Automotive Relays High Current Devices High Current Relay 150 nLimiting continuous current 130A at 85°C switching ability up to 300A nSuitable for voltage levels up to 24VDC nHeat, moisture and vibration resistant nMinimal contact resistance nDustproof and sealed versions nCurrent Typical applications Engine control, glow plug, heated front screen, preheating systems (e.g. for diesel engines, catalytic converters), switches for loading ramps, start/stop. F132_fcw2b Contact Data Contact arrangement 1 form A, 1 NO 1 form B, 1 NC 1 form C, 1 CO 1 form X, 1 NO DM Rated voltage 12VDC/24VDC Max. switching voltage depends on load parametersA) Rated current, cable 25mm2 130A at 85°C Limiting continuous current 23°C, load cable 16mm2 130A 85°C, load cable 16mm2 120A 125°C, load cable 16mm2 60A 23°C, load cable 25mm2 180A 85°C, load cable 25mm2 130A 125°C, load cable 25mm2 70A Limiting making current, load current max. 3s on, make/break ratio 1:10 300A Limiting breaking current 300A Contact material AgSnO2 Min. recommended contact load4) 1A at 5VDC Initial voltage drop, typ. at 100A 70mV Frequency of operation, with/without load 6 ops./min Operate/release time typ. at nominal voltage 25/8ms Electrical endurance form A contact (NO), resistive load, cyclic temperature:+23°C >5x104 cycles at 300A, 13.5VDC Mechanical endurance >107 ops. Coil Data Rated coil voltage Rated coil power Max. coil temperature 12/24VDC 3.3W1) 155°C Coil versions, DC coil1) Coil Rated Operate Release Coil Rated coil codevoltagevoltagevoltage resistancepower VDCVDCVDC Ω±10%W 00112 7.21.237 3.9 0022414.4 2.4141 4.1 1) With resistor. All figures are given for coil without preenergization, at ambient temperature +23°C. Coil operating range ECR1449-V 300 Does not ta the tempera the contact E = pre-ene A) Please contact TE relay application engineer. Does not take into account the temperature rise due to the contact current E = pre-energization Insulation Data Initial dielectric strength between contact and coil Load dump test ISO 7637-1 (12VDC), test pulse 5 ISO 7637-2 (24VDC), test pulse 5 08-2012, Rev. 0812 www.te.com © 2012 Tyco Electronics Corporation, a TE Connectivity Ltd. company. Datasheets and product specification according to IEC 61810-1 and to be used only together with the ‘Definitions’ section. Datasheets and product data is subject to the terms of the disclaimer and all chapters of the ‘Definitions’ section, available at http://relays.te.com/definitions 1000VACrms Vs=+86.5VDC Vs=+200VDC Datasheets, product data, ‘Definitions’ section, application notes and all specifications are subject to change. 1 Automotive Relays High Current Devices High Current Relay 150 (Continued) Other Data Other Data (continued) Terminal type Cover retention pull force push force Terminal retention pull force push force resistance to bending force applied to side torque Weight Packaging unit EU RoHS/ELV compliance compliant Ambient temperature -40°C to +125°C Dry heat, IEC 60068-2-2 500h at 100°C Damp heat constant, IEC 60068-2-3 (78), Ca 500h, 40°C, 93% RH Degree of protection dustproof: IP54 (IEC 60529), RT I (IEC 61810) sealed: sealing in accordance with IEC 68 immersion cleanable: IP67 (IEC 60529), RT III (IEC 61810) Corrosive gas IEC 60068-2-42 10 days IEC 60068-2-43 10 days Vibration resistance (functional) IEC 60068-2-6 (sine sweep) 10 to 200Hz >5g2) Shock resistance (functional) IEC 60068-2-27 (half sine) 6ms >20g2) Drop test, free fall IEC 60068-2-32 1m onto concrete screw 500N 500N 150N 150N 20N 20N 5Nm approx. 220g (7.8oz) 50 pcs. 2) No change in the switching state >10µs. Terminal Assignment NOR 1 form A, 1 NO with resistor COR 1 form C, 1 CO with resistor 2 5 2 1 3 1 5 NOBRR 1 form X, 1 NO DM with resistor 4 2 3 5b 1 View of the terminals Bottom view Dimensions NO and NO DM version .5 x 6.5 5 84 84 63 63 40 40 15.5 7.5 x 6.5 45 45 65.2 3.5 13.5 71 Ø 6.5 *) 65.2 71 Ø 6.5 TE1667-61 Connector 2-pole Connector 17 2-pole 17 Screw terminals Screw M6terminals M6 TE1666-X1 TE1666-X1 *) Alternatively 5b for form X, 1 NO DM with resistor. Connector Information AMP SUPERSEAL 1.5 SERIES Coil side - Receptacle connector 282080-1 - Single wire seal 281934-2 - Contact 282110-1 Load side Cable lug M6, maximum cable section 25 mm² 2 08-2012, Rev. 0812 www.te.com © 2012 Tyco Electronics Corporation, a TE Connectivity Ltd. company. Datasheets and product specification according to IEC 61810-1 and to be used only together with the ‘Definitions’ section. Datasheets and product data is subject to the terms of the disclaimer and all chapters of the ‘Definitions’ section, available at http://relays.te.com/definitions Datasheets, product data, ‘Definitions’ section, application notes and all specifications are subject to change. Automotive Relays High Current Devices High Current Relay 150 (Continued) Dimensions CO version Load terminals Screw M6 Max. torsion of screw bolts: 5Nm 2 pole tab connector TE AMP MCP 1.2 132CO_DD1 View of the terminals Product code structure Typical product code V23132-A2001 -A Type V23132 High Current Relay 150 Contact arrangement A2 1 form A, 1 NO B2 1 form X, 1 NO DM Coil 001 12VDC Protection class A IP54 Contact material 2 AgSnO2 Standard version 00 Standard Product code D2 E2 1 form B, 1 NC 1 form C, 1 CO 002 24VDC B IP67 Arrangement V23132-A2001-A200 1 form A, 1 NO V23132-A2001-A200-EV-USBX*) V23132-A2001-B200 V23132-A2001-B200-EV-USBX*) V23132-B2002-A200 1 form X, 1 NO DM V23132-B2002-B200 V23132-B2002-B200-EV-USBX*) V23132-D2001-B200 1 form B, 1 NC V23132-E2001-A200 1 form C, 1 CO Coil 12VDC Circuit NOR Coil suppr. Protect. Contact mat. Terminals Part number Resistor IP54 AgSnO2 IP67 24VDC NOBRR 12VDC 12VDC NCR COR 2 00 IP54 IP67 IP54 Screw 1393315-2 7-1414968-8*) 1416010-1 2-1414939-2*) 1393315-9 1-1393315-1 5-1414968-1*) on request 9-1415001-5 Other types on request. This list represents the most common types and does not show all variants covered by this datasheet. *) Americas market only. 08-2012, Rev. 0812 www.te.com © 2012 Tyco Electronics Corporation, a TE Connectivity Ltd. company. Datasheets and product specification according to IEC 61810-1 and to be used only together with the ‘Definitions’ section. Datasheets and product data is subject to the terms of the disclaimer and all chapters of the ‘Definitions’ section, available at http://relays.te.com/definitions Datasheets, product data, ‘Definitions’ section, application notes and all specifications are subject to change. 3