40W DC-DC Converter P40A-Series ● ● ● ● ● ● ● ● Offer single, dual and triple output 40 W Output power 2:1 Wide input voltage range International safety standard approval Six-Sided continuous shield High efficiency up to 90% Standard 2" X 2" X 0.4" package Fixed switching frequency Model selection guide Typ Single output P40A24S3P3 P40A24S05 P40A24S12 P40A24S15 P40A48S3P3 P40A48S05 P40A48S12 P40A48S15 Dual output P40A24D3305 P40A48D3305 Triple output P40A24T3312 P40A24T3315 P40A24T0512 P40A24T0515 P40A48T3312 P40A48T3315 P40A48T0512 P40A48T0515 Input nominal voltage current full load Output 1 voltage current capacitor load max. [VDC] Output 2 (or Dual Output) voltage current capacitor load max. [mA] [VDC] [A] [µF] 18-36 18-36 18-36 18-36 36-75 36-75 36-75 36-75 1325 1961 2048 1985 655 969 1000 992 3.3 5.0 12.0 15.0 3.3 5.0 12.0 15.0 8.0 8.0 3.3 2.6 8.0 8.0 3.3 2.6 21000 13600 2360 1510 21000 13600 2360 1510 18-36 36-75 1729 854 3.3 3.3 4.0 4.0 11000 11000 5.0 5.0 4.0 4.0 6800 6800 84 85 18-36 18-36 18-36 18-36 36-75 36-75 36-75 36-75 1512 1481 1989 1958 747 732 982 967 3.3 3.3 5.0 5.0 3.3 3.3 5.0 5.0 6.0 6.0 6.0 6.0 6.0 6.0 6.0 6.0 13000 13000 6800 6800 13000 13000 6800 6800 ±12.0 ±15.0 ±12.0 ±15.0 ±12.0 ±15.0 ±12.0 ±15.0 ±0.4 ±0.3 ±0.4 ±0.3 ±0.4 ±0.3 ±0.4 ±0.3 2 x 330 2 x 110 2 x 330 2 x 110 2 x 330 2 x 110 2 x 330 2 x 110 85 85 87 87 86 86 88 88 [VDC] [A] [µF] Efficiency typ. Output ripple & Noise [%] [mVp-p] 87 89 88 89 88 90 89 89 50 50 75 75 50 50 75 75 100 @1µF 100 @1µF 75 75 75 75 75 75 75 75 Derating Page 1 of 2 Deutschland: Inselkammerstraße 10 D-82008 Unterhaching Tel.: 089 614 503-10 E-Mail: [email protected] Schweiz: Gründenstraße 82 CH-8247 Flurlingen Tel.: 052 647 42 00 E-Mail: [email protected] 40W DC-DC Converter P40A-Series Specifications Input Voltage range Filter (see note 1) Under voltage lockout 24V Input model General Efficiency Switching frequency Environmental Operating temperature 18-36, 36-75VDC L-C type DC-DC On max. 17.8 VDC DC-DC Off min. 16 VDC DC-DC On max. 36 VDC DC-DC Off min. 34 VDC 48V Input model Output Output Power Voltage accuracy full load and nominal Vin Temperature coefficient Minimum load 2 x 2 inches 50.8 x 50.8 x 10.2 mm 60 g Nickel-coated copper Weight Case material Isolation Rated voltage Resistance Capacitance Remote control Remote control on Remote control off Pin: CTRL See table measured with CL 104pF Hiccup, automatics recovery Single/Dual: ±0.5% Triple main: ±1% Triple auxiliary: ±5% single: ± 0.5% dual: ±1% Triple Main: ±2% Triple Auxiliary: ±5% ± 0.02% / °C, max Single: and Dual: 0% Triple: 10% of full load Load voltage regulation -40°C to +85°C (with derating) -55 °C to +105 °C +100 °C 5% to 95% Free-air convection Storage temperature range Maximum case temp. Relative humidity Cooling Physical Dimensions 40 W max. Single / Dual: ±1% Triple main: ±1% Auxiliary ±3% Single output only ±10% Voltage adjustability (see note 2) Ripple and noise (at 20 MHz BW) Short circuit protection Line voltage regulation LL to HL at Full Load See table 300 kHz, typ. 1600 VDC, min 9 10 Ω, min. 1000pF, max Open 3.5V < Vr < 12V Short or 0V < Vr < 1.2V (referenced to – Input) Note1: An external filter capacitor is required for normal operation. The capacitor should be capable of handing 1A ripple current for 24V and 48V models. Example: 220µF/ 100V, ESR <90mΩ. Note2: Maximum output deviation is 10% inclusive of remote sense and trim. If remote sense is not being used, the +SENSE should be connected to its corresponding +OUTPUT and likewise the sense should be connected to its corresponding -OUTPUT. Pin connections 1 2 3 4 5 6 7 8 9 2.00 (50.8) Triple + Input - Input CTRL + AUX Common - AUX + Output - Output (COM) NC Trimming 1.15 (29.2) 0.40 (10.2) 3 Output can be externally trimmed by using the method shown below. 8 0.40 (10.2) 0.20 (5.1) 2 1 BOTTOM VIEW 9 8 7 6 5 4 0.10 (2.5) TRIM UP 0.22 (5.6) 0.30 (7.6) 9 7 DIA. 0.04 1.80 (45.7) Single + Input - Input CTRL NC - Sense (note 2) +Sense (note 2) + Output - Output TRIM Dimensions Standard Dual + Input - Input CTRL 3.3 V 3.3V RTN (COM) NC NC 5V 5V RTN (COM) 2.00 (50.8) Pin 0.60 (15.2) TRIM DOWN 0.80 (20.3) Life Support Policy: HY-LINE does not authorize the use of any of its products for use in life support devices or systems without the express written approval of an officer of the Company. Life support systems are devices which support or sustain life, and whose failure to perform, when properly used in accordance with instructions for use provided in the labeling, can be reasonably expected to result in significant injury to the user. Rev: 11 / 2004 f 0.20 (5.1) 0.50 (12.7) 1. All dimensions in Inches (mm) 2. Pin pitch tolerance ±0.014(0.35) Page 2 of 2 Deutschland: Inselkammerstraße 10 D-82008 Unterhaching Tel.: 089 614 503-10 E-Mail: [email protected] Schweiz: Gründenstraße 82 CH-8247 Flurlingen Tel.: 052 647 42 00 E-Mail: [email protected]