Plastic Packages for Integrated Circuits Package Outline Drawing L48.7x7V 48 LEAD QUAD FLAT NO-LEAD PLASTIC PACKAGE (PUNCH QFN WITH WETABLE FLANK) Rev 3, 12/15 2X A 0.10 C A 7.00 6.75 N 0.10 M C A B 4X 0.42±0.18 2X 4.70 PIN #1 ID 0.20 R N 0.10 C B 4X 0.42±0.18 1 2 3 5 0.80 DIA. 1 2 3 0.45 6.75 0.10 M C A B 4.70 7.00 (0.75) C C 0.10 C B 2X B 0.10 C A TOP VIEW 0.25 0.10 M C A B 0.05 M C 0.50 0.40±0.10 0.15±0.10 (0.75) 2X BOTTOM VIEW 6 0.08 C 0.10 C 0.85 (44 x 0.50) 6.80 Sq 0.01 0.25 4 0.00 MIN/0.05 MAX 0.65 0.20 SECTION "C-C" SCALE: NONE 4.70 Sq 48 x 0.25 0.15 0.25 0.00 MIN/0.05 MAX (48 x 0.60) SEE DETAIL "A" TYPICAL RECOMMENDED LAND PATTERN 0.10 DETAIL "A" SCALE: NONE C NOTES: 1. Dimensions are in millimeters. Dimensions in ( ) for Reference Only. 2. Dimensioning and tolerancing conform to ASME Y14.5m-1994. 3. Unless otherwise specified, tolerance: Decimal ±0.05 4. Dimension applies to the metallized terminal and is measured between 0.20mm and 0.25mm from the terminal tip. 5. Tiebar shown (if present) is a non-functional feature. 6. The configuration of the pin #1 identifier is optional, but must be located within the zone indicated. The pin #1 identifier may be either a mold or mark feature. 1 SIDE VIEW SEATING PLANE