UTC MPSA06/56 AMPLIFIER TRANSISTOR NPN MPSA06 PNP MPSA56 FEATURES *Collector-Emitter Voltage: VCEO=80V *Collector Dissipation: PD=625mW 1 TO-92 1: EMITTER 2: BASE 3: COLLECTOR ABSOLUTE MAXIMUM RATINGS (TA=25°C, unless otherwise specified) PARAMETER SYMBOL RATING UNIT VCBO VCEO VEBO Ic PD Tj TSTG 80 80 4 500 625 5 1500 12 -55 ~ +150 -55 ~ +150 V V V mA mW mW/°C mW mW/°C °C °C SYMBOL MAX UNIT Thermal resistance, junction to ambient RθJA (note) 200 Thermal resistance, junction to case RθJC 83.3 Note: RθJA is measured with the device soldered into a typical printed circuit board. °C/W °C/W Collector-base voltage Collector-emitter voltage Emitter-base voltage Collector current - Continuous Total device dissipation, @TA=25°C Derate above 25°C Total device dissipation, @TC=25°C Derate above 25°C Junction Temperature Storage Temperature PD THERMAL CHARACTERISTICS PARAMETER ELECTRICAL CHARACTERISTICS (Ta=25°C, unless otherwise specified) PARAMETER OFF CHARACTERISTICS Collector-emitter breakdown voltage (note 1) Emitter-base breakdown voltage Collector cutoff current Collector cutoff current UTC SYMBOL TEST CONDITIONS MIN V(BR)CEO IC=1.0mA, IB=0 80 V(BR)EBO ICES ICBO IE=100µA, Ic=0 VCE=60V, IB=0 VCB=80V, IE=0 4 TYP MAX UNIT V 0.1 0.1 UNISONIC TECHNOLOGIES CO., LTD. V µA µA 1 QW-R201-035,A UTC MPSA06/56 PARAMETER ON CHARACTERISTICS DC current gain Collector-emitter saturation voltage Base-emitter on voltage SMALL-SIGNAL CHARACTERISTICS Current gain bandwidth product (note 2) AMPLIFIER TRANSISTOR SYMBOL TEST CONDITIONS MIN hFE IC=10mA, VCE=1V IC=100mA, VCE=1V IC=100mA, IB=10mA IC=100mA, VCE=1V 100 100 VCE(sat) VBE(on) fT MPSA06: IC=10mA, VCE=2V, f=100MHz MPSA56: IC=100mA, VCE=1V, f=100MHz TYP MAX UNIT 0.25 1.2 V V 100 MHz 50 MHz Note 1: Pulse test: PW<=300µs, Duty Cycle<=2% Note 2: fT is defined as the frequency at which IhfeI extrapolates to unity. SWITCHING TIME TEST CIRCUITS Figure 1 (Note: Total shunt capacitance of test jig and connectors for PNP test circuits, reverse all voltage polarities.) MPSA06 MPSA56 CURRENT-GAIN BANDWIDTH PRODUCT Figure 2 UTC Figure 3 UNISONIC TECHNOLOGIES CO., LTD. 2 QW-R201-035,A UTC MPSA06/56 AMPLIFIER TRANSISTOR MPSA06 MPSA56 CAPACITANCE Figure 4 Figure 5 SWITCHING TIME Figure 6 Figure 7 ACTIVE-REGION SAFE OPERATING AREA Figure 8 UTC Figure 9 UNISONIC TECHNOLOGIES CO., LTD. 3 QW-R201-035,A UTC MPSA06/56 AMPLIFIER TRANSISTOR MPSA06 MPSA56 DC CURRENT GAIN Figure 10 Figure 11 “ON” VOLTAGES Figure 12 Figure 13 COLLECTOR SATURATION REGION Figure 14 UTC Figure 15 UNISONIC TECHNOLOGIES CO., LTD. 4 QW-R201-035,A UTC MPSA06/56 AMPLIFIER TRANSISTOR MPSA06 MPSA56 BASE-EMITTER TEMPERATURE COEFFICIENT Figure 16 Figure 17 THERMAL RESPONSE Figure 18 UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UTC UNISONIC TECHNOLOGIES CO., LTD. 5 QW-R201-035,A