MN101C93 Series Type Internal ROM type MN101C93K MN101CF93K Mask ROM FLASH ROM (byte) 224K RAM (byte) 6K Package (Lead-free) Minimum Instruction Execution Time LQFP100-P-1414 0.125 µs (at 3.0 V to 3.6 V, 8 MHz) 62.5 µs (at 3.0 V to 3.6 V, 32 kHz) 0.167 µs (at 3.0 V to 3.6 V, 6 MHz) 62.5 µs (at 3.0 V to 3.6 V, 32 kHz) Interrupts RESET. Watchdog. External 0 to 5. External 6 (key interrupt dedicated). Timer 0 to 3. Timer 6. Timer 7 (2 systems). Timer 8 (2 systems). Time base. Serial 0 (2 systems). Serial 1 (2 systems). Serial 3 (1 systems). A/D conversion finish. Automatic transfer finish. USB interrupts Timer Counter 8-bit timer × 5 Timer 0 ..................Square-wave/8-bit PWM output. Event count. Remote control carrier output. Simple pulse width measurement. Added pulse (2-bit) type PWM output. Square-wave/PWM output to large current terminal PC3 possible Timer 1 ..................Square-wave output. Event count. Serial transfer clock output. Synchronous output event Timer 2 ..................Square-wave output. Added pulse (2-bit) type PWM output. PWM output. Serial transfer clock output. Event count. Synchronous output event. Simple pulse width measurement. Square-wave/PWM output to large current terminal PC5 possible Timer 3 ..................Square-wave output. Event count. Serial transfer clock output Timer 6 ..................8-bit freerun timer Timer 0, 1 can be cascade-connected Timer 2, 3 can be cascade-connected 16-bit timer × 2 Timer 7 ..................Square-wave output. 16-bit PWM output (cycle/duty continuous variable). Event count. Synchronous output event. Pulse width measurement. Input capture. Real time output control. High performance IGBT output. Squarewave/PWM output to large current terminal PC4 possible Timer 8 ..................Square-wave/16-bit PWM output (duty continuous variable). Event count. Pulse width measurement. Input capture. Square-wave/PWM output to large current terminal PC6 possible Timer 7, 8 can be cascade-connected: Square-wave output, PWM is possible as a 32-bit timer Time base timer: One-minute count setting Watchdog timer × 1 Serial interface Synchronous type/UART (full-duplex) × 2: Serial 0, 1 Synchronous type/Single-master I2C × 1: Serial 3 DMA controller Maximum transfer cycles: 255 Starting factor: External request. Various types of interrupt. Software Transfer mode: 1-byte transfer. Word transfer. Burst transfer USB Functions Conforms to USB 1.1: Full-speed (12 Mbps) supported USB transceiver built-in. 5 end points (FIFO built-in independently) FIFO size: EP0 = 16 bytes. EP1 = 128 bytes. EP2 = 128 bytes. EP3 = 64 bytes. EP4 = 64 bytes EP0: Control transfer. IN/OUT (two ways) EP1 to EP4: Interrupt/Bulk/Isochronous transfer supported. Settable to IN or OUT. Double Buffering function supported When the MAXP size is set to a half or less of the MAXFIFO size for each EP, the Double Buffering function is made valid automatically I/O Pins I/O 84 : Common use. Specified pull-up resistor available. Input/output selectable (bit unit) A/D converter 10-bit × 12 channels (with S/H) MAD00056GEM MN101C93K, MN101CF93K Display control function LCD: 47 segments × 4 commons (Static, 1/2, 1/3, or 1/4 duty) LCD power supply separated from VDD (usable if VDD = VLCD ≤ 3.6 V) LCD power shunt resistance contained Special Ports USB ports (D+, D–). Buzzer output. Inverted buzzer output. Remote control carrier output. High-current drive port. Clock output Pin Assignment 75 74 73 72 71 70 69 68 67 66 65 64 63 62 61 60 59 58 57 56 55 54 53 52 51 P56, SEG25, A6 P55, SEG26, A5 P54, SEG27, A4 P53, SEG28, A3 P52, SEG29, A2 P51, SEG30, A1 P50, SEG31, A0 P47, SEG32, D7, KEY7, SDO7 P46, SEG33, D6, KEY6, SDO6 P45, SEG34, D5, KEY5, SDO5 P44, SEG35, D4, KEY4, SDO4 P43, SEG36, D3, KEY3, SDO3 P42, SEG37, D2, KEY2, SDO2 P41, SEG38, D1, KEY1, SDO1 P40, SEG39, D0, KEY0, SDO0 P06, SEG40, NRE P05, SEG41, NWE P04, SEG42, NCS, SBI3 P03, SEG43, NDK, SBO3, SDA3 P02, SEG44, SYSCLK, SBT3, SCL3 P01, SEG45, NBUZZER P00, SEG46, BUZZER P25, IRQ5 P24, IRQ4 P23, IRQ3 LQFP100-P-1414 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 COM0, P90 COM1, P91 COM2, P92 COM3, P93 VLC3, P94 VLC2 VLC1 N.C. RXD0B, SBI0B, LED0, PC0 TXD0B, SBO0B, LED1, PC1 SBT0B, LED2, PC2 TM0O, LED3, PC3 TM7O, LED4, PC4 TM2O, LED5, PC5 TM8O, LED6, PC6 VSS OSC1 OSC2 VDD XI XO MMOD NRST, P27 DMOD VREF+ 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 P57, SEG24, A7 P60, SEG23, A8 P61, SEG22, A9 P62, SEG21, A10 P63, SEG20, A11 P64, SEG19, A12 P65, SEG18, A13 P66, SEG17, A14 P67, SEG16, A15 P70, SEG15, A16 P71, SEG14, A17 P72, SEG13 P73, SEG12 P74, SEG11 P75, SEG10 P76, SEG9 P77, SEG8 P80, SEG7 P81, SEG6 P82, SEG5 P83, SEG4 P84, SEG3 P85, SEG2 P86, SEG1 P87, SEG0 MAD00056GEM 50 49 48 47 46 45 44 43 42 41 40 39 38 37 36 35 34 33 32 31 30 29 28 27 26 IRQ2, P22 IRQ1, P21 IRQ0, P20 TM8IO, P15 TM7IO, P14 TM3IO, P13 TM2IO, P12 TM1IO, P11 RMOUT, TM0IO, P10 RXD1, SBI1, AN11, PB7 TXD1, SBO1, AN10, PB6 SBT1, AN9, PB5 RXD0A, SBI0A, AN8, PB4 TXD0A, SBO0A, AN7, PB3 SBT0A, AN6, PB2 VSS DD+ VDD AN5, PA5 AN4, PA4 AN3, PA3 AN2, PA2 AN1, PA1 AN0, PA0 Request for your special attention and precautions in using the technical information and semiconductors described in this book (1) If any of the products or technical information described in this book is to be exported or provided to non-residents, the laws and regulations of the exporting country, especially, those with regard to security export control, must be observed. (2) The technical information described in this book is intended only to show the main characteristics and application circuit examples of the products. No license is granted in and to any intellectual property right or other right owned by Panasonic Corporation or any other company. Therefore, no responsibility is assumed by our company as to the infringement upon any such right owned by any other company which may arise as a result of the use of technical information described in this book. (3) The products described in this book are intended to be used for standard applications or general electronic equipment (such as office equipment, communications equipment, measuring instruments and household appliances). Consult our sales staff in advance for information on the following applications: – Special applications (such as for airplanes, aerospace, automobiles, traffic control equipment, combustion equipment, life support systems and safety devices) in which exceptional quality and reliability are required, or if the failure or malfunction of the products may directly jeopardize life or harm the human body. – Any applications other than the standard applications intended. (4) The products and product specifications described in this book are subject to change without notice for modification and/or improvement. At the final stage of your design, purchasing, or use of the products, therefore, ask for the most up-to-date Product Standards in advance to make sure that the latest specifications satisfy your requirements. (5) When designing your equipment, comply with the range of absolute maximum rating and the guaranteed operating conditions (operating power supply voltage and operating environment etc.). Especially, please be careful not to exceed the range of absolute maximum rating on the transient state, such as power-on, power-off and mode-switching. Otherwise, we will not be liable for any defect which may arise later in your equipment. Even when the products are used within the guaranteed values, take into the consideration of incidence of break down and failure mode, possible to occur to semiconductor products. Measures on the systems such as redundant design, arresting the spread of fire or preventing glitch are recommended in order to prevent physical injury, fire, social damages, for example, by using the products. (6) Comply with the instructions for use in order to prevent breakdown and characteristics change due to external factors (ESD, EOS, thermal stress and mechanical stress) at the time of handling, mounting or at customer's process. When using products for which damp-proof packing is required, satisfy the conditions, such as shelf life and the elapsed time since first opening the packages. (7) This book may be not reprinted or reproduced whether wholly or partially, without the prior written permission of our company. 20080805