VECTRON TFS549A

Filename: tfs 549a.doc
Version 1.2
VI TELEFILTER
13.07.2004
Filter specification
TFS 549A
1/5
Measurement condition
Ambient temperature:
Input power level:
Terminating impedance: *
23
0
°C
dBm
for input:
for output:
956 Ω || -3,0 pF
718 Ω || -3,6 pF
Characteristics
Remark:
The reference level for the relative attenuation arel of TFS 549A is the minimum of the pass band attenuation amin. This value is defined as the insertion
loss ae. The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 1 dB filter attenuation level relative to the insertion
loss ae. The given values for the relative attenuation arel and the group delay ripple have to be reached at the frequencies given below, even if the centre
frequency fc is shifted due to the temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the
centre frequency fc.
Data
typ. value
Insertion loss
(reference level)
ae
13,8
-
Nominal frequency
fN
-
Passband
within PB
Pass band ripple
dB
max.
15
-
dB
549,5
MHz
± 2,5
MHz
-
fN
-
max.
0,5
dB
max.
1
dB
dB
arel
Relative attenuation
fN
tolerance / limit
MHz ... fN
±
2,5
MHz
0,5
dB
fN
±
4
MHz ... fN
±
MHz
8
dB
min.
3
fN
±
6,5
MHz ... fN
±
22
MHz
44
dB
min.
39
dB
fN
fN
+
548,5
22
MHz ... fN
MHz ... fN
+
22
451,5
MHz
MHz
55
54
dB
dB
min.
min.
50
50
dB
dB
600
ns
max.
800
ns
10
ns
max.
50
ns
deg
max.
dB
min.
6,5
Absolute group delay
Group delay ripple within PB
Phase linearity (p-p)
at any 2 MHz band width in PB
1,8
53
Triple transit response suppression
1,5:1
VSWR
Operating temperature range
OTR
Storage temperature range
Temperature coefficient of frequency
TCf **
30
-
- 10°C ... + 65°C
- 25°C ... + 75°C
-0,05
°C
ppm/K
deg
dB
2:1
28
Turn over temperature
max.
2,55
2
-
*) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference
values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team.
**) ∆f(Hz) = TCf(ppm/K²) x (T-T0)² x fTo(MHz)
Generated:
Checked / Approved:
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 549a.doc
Version 1.2
VI TELEFILTER
13.07.2004
Filter specification
TFS 549A
2/5
0
15.36
-10
-1
13.56
-20
-2
11.76
-30
-3
9.96
-4
8.16
-5
6.36
-6
4.56
-70
-7
2.76
-80
-8
0.96
-90
-9
-0.84
-40
-50
-60
-100
524.5 529.5 534.5 539.5 544.5 549.5 554.5 559.5 564.5 569.5 574.5
frequency in MHz
-10
-2.64
545.5 546.3 547.1 547.9 548.7 549.5 550.3 551.1 551.9 552.7 553.5
frequency in MHz
Construction and pin connection
(All dimensions in mm)
S 549A
●
S29
3
Date code
2 Max.
1
7,2 Max.
2,54 ± 0,2
1
1
2
3
4
5
6
7
8
9
10
11
12
Ground
Ground
Output RF Return
Output
Ground
Ground
Ground
Ground
Input RF Return
Input
Ground
Ground
Date code:
S
T
U
...
Year + week
2004
2005
2006
1
5,2 Max.
2,54 ± 0,2
phase in °
0
magnitude in dB
magnitude in dB
Filter characteristic
0,80
50 Ohm Test circuit
L1
C1
10
4
9
3
C2
L2
1, 2, 5, 6, 7, 8, 11, 12
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 549a.doc
Version 1.2
VI TELEFILTER
13.07.2004
Filter specification
TFS 549A
3/5
Stability characteristics
After the following tests the filter shall meet the whole specification:
1. Shock:
500g, 18 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
2. Vibration:
10 Hz to 500 Hz, 0,35 mm or g respectively, 1 octave per min, 10 cycles per plan, 3 plans;
DIN IEC 68 T2 - 6
3. Change of
temperature:
4. Resistance to
solder heat (reflow):
-55 °C to 125°C / 30 min. each / 10 cycles
DIN IEC 68 part 2 – 14 Test N
reflow possible: twice max.;
for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4;
Packing
Tape & Reel:
IEC 286 – 3, with exeption of value for N and minimum bending radius;
tape type II, embossed carrier tape with top cover tape on the upper side;
max. pieces of filters peer reel:
reel of empty components at start:
reel of empty components at start including leader:
trailer:
3000
min. 300 mm
min. 500 mm
min. 300 mm
EMBOSSED CARRIER TAPE
Tape (all dimensions in mm)
W
: 16,00 ± 0,3
Po
: 4,00 ± 0,1
Do
: 1,50 +0,1/-0
E
: 1,75 ± 0,1
F
: 7,50 ± 0,1
G(min)
: 0,60
P2
: 2,00 ± 0,1
P1
: 8,00 ± 0,1
D1(min)
: 1,50
Ao
: 5,50 ± 0,1
Bo
: 7,50 ± 0,1
Ct
: 13,5 ± 0,1
Do
Po
P2
E
Ao
F
D1
Ct
W
Bo
G
P1
COVER TAPE
W 2
Reel (all dimensions in mm)
A
: 330
W1
: 16,4 +2/-0
W2(max) : 22,4
N(min)
: 50
C
: 13,0 +0,5/-0,2
A
C
N
W 1
The minimum bending radius is 45 mm. The mounting surface of the filters faces the bottom side of the embossed carrier tape. Marking
of the filters can be read if the upper side of the carrier tape is regarded with the sprocket holes on the right.
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 549a.doc
Version 1.2
VI TELEFILTER
13.07.2004
Filter specification
TFS 549A
4/5
Air reflow temperature conditions
1st and 2nd air reflow profile
Name:
Temperature:
Time:
pre-heating periods main-heating periods
150 °C - 170 °C
over 200 °C
60 sec. - 90 sec.
20 sec. - 25 sec.
peak temperature
255 °C ± 5 °C
Chip-mount air reflow profile
260
240
220
200
temperature / °C
180
160
140
120
100
80
60
40
20
0
0
20
40
60
80
100
120
140
160
180
200
220
240
time / sec.
Table for temperature vs. time during the air reflow process
Tolerance of temperatures: ± 5 °C
time / sec.
0
10
20
30
40
50
60
70
80
90
100
110
120
130
temperature / °C
23
34
46
60
80
103
121
134
143
150
154
156
158
159
time / sec.
140
150
160
170
180
190
195
200
205
210
215
220
230
240
temperature / °C
160
161
164
170
180
205
230
255
230
205
180
165
140
120
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 549a.doc
VI TELEFILTER
Version 1.2
Filter specification
13.07.2004
TFS 549A
5/5
Version
Reason of Changes
Name
Date
1.0
- generate development specification
Roizengaft
02.02.2004
1.1
- matching circuit added
Steiner
12.02.2004
1.2
- terminating impedance, typical values and filter characteristic added
- matching configuration corrected
Pfeiffer
14.07.2004
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.