Plastic Packages for Integrated Circuits Package Outline Drawing L32.5x5D 32 LEAD QUAD FLAT NO-LEAD PLASTIC PACKAGE Rev 1, 3/10 4X 3.5 5.00 28X 0.50 A B 25 6 PIN 1 INDEX AREA 6 PIN #1 INDEX AREA 32 1 5.00 24 3 .50 EXP. DAP 17 (4X) 0.15 8 16 TOP VIEW 9 32X 0.40 ± 0.10 4 32X 0.23 0.10 M C A B BOTTOM VIEW SEE DETAIL "X" 0.10 C MAX 0.90 ( 4. 80 TYP ) ( SEATING PLANE 0.08 C C SIDE VIEW ( 28X 0 . 5 ) 3.50 ) (32X 0 . 23 ) C 0 . 2 REF 5 0 . 00 MIN. 0 . 05 MAX. ( 32X 0 . 60) TYPICAL RECOMMENDED LAND PATTERN DETAIL "X" NOTES: 1. Dimensions are in millimeters. Dimensions in ( ) for Reference Only. 2. Dimensioning and tolerancing conform to ASME Y14.5m-1994. 3. Unless otherwise specified, tolerance : Decimal ± 0.05 4. Dimension applies to the metallized terminal and is measured between 0.15mm and 0.30mm from the terminal tip. 5. Tiebar shown (if present) is a non-functional feature. 6. The configuration of the pin #1 identifier is optional, but must be located within the zone indicated. The pin #1 identifier may be either a mold or mark feature. 1