Plastic Packages for Integrated Circuits Package Outline Drawing L48.7x7W 48 LEAD QUAD FLAT NO-LEAD PLASTIC PACKAGE Rev 0, 8/12 2X A 0.10 C A 7.00 2X 37 0.10 C B 6 44x0.50 1 36 PIN 1 INDEX AREA 6 PIN #1 INDEX AREA 48 7.00 4x 5.65 12 25 13 24 B 48x0.40 ±0.05 b 0.25 ±0.05 4 0.10 M C A B BOTTOM VIEW TOP VIEW PACKAGE OUTLINE SEE DETAIL "X" 0.10 C C BASE PLANE SEATING PLANE 0.05 C 0.85±0.05 (44x0.50) 6.80 Sq 5.65 Sq SIDE VIEW (48x0.25) C 0.2 REF 5 0.00 MIN. 0.05 MAX. (48x0.60) DETAIL "X" TYPICAL RECOMMENDED LAND PATTERN NOTES: 1. Dimensions are in millimeters. Dimensions in ( ) for Reference Only. 2. Dimensioning and tolerancing conform to ASME Y14.5m-1994. 3. Unless otherwise specified, tolerance : Decimal ± 0.05 4. Dimension applies to the metallized terminal and is measured between 0.20mm and 0.25mm from the terminal tip. 5. Tiebar shown (if present) is a non-functional feature. 6. The configuration of the pin #1 identifier is optional, but must be located within the zone indicated. The pin #1 identifier may be either a mold or mark feature. 1