25% load step change (75% - 50% - 25% of Io) 4 = Tested by minimal Vin and constant resistive load. 5 = Input filter components (C1, C2, L) are used to help meet conducted emissions requirement for the module. These components should be mounted as close as possible to the module; all leads should be minimized to decrease radiated noise. 6 = An external filter capacitor is required if the module has to meet EN61000-4-4 and EN61000-4-5 EMC SPECIFICATIONS Part # C1 / C2 L P48WG-24xx P48WG-48xx 1210, 2.2uF/100V 1210, 2.2uF/100V 12uH 12uH Rtrim-up Radiated Emissions Conducted 5 Emissions ESD RS 6 EFT 6 Surge CS PFMF EN 55022 CLASS A EN 55022 CLASS A EN 61000-4-2 EN 61000-4-3 EN 61000-4-4 EN 61000-4-5 EN 61000-4-6 EN 61000-4-8 Perf. Criteria B Perf. Criteria A Perf. Criteria B Perf. Criteria B Perf. Criteria A Perf. Criteria A Rtrim-down 4 3 5 4 External Output Trimming Output can be externally trimmed. (Single output models only!) Over Voltage Protection (Zender diode clamp) Under Input Voltage Lockout (typ.) 3.3 Vout: 3.9 V 24 Vin Models Module ON/OFF 8.6V / 7.9V 5 Vout 6.2 V 48 Vin Models Module ON/OFF 17.8V / 16V 12 Vout 15 V Remote ON/OFF Control 15 Vout 18 V ± 5 Vout ± 6.2 V ON: ± 12 Vout ± 15 V OFF: ± 15 Vout ± 18 V OFF idle current: 3 -12 VDC or open circuit 0 – 1.2 VDC or short circuit PIN2 and PIN6 5mA, typ. Notes: PM9-Series – P48WG-xxxxE/Z4:1LF – Single and Dual Output – 2”x1” - Metal Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 4/4