Plastic Packages for Integrated Circuits Package Outline Drawing L32.5x5C 32 LEAD THIN QUAD FLAT NO-LEAD PLASTIC PACKAGE Rev 0, 09/08 3.50 5.00 28X 0.50 A B 6 6 PIN 1 INDEX AREA 24 1 3.50 5.00 3.10 Exp. DAP 8 17 (4X) PIN #1 INDEX AREA 32 25 0.15 32X 0.25 4 0.10 M C A B 9 16 3.10 Exp. DAP SIDE VIEW TOP VIEW 32X 0.40 BOTTOM VIEW SEE DETAIL "X" ( 4.80 ) ( 3.50) 0.10 C Max 0.80 ( 28X 0.50) C SEATING PLANE 0.08 C SIDE VIEW ( 4.80 ) ( 3.10 sq) ( 3.50) (32X .25) C 0 . 2 REF 5 0 . 00 MIN. 0 . 05 MAX. ( 32 X 0.60) DETAIL "X" TYPICAL RECOMMENDED LAND PATTERN NOTES: 1. Dimensions are in millimeters. Dimensions in ( ) for Reference Only. 2. Dimensioning and tolerancing conform to AMSE Y14.5m-1994. 3. Unless otherwise specified, tolerance : Decimal ± 0.05 4. Dimension b applies to the metallized terminal and is measured between 0.15mm and 0.30mm from the terminal tip. 5. Tiebar shown (if present) is a non-functional feature. 6. The configuration of the pin #1 identifier is optional, but must be located within the zone indicated. The pin #1 indentifier may be either a mold or mark feature. 1