VECTRON TFS238A

TFS 238a.doc
version 1.1
VI TELEFILTER
Preliminary Specification
10.04.2003
TFS 238 A
1/5
Measurement condition
Ambient temperature TA:
Input power level:
Terminating impedances at fc*:
25 °C
0 dBm
input:
1000
output:
670
// - 7,2 pF
// - 7,8 pF
Characteristics
Remark:
Reference level for the relative attenuation arel of the TFS 238A is the insertion loss. The minimum of the pass band attenuation amin is defined as
the insertion loss ae . The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 3 dB filter attenuation level
relative to the insertion loss ae. The temperature coefficient of frequency Tcf is valid both for the reference frequency fc and the frequency response
of the filter in the operating temperature range.
Data
typ. value
Insertion loss
ae
(reference level at ambient temperature)
9,5
Nominal frequency
fN
-
Centre frequency
fc
238,4
Passband Ripple (p-p)
fN
500 kHz
fN
.........
fN ± 0,5 MHz .........
fN ±
fN ±
fN
fN
fN
fN
fN
fN
fN
fN
0,9
1,25
4
4
MHz
MHz
MHz
MHz
.........
.........
.........
.........
Phase variation within fN
dB
min.
max.
8,9 dB
10,9 dB
238,4 MHz
MHz
-
0,4
dB
max.
1
dB
0,4
1
dB
dB
max.
max.
1
5
dB
dB
dB
dB
dB
dB
min.
min.
min.
min.
20
30
47
47
dB
dB
dB
dB
deg rms
max.
4
dB
min.
20
dB
- 20 °C.... + 85
°C
- 55 °C.... + 125
C
arel
Relative attenuation
±
±
+
tolerance / limit
0,5
MHz
0,615 MHz
±
1,25
±
4
- 228,4
+ 111,6
MHz
MHz
MHz
MHz
630 kHz
25
35
55
60
1,2
27
Triple transit response suppression
-
Operating temperature range
-
Storage temperature range
Temperature coefficient of frequency
TCf ***
-0,036 ppm/K
Frequency inversion temperature
T0
35
Input power
-
2
deg rms
-
°C
max.
20
dBm **
*) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as
reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team.
**) This power level is allowed for short term operation (10% of life time) only, the max. input power for continuous operation is 15 dBm
***) f(Hz) = TCf(ppm/K²) x (T-T0)² x fTo(MHz)
generated:
checked / approved:
TELEFILTER GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as
a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information
TFS 238a.doc
version 1.1
VI TELEFILTER
Preliminary Specification
Construction, pin configuration and 50
10.04.2003
TFS 238 A
2/5
- matching network
(all dimensions in mm)
15,32 ±0,20
10 9
8
7
6
TFS 238 A
R16
1
2
3
4
date code
6,50 ±0,20
5
2,0Max.
1,0 0,2
1
1
2
3
4
5
6
7
8
9
10
output
ground
ground
ground
input rf return
input
ground
ground
ground
output rf return
date code: year + week
N
2001
P
2002
R
2003
......
120°
1,9 0,2
1,91
7,62
50
0,2
0,2
test circuit
L1
Input
50 Ohm
6
1
L2
Output
50 Ohm
SAW
C1
C2
2,3,4,5,7,8,9,10
TELEFILTER GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as
a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information
TFS 238a.doc
version 1.1
VI TELEFILTER
Preliminary Specification
10.04.2003
TFS 238 A
3/5
Stability characteristics
After the following tests the filter shall meet the whole specification:
1. Shock:
500g, 18 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
2. Vibration:
10 Hz to 500 Hz, 0,35 mm or 5g respectively, 1 octave per min, 10 cycles per plan, 3 plans;
DIN IEC 68 T2 - 6
3. Change of
temperature:
-55 °C to 125°C / 30 min. each / 10 cycles
DIN IEC 68 part 2 – 14 Test N
4. Resistance to
solder heat (reflow):
reflow possible: twice max.;
for temperature conditions, please refer to the attached "Air reflow temperature conditions" on page 4;
Packing
Tape & Reel:
DIN IEC 286 – 3, with exception of value for N and minimum bending radius;
tape type II, embossed carrier tape with top cover tape on the upper side;
max. pieces of filters per reel:
reel of empty components at start:
reel of empty components at start including leader:
trailer
Tape (all dimensions in mm)
W
:
24
± 0,3
Po
:
4
± 0,1
Do
E
:
:
1,5 + 0,1
1,75 ± 0,1
F
:
11,5 ± 0,1
G (min) :
2000
min 300 mm
min 500 mm
min 300 mm
EMBOSSED CARRIER TAPE
Do
Po
P2
E
Ao
0,60
F
D1
P2
:
P1
:
D1(min) :
2
12
1,5
± 0,1
± 0,1
Ao
:
7,1
± 0,2
Bo
Ct
:
:
15,9
21,5
± 0,2
± 0,1
Ct
W
Bo
G
P1
COVER TAPE
W 2
Reel (all dimensions in mm):
A
:
330
W1
:
W2 (max) :
24,40 +2,0
30,4
N (min)
:
60
C
:
13
0,5/-0.2
A
C
N
W 1
The minimum bending radius is 45 mm. The mounting surface of the filters faces the bottom side of the embossed carrier tape.
Markings on the filters can be read if the upper side of the carrier tape is regarded with the sprocket holes on its right.
TELEFILTER GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as
a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information
TFS 238a.doc
version 1.1
VI TELEFILTER
Preliminary Specification
10.04.2003
TFS 238 A
4/5
Air reflow temperature conditions
1st and 2nd air reflow profile
pre-heating periods
150 °C - 170 °
Name:
Temperature:
Time:
main-heating periods
Cover 200 °C
60 sec. - 90 sec.
peak temperature
255 °C ± 5 °C
20 sec. - 25 sec.
Air reflow profile
260
240
220
200
temperature / °C
180
160
140
120
100
80
60
40
20
0
0
20
40
60
80
100
120
140
160
180
200
220
240
time / sec.
Table for temperature vs. time during the air reflow process
Tolerance of temperatures: ± 5 °C
time / sec.
0
10
20
30
40
50
60
70
80
90
100
110
120
130
temperature / °C
23
34
46
60
80
103
121
134
143
150
154
156
158
159
time / sec.
140
150
160
170
180
190
195
200
205
210
215
220
230
240
temperature / °C
160
161
164
170
180
205
230
255
230
205
180
165
140
120
TELEFILTER GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as
a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information
TFS 238a.doc
VI TELEFILTER
version 1.1
Preliminary Specification
10.04.2003
TFS 238 A
5/5
History
Version
Reason of Changes
Name
Date
1.0
generation of specification
Pfeiffer
10.02.2003
1.1
typical values of relative attenuation and terminating impedance (preliminary values) added
10.04.2003
Pfeiffer
TELEFILTER GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as
a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information