Data Sheet No. PD10056 revE Series PVR33N & PbF Microelectronic Power IC HEXFET® Power MOSFET Photovoltaic Relay Dual-Pole, Normally-Open 0-300V AC/DC, 165mA General Description The PVR33 Series AC/DC Relay is a dual-pole, normally open, solid-state replacement for electromechanical relays used for general purpose switching of analog signals. It utilizes International Rectifier’s HEXFET power MOSFETs as the output switches, driven by an integrated circuit photovoltaic generator of novel construction. The output switch is controlled by radiation from a GaAlAs light emitting diode (LED), which is optically isolated from the photovoltaic generator. The PVR33 Series overcomes the limitations of both conventional electromechanical and reed relays by offering the solid state advantages of long life, fast operating speed, low pick up power, bounce-free operation, low thermal offset voltages and miniature package. These advantages allow product improvement and design innovations in many applications such as process control, multiplexing, automatic test equipment and data acquisition. The PVR33 can switch analog signals from thermocouple level to 300 Volts peak AC or DC polarity. Signal frequencies into the RF range are easily controlled and switching rates up to 350Hz are achievable. The extremely small thermally generated offset voltages allow increased measurement accuracies. These relays are packaged in 16-pin, molded DIP packages and available with thru-hole leads, in plastic shipping tubes. Applications ! ! ! ! Features ! ! ! ! ! ! ! Bounce-Free Operation 1010 Off-State Resistance 1,000 V/µsec dv/dt 0.2 µV Thermal Offset 5 mA Input Sensitivity 1,500 VRMS I/O Isolation Solid-State Reliability Part Identification Process Control Data Acquisition Test Equipment Multiplexing and Scanning PVR2300N & PbF PVR3300N & PbF PVR3301N & PbF (HEXFET is the registered trademark for International Rectifier Power MOSFETs) www.irf.com 1 Series PVR33N & PbF Electrical Specifications (-40°C ≤ TA ≤ +85°C unless otherwise specified) INPUT CHARACTERISTICS Minimum Control Current A Connection (see figure 1) For 170 Continuous Load Current For 165 Continuous Load Current For 130 Continuous Load Current Minimum Turn-Off Current 0.6 V(DC) 2.0 to 25 mA(DC) 6.0 V(DC) PVR2300N PVR3300N, PVR3301N Units Control Current Range (Caution: current limit input LED. See figure 6) Maximum Reverse Voltage OUTPUT CHARACTERISTICS Operating Voltage Range Maxiumum Load Current 40°C ILED = 5mA (see figure 1) AC (A Connection) DC (B Connection) DC (C Connection) DC mA@25°C mA@40°C mA@85°C µA(DC) 2.0 5.0 5.0 10 Minimum Turn-Off Voltage Units ±200 ±300 V(peak) 165 180 310 mA (peak) mA(DC) mA(DC) Maximum T (on) @ 12mA Control, 100 mA Load, 100 VDC 150 µs Maximum T (off) @ 12mA Control, 100 mA Load, 100 VDC 125 µs 24 12 6 108 1010 Ω Ω Ω Ω Ω Response Time @25°C (see figures 7 and 8) Maximum On-state Resistance 25°C (Pulsed) (fig. 2) 50 mA Load, 5mA Control AC (A Connection) DC (B Connection) DC (C Connection) Minimum Off-state Resistance 25°C @ 160 VDC PVR2300, PVR3300 @ 240 VDC PVR3301 Maximum Thermal Offset Voltage @ 5.0mA Control Minimum Off-State dv/dt Typical Output Capacitance (see figure 9) 0.2 µvolts 1000 V/µs 6 pF @ 50VDC GENERAL CHARACTERISTICS Units Dielectric Strength: Input-Output 1500 VRMS Insulation Resistance: Input-Output @ 500VDC 12 10 Ω Maximum Capacitance: Input-Output 1.0 pF Maximum Lead Soldering Temperature (1.6mm below seating plane for 10 sec.) 260 °C Operating -40 to +85 °C Storage -40 to +100 Ambient Temperature Range: International Rectifier does not recommend the use of this product in aerospace, avionics, military or life support applications. Users of this International Rectifier product in such applications assume all risks of such use and indemnify International Rectifier against all damages resulting from such use. www.irf.com 2 Series PVR33N & PbF 4000 3000 C Connection 2500 B C o nne ctio n 2000 1500 1000 A Connection ILED = 5mA 500 00 0 20 40 60 80 100 Ambient Temperature (°C) Ambient Temperature (°C) Figure 1. Current Derating Curve Figure 2. Typical On-Resistance 700 300 600 25oC 40oC 60oC 85oC Pulsed, 25ºC 200 150 100 I LED = 5mA, Forced Air 50 Pulsed, 25ºC Load Current (mA) 250 Load Current (mA) 5 mA Control lD = 50 mA Rd(on) (Normalized to 25oC) Max. Load Current (mA) 3500 25oC 40oC 60oC 85oC 500 400 300 200 I LED = 5mA, Forced Air 100 A Connection C Connection 0 0 0.0 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 4.5 0.0 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 4.5 VDD (Volts) VDD (Volts) Figure 3. Typical On-Characteristic A Connection Figure 4. Typical On-Characteristic C Connection www.irf.com 3 IDOff/IDOff 25°C Input Current (mA) Series PVR33N & PbF LED Forward Voltage Drop (Volts DC) Ambient Temperature (°C) Figure 5. Typical Normalized Off-State Leakage Figure 6. Input Characteristics (Current Controlled) 1000 Delay Time (µS) Ton Tdly 100 Toff 10 0 5 10 15 20 ILED (mA) Figure 7.Typical Delay Times www.irf.com Figure 8. Delay Time Definitions 4 Series PVR33N & PbF 180 Typical Capacitance (pF) 160 140 120 100 80 60 C Connection 40 20 A Connection 0 0 10 20 30 40 50 VDD Drain-to-Drain Voltage Figure 9. Typical Output Capacitance Wiring Diagram www.irf.com Schematic Diagram 5 Series PVR33N & PbF Case Outline 01-2012 00 IR WORLD HEADQUARTERS: 233 Kansas St., El Segundo, California 90245 Tel: (310) 252-7105 Data and specifications subject to change without notice. 3/27/2006 www.irf.com 6