Test Procedure for the NCP3063 (SOIC-8) Boost Evaluation Board Figure 1Test Setup Table 1 Required Equipment Voltage Supply (12V, 3A) Voltage Meter Electronic Load or Current Source Test Procedure: 1. Connect the test setup as shown in Figure 1 2. Apply an input voltage, Vcc = 12V 3. Apply Iout = 0A load 4. Check that Vout is 24V (23.9V-24.1V) 5. Increase Iout load to 350mA 6. Check that Vout is 24V (23.9V-24.1V) 7. Power down the load 8. Power down Vcc 9. End of test 3/13/2008 -1- www.onsemi.com