IDT 3CN

CrystalFree™ Oscillators
3CN
Ultra Low Power Oscillators
Features







Frequency Range:
Output Type:
Frequency Tolerance:
Supply Voltage:
Power Consumption:
Standby Current:
Standard Package:
 Operating Temperature:
PRELIMINARY DATA SHEET
4 to 133 MHz
CMOS
± 100 ppm
1.8 to 3.3 V
1.9 mA (1.8 V)
< 1 uA
5.0 x 3.2 x 0.85 mm
2.5 x 2.0 x 0.85 mm
0 to 70 °C, -20 to 70 °C
This product is rated “Green”, please contact
factory for environmental compliancy information
Specification
Parameter
Supply Voltage
Frequency Stability
Supply Current
Quiescent Current
Input LOW/HIGH level
Output LOW/HIGH level
Rise/Fall Time
Symmetry
Start-up time
Period Jitter
Cycle to Cycle Jitter
Symbol
Specifications
VDD 1.8 V± 10% 2.5 V±10% 3.3 V±10%
FSTB
± 100 ppm
IDD
1.9 mA
2.0 mA
2.2 mA
ISTBY
1 uA
VIL/VIH
0.3 VDD (max) /0.7 VDD (min)
VOL
0.1 VDD (max) / 0.9 VDD (min)
TR /TF
1.6 ns
1.2 ns
1.0 ns
45% / 55%
SYM
40% / 60%
TST
400 us (max)
PJRMS
17 ps
6 ps
5 ps
CCJMAX
120 ps
50 ps
40 ps
Output Frequency
Conditions
Nominal ± tolerance
Total Frequency Stability*
Typical; No load condition; 75 MHz
Maximum; STBY# = GND
At STBY# pin
IOL = - 1 mA / IOH = 1 mA
Maximum; 20% to 80% x VDD; Output load (CL) = 4 pF
Worst case; output frequencies ≤ 100 MHz
Worst case; output frequencies > 100 MHz
Output valid time after VDD meets the specified range & STBY# transition
Output load (CL) = 4 pF; 75 MHz
Output load (CL) = 4 pF; 75 MHz; measured over 12 K cycles
4
4.096
5
6
15
16
18.432
19.44
36
37.5
40
48
75
80
98.304
100
Contact IDT for additional frequencies
FOUT
6.144
20
49.152
125
7.3728
22.5972
50
133
8
24
60
10
24.576
62.5
12
25
66
12.5
30
66.66
12.288
33
72
14.31818
33.333
74.25
Note: Above specifications are typical at room temperature (25°C ) unless otherwise specified.
* Inclusive of initial frequency accuracy, operating temperature range, supply variation, load variation, 3 times solder reflow, shock, vibration and 5 years aging at 25°C.
Package Outline and Dimensions
Typical PCB Land Pattern
Pin #1 ID
Chamfer
0.5 x 45°
1.00 ±0.05
3.20 ±0.1
0.85
1.20 ±0.05
5.0 xx 3.2
5.0
3.2
2.2
0.0-0.05
STBY#
4L SMD
5.0 x 3.2mm
5.00 ±0.1
2.54 bsc
Top View
2.5 x 2.0
0.65 ±0.05
Pin #1 ID
Chamfer
0.35 x 45°
Side View
1.4
1.5
0.0-0.05
0.85 ±0.05
STBY#
4L SMD
2.5 x 2.0mm
2.5 ±0.05
1.35 Bsc
1.62 Bsc
VDD
0.20 REF
1.8
(mm)
0.20 Ref.
Bottom View
0.72 ±0.05
OUT
1.6
GND
0.15
2.0 ±0.05
VDD
2.5
(mm)
(mm)
0.85 ±0.05
OUT
0.9
GND
0.5
Top View
Oct 24, 2011
Bottom View
www.IDT.com
Side View
0.8
©2011 Integrated Device Technology, Inc
3CN Datasheet
CrystalFree™ Oscillator
4.6 V
-0.5 V to VDD + 0.5 V
-0.5 V to VDD + 0.5 V
-65°C to 150°C
Name
1
2
3
4
STBY#
GND
OUT2
VDD
217°C
200
150°C
100
60-150
sec
60-180
sec
ax
150
50
Time
Output Waveform
Pin Descriptions
Pin #
(260°C max)
cm
VDD
STBY#
OUT
Storage Temperature
250
3°
C/
se
Maximum Absolute Rating
40 sec (max)
245°C
ma x
Item
Solder Reflow Profile
/sec
6°C
Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. These ratings are
stress specifications only. Functional operation of product at
these or under any condition beyond those listed in the
operating specifications is not implied. Exposure to absolute
maximum rated conditions may affect product reliability.
Temperature (°C)
Absolute Maximum Ratings
TR
Description
TF
VOH
1
Standby Mode (0 = Output Disabled)
Ground
CMOS Output
Power
0.8 VDD
0.5 VDD
1. Pulled high internally
2. Weak pull down to GND during STBY# enable and startup
0.2 VDD
VOL
SYM = t1 / t2
t1
t2
Ordering Information
3CN11G
4.09600
22.5792
133.000
E
NSG
Package
8
Suffix
NSG
Frequency
4 to 133MHz*
Package
NSG: 5.0 x 3.2 x 0.85
CVG: 2.5 x 2.0 x 0.85
C:
E:
Temp
0 to 70°C
-20 to 70°C
Shipping
Blank: Tubes
8:
Tape and Reel
CVG
Minimum Order Quantity (MOQ)
T&R
Bulk
Factory Order Increment (FOI)
T&R
Bulk
2500
1260 (18 Tubes)
2500
1260 (18 Tubes)
3000
1250 (Canister)
3000
1250 (Canister)
* See frequency table or contact IDT
6024 Silver Creek Valley Road
San Jose, California 95138
Sales
800-345-7015 (inside USA)
+1 408-284-8200 (outside USA)
Fax: 408-284-2775
Technical Support
[email protected]
+1 408-360-5656
DISCLAIMER Integrated Device Technology, Inc. (IDT) and its subsidiaries reserve the right to modify the products and/or specifications described herein at any time and at IDT’s sole discretion. All information in this document,
including descriptions of product features and performance, is subject to change without notice. Performance specifications and the operating parameters of the described products are determined in the independent state and are not
guaranteed to perform the same way when installed in customer products. The information contained herein is provided without representation or warranty of any kind, whether express or implied, including, but not limited to, the
suitability of IDT’s products for any particular purpose, an implied warranty of merchantability, or non-infringement of the intellectual property rights of others. This document is presented only as a guide and does not convey any
license under intellectual property rights of IDT or any third parties.
IDT’s products are not intended for use in life support systems or similar devices where the failure or malfunction of an IDT product can be reasonably expected to significantly affect the health or safety of users. Anyone using an
IDT product in such a manner does so at their own risk, absent an express, written agreement by IDT.
Integrated Device Technology, IDT and the IDT logo are registered trademarks of IDT. Other trademarks and service marks used herein, including protected names, logos and designs, are the property of IDT or their respective
third party owners.
Copyright 2010, 2011. All rights reserved.
Oct 24, 2011
www.IDT.com
©2011 Integrated Device Technology, Inc