VECTRON TFS246H4

Filename: tfs246h4.doc
version 1.3
VI TELEFILTER
16.05.2002
Filter Specification
TFS 246 H4
1/5
Measurement condition
Ambient temperature:
Input power level:
Terminating impedances
Input:
Output:
External coil:
°C
dBm
23
0
*)
490
490
270
Ω || -2.62 pF
Ω || -2.62 pF
nH
Characteristics
Remark:
Reference level for the relative attenuation arel of the TFS246H4 is the minimum of the pass band attenuation amin. The minimum of the pass
band attenuation amin is defined as the insertion loss ae. The centre frequency fc is the arithmetic mean value of the upper and lower frequencies
at the 3 dB filter attenuation level relative to the insertion loss ae. The nominal frequency fN is fixed at 246 MHz without any tolerance. The given
values for the relative attenuation arel and for the group delay ripple have to be reached at the frequencies given below even if the centre
frequency fc is shifted due to the temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance
for the centre frequency fc.
Data
typ. value
Insertion loss
(Reference level)
ae = amin
2,5
Nominal frequency
fN
-
Pass band ripple
fN - 85 kHz ... fN + 93 kHz
Relative attenuation
fN
fN ±
330
kHz ...
fN ±
400
kHz ...
fN ±
600
kHz ...
fN ±
800
kHz ...
fN ±
1,6 MHz ...
fN ±
3,0 MHz ...
fN ±
20
MHz ...
dB
tolerance / limit
max
5
dB
246,000 MHz
0,5
dB
max
1,5
22
33
41
47...55
52...55
54
55...70
dB
dB
dB
dB
dB
dB
dB
dB
max
min
min
min
min
min
min
min
0,5
0,8
1,2
µs
µs
µs
max
max
max
1,5
dB
arel
fN
fN
fN
fN
fN
fN
fN
fN
±
±
±
±
±
±
±
±
Group delay distortion
fN ±
50
kHz
fN ±
70
kHz
fN ±
100
kHz
120
400
600
800
1,6
3,0
20
100
kHz
kHz
kHz
MHz
MHz
MHz
MHz
MHz
3
18
25
40
45
45
46
45
dB
dB
dB
dB
dB
dB
dB
dB
GDD
1,2
1,5
2,5
µs
µs
µs
Operating temperature range
-
- 25 °C ... + 85 °C
Storage temperature range
-
- 30 °C ... + 85 °C
Temperature coefficient of frequency
Frequency inversion temperature T0
TCf **)
- 0,036 ppm/K²
+ 25
°C
-
*) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as
reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team.
**) ∆f(Hz) = TCf(ppm/ K²) x (T-T0)² x fTo(MHz)
Generated:
Checked / approved:
VI TELEFILTER
Vectron International, Inc.
Potsdamer Straße 18
267 Lowell Road
D 14 513 TELTOW / Germany
Hudson, NH 03051 / USA
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
Tel: (603) 598-0070 Fax: (603) 598-0075
E-Mail: [email protected]
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs246h4.doc
version 1.3
VI TELEFILTER
16.05.2002
Filter Specification
TFS 246 H4
2/5
Construction and pin configuration
(All dimensions in mm)
S 246 H4
P16
3
2 Ma x.
1
Year + week
2000
2001
2002
1
7
3,4
2,5,6,8,9,10,11,12
Input
Output
External coil
Ground
5,2 Ma x.
2,54 +-0,2
7,2 Ma x.
2,54+-0,2
Datecode
M
N
P
...
0,8
50 Ohm Test circuit 1
L1
L2
1
7
SAW
C1
C2
3
4
L3
2,5,6,8,9,10,11,12
50 Ohm Test circuit 2
C1
C2
1
7
SAW
L1
L2
3
4
L3
2,5,6,8,9,10,11,12
VI TELEFILTER
Vectron International, Inc.
Potsdamer Straße 18
267 Lowell Road
D 14 513 TELTOW / Germany
Hudson, NH 03051 / USA
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
Tel: (603) 598-0070 Fax: (603) 598-0075
E-Mail: [email protected]
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs246h4.doc
version 1.3
VI TELEFILTER
16.05.2002
Filter Specification
TFS 246 H4
3/5
Stability characteristics
After the following tests the filter shall meet the whole specification:
1. Shock:
500g, 18 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
2. Vibration:
10 Hz to 500 Hz, 0,35 mm or 5g respectively, 1 octave per min, 10 cycles per plan, 3 plans;
DIN IEC 68 T2 - 6
3. Change of
temperature:
-55 °C to 125°C / 30 min. each / 10 cycles
DIN IEC 68 part 2 – 14 Test N
4. Resistance to
solder heat (reflow): reflow possible: twice max.;
for temperature conditions, please refer to the attached "Air reflow temperature conditions" on page 4;
Packing
Tape & Reel:
IEC 286 - 3, with exception of value for N and minimum bending radius;
tape type II, embossed carrier tape with top cover tape on the upper side;
max. pieces of filters per reel:
Reel of empty components at start:
Reel of empty components at start including leader:
Trailer
Tape (all dimensions in mm)
W
:
16
± 0,3
Po
:
4
± 0,1
Do
E
:
:
1,5 + 0,1
1,75 ± 0,1
F
:
7,5 ± 0,1
G (min) :
0,6
P2
:
2
± 0,1
P1
:
8
± 0,1
3000
min 300 mm
min 500 mm
min 300 mm
EMBOSSED CARRIER TAPE
Do
Po
P2
E
Ao
F
D1
13,4
± 0,1
W
Bo
G
D1(min) :
1,5
Ao
:
5,5
± 0,1
Bo
:
7,5
± 0,1
P1
COVER TAPE
W 2
Reel (all dimensions in mm):
A
W1
:
:
330
16,4 +2
W2 (max) :
22,4
N (min)
:
50
C
:
13
+ 0,5 / - 0,2
A
C
N
W 1
The minimum bending radius is 45 mm. The mounting surface of the filters faces the bottom side of the embossed carrier tape.
Markings on the filters can be read if the upper side of the carrier tape is regarded with the sprocket holes on its right.
VI TELEFILTER
Vectron International, Inc.
Potsdamer Straße 18
267 Lowell Road
D 14 513 TELTOW / Germany
Hudson, NH 03051 / USA
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
Tel: (603) 598-0070 Fax: (603) 598-0075
E-Mail: [email protected]
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs246h4.doc
version 1.3
VI TELEFILTER
16.05.2002
Filter Specification
TFS 246 H4
4/5
Air reflow temperature conditions
1st and 2nd air reflow profile
Name:
Temperature:
Time:
pre-heating periods
150 °C - 170 °C
60 sec. - 90 sec.
main-heating periods
over 200 °C
20 sec. - 25 sec.
peak temperature
255 °C ± 5 °C
Chip-mount air reflow profile
260
240
220
200
temperature / °C
180
160
140
120
100
80
60
40
20
0
0
20
40
60
80
100
120
140
160
180
200
220
240
time / sec.
Table for temperature vs. time during the air reflow process
Tolerance of temperatures: ± 5 °C
time / sec.
0
10
20
30
40
50
60
70
80
90
100
110
120
130
temperature / °C
23
34
46
60
80
103
121
134
143
150
154
156
158
159
time / sec.
140
150
160
170
180
190
195
200
205
210
215
220
230
240
temperature / °C
160
161
164
170
180
205
230
255
230
205
180
165
140
120
VI TELEFILTER
Vectron International, Inc.
Potsdamer Straße 18
267 Lowell Road
D 14 513 TELTOW / Germany
Hudson, NH 03051 / USA
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
Tel: (603) 598-0070 Fax: (603) 598-0075
E-Mail: [email protected]
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs246h4.doc
VI TELEFILTER
version 1.3
Filter Specification
16.05.2002
TFS 246 H4
5/5
History
Version
Reason of Changes
Name
Date
1.0
Generate specification according to customer’s requirements
Dr. Wall
07.02.2002
1.1
Add and correct typical data.
Correct value for coupling coil.
Dr. Wall
27.03.2002
1.2
Change operating temperature range from –20°C ... 85°C to –25°C ... 85°C
Dr. Wall
19.04.2002
1.3
Correct typo for first selection value (from 8 to 18 dB)
Dr. Wall
16.05.2002
VI TELEFILTER
Vectron International, Inc.
Potsdamer Straße 18
267 Lowell Road
D 14 513 TELTOW / Germany
Hudson, NH 03051 / USA
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
Tel: (603) 598-0070 Fax: (603) 598-0075
E-Mail: [email protected]
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.