Telefon: +49 (0)6135 931069 Telefax: +49 (0)6135 931070 www.peak-electronics.de [email protected] PD10NG-XXXXE2:1 1KV ISOLATED 2W REGULATED SINGLE OUTPUT SIP8 Electrical Specifications (Typical at + 25℃ , nominal input voltage, rated output current unless otherwise specified) Input Specifions Voltage range Filter 4.5-9, 9-18, 18-36 and 36-72 VDC Wide lnput Capacitor type lsolation Specifications Rated voltage Resistance Capacitance 1000 VDC ＞1 GΩ 68 PF Output Specifications Voltage accuracy Ripple and noise (at 20 MHz BW) Short circuit protection Line voltage regulation Load voltage regulation Temperature coefficient +/−2 %, typ. 100 mV p-p, max. Continuous, auto restart +/−0.2 % typ. +/−0.5 % typ. load = 10 ~ 100% +/−0.02 % / ℃ General Specifications Efficiency Switching frequency Refer to the table 75 KHz, typ. Environmental Specifications Operating temperature (ambient) Storage temperature Humidity Cooling − 40 ℃ to + 80 ℃ − 55 ℃ to + 125 ℃ Up to 90 %, non condensing Free air convection Physical Characteristics Dimensions SIP Case material 21.80 x 9.20 x 11.10 mm Non conductive black plastic Samples of Partnumbers PART NO. PD10NG-053R3E2:1 PD10NG-0505E2:1 PD10NG-0509E2:1 PD10NG-0512E2:1 PD10NG-0515E2:1 PD10NG-0524E2:1 PD10NG-123R3E2:1 PD10NG-1205E2:1 PD10NG-1209E2:1 PD10NG-1212E2:1 PD10NG-1215E2:1 PD10NG-1224E2:1 PD10NG-243R3E2:1 PD10NG-2405E2:1 PD10NG-2409E2:1 PD10NG-2412E2:1 PD10NG-2415E2:1 PD10NG-2424E2:1 PD10NG-483R3E2:1 PD10NG-4805E2:1 PD10NG-4809E2:1 PD10NG-4812E2:1 PD10NG-4815E2:1 PD10NG-4824E2:1 INPUT VOLTAGE (VDC) INPUT CURRENT NO LOAD (mA) INPUT CURRENT FULL LOAD (mA) OUTPUT VOLTAGE (VDC) OUTPUT CURRENT (max.mA) EFFICIENCY FULL LOAD (% TYP.) 4.5 - 9 4.5 - 9 4.5 - 9 4.5 - 9 4.5 - 9 4.5 - 9 9 - 18 9 - 18 9 - 18 9 - 18 9 - 18 9 - 18 18 - 36 18 - 36 18 - 36 18 - 36 18 - 36 18 - 36 36 - 72 36 - 72 36 - 72 36 - 72 36 - 72 36 - 72 41 37 38 37 37 37 24 23 22 22 22 22 12 12 12 12 11 11 8 7 7 7 7 7 487 455 458 452 452 452 237 219 215 212 212 217 117 111 108 105 102 106 58 54 53 52 52 53 3,3 5 9 12 15 24 3,3 5 9 12 15 24 3,3 5 9 12 15 24 3,3 5 9 12 15 24 606 400 222 167 133 83 606 400 222 167 133 83 606 400 222 167 133 83 606 400 222 167 133 83 68 72 71 73 73 73 70 75 77 78 78 76 71 74 78 79 80 78 72 77 78 80 80 78 PD10NG-XXXXE2:1 1KV ISOLATED 2W REGULATED SINGLE OUTPUT SIP8 Dimensions 21,8 PEAK Modelcode 1 2 3 5 9,2 6 7 8 11,10 0.25± 0.05 3.20 typ. 0.50± 0.05 2.0± 0.50 3.10 typ. 0.50± 0.05 Recommended footprint details 2.54 typ. 2,54 XX.X± 0.5m/m XX.XX± 0.25m/m Unit : mm 1.0φ＋0.15 /－0 2,54 Derating Graph and Pinning Output Temperature Derating Graph Ambient Temperature C 2.00W Safe Operating Area Pin Connection # Single 1 − V Input 2 + V Input 3 Ctrl 4 Omitted 5 NE 6 + V Output 7 − V Output 8 －40 0 40 80 100 CS Control input can be left open (3) No external connection allowed (5) Optional external capacitor (8) PD10NG-XXXXE2:1 1KV ISOLATED 2W REGULATED SINGLE OUTPUT SIP8 External capacitance: Pin 3 (CTRL) These converters will work with without external capacitors but they are necessary in order to guarantee the full line load range. All parts have been tested using the following recommended values. Control pin (ON/OFF) Output starts at low or open and stops when high. Voltage applied via a limiting resistor and switching diode. The converter is in a low power mode during the high level phase. + Vout + Vin ＋ Cin Converter Connection example ＋ Cout - Vout - Vin Cin Cout 10uF/100V, low ESR. 100uF/35V, low ESR. MCU 1K 1N4148 CONVERTER Vcc-5V PIN 3 Pin 8 (CS) This pin provides a connection point to the main reservoir capacitor. Additional capacitance can be added from this to pin 7. Any low ESR capacitor will improve ripple and noise in some measure. Starting values can be in the range of 100uF. Pin 5 (NE) This pin is used internally and must have have no external connection. Application Notes Pin 3: The outside control connection. This pin provides the converter output ON/OFF, and the control common is referred to negative input. Pin 5: This pin belongs to the secondary side. It just avoids someone to reverses the primary and secondary. Pin 8: Max. 1000 uF Specification can be changed without notice. REV: 1 / 03.2003 Copyright PEAK electronics GmbH