SEi - Radiation Hardened 54HC4046RP Phase-Locked Loop Features •Maximum VCO Operating Frequency - 12 MHz (VCC = 4.5V) •Fast Comparator Response Time (VCC = 4.5V) - Comparator I: 25 ns - Comparator II: 30 ns - Comparator III: 25 ns •Screening per TM 5004 •QCI per TM5005 •RAD-PAK Technology Hardened Against Natural Space Radiation •Total Dose Hardness >100 krad (Si) •Low Power Phase Lock Loop •Package: -16 Pin RAD-PAK Flat Package -16 Pin RAD-PAK DIP •Low Dynamic Power Consumption - VCC = 4.5V S Ei’s 54HC4046RP (RP for RAD-PAK ) high speed Phase Lock Loop microcircuit features a 100 kilorad (Si) ® total dose tolerance. This device uses advanced CMOS technology to obtain high frequency operation. The 54HC4046RP contains a low power linear voltage controlled oscillator (VCO), a source follower, and three phase comparators. The three phase comparators have a common signal input and a common comparator input. The signal input has a self biasing amplifier allowing signals to be either capacitively coupled to the phase comparators with a small signal or directly coupled with standard input logic levels. Any one of the three comparators feeds an external filter network, which in turn feeds the VCO input. This input is a very high impedance CMOS input that also drives the source follower. An inhibit pin is provided to disable the VCO and the source follower, providing a method of putting the IC in a low power state. Capable of surviving space environments, the 54HC4046RP is ideal for many satellite, spacecraft, and space probe missions. The radiation hardened RADPAK® technology incorporates radiation shielding in the microcircuit package. The 54HC4046RP is available in Class S packaging and screening. Specifications and design are subject to change without notice. --9.9-- 4031 Sorrento Valley Blvd. San Diego, CA 92121 (619) 452-4167 Fax (619) 452-5499 Email: [email protected] http://www.spaceelectronics.com 1 SEi - Radiation Hardened 54HC4046RP Phase-Locked Loop 54HC4046RP OPERATING CONDITIONS 54HC4046RP ABSOLUTE MAXIMUM RATINGS 1/ 2/ PARAMETER SYMBOL MIN MAX UNIT PARAMETER SYMBOL MIN Supply Voltage VCC VIN VOUT IIK, IOK IOUT ICC -0.5 -0.5 -0.5 +7.0 V V V mA mA mA Supply Voltage VCC+0.5 VCC VIN, VOUT TSTG PD -65 DC Input Voltage DC Output Voltage Clamp Diode Current DC Output Current, per pin DC V CC or GND Current, per pin Storage Temperature Range Power Dissipation VCC+0.5 ±20 +25 ±50 +150 500 o C mW DC Input or Output Voltage Operating Temperature Range Input Rise or Fall Times VCC = 2.0V VCC = 4.5V VCC = 6.0V TA MAX UNIT +2.0 +6.0 V 0 VCC V -55 +125 oC 0 0 0 1000 500 400 ns tr, tf Note: 1/ Maximum Ratings are those values beyond which damage to the device may occur. 2/ All voltages are referenced to ground, unless otherwise specified. 54HC404SRP DC ELECTRICAL CHARACTERISTICS1 PARAMETER Minimum High Level Input Voltage VCC = 2.0V VCC = 4.5V VCC = 6.0V Maximum Low Level Input Voltage VCC = 2.0V VCC = 4.5V VCC = 6.0V Minimum High Level Output Voltage VIN = VIH or VIL |IOUT| ≤ 20uA VCC = 2.0V VCC = 4.5V VCC = 6.0V VIN=VIH or VIL |IOUT| ≤ 4.0mA @V CC = 4.5V |IOUT| ≤ 5.2mA @V CC = 6.0V Maximum Low Level Output Voltage VIN = VIH or VIL |IOUT| ≤ 20uA VCC = 3.0V VCC = 4.5V VCC = 6.0V VIN = VIH or VIL |IOUT| ≤ 4.0mA @V CC = 4.5V |IOUT| ≤ 5.2mA @V CC = 6.0V Input Current VIN=VCC or GND @VCC=6.0V Pin 3, 5, 9 Pin 14 Maximum Tri-State Output Leakage Current (pin 13) VOUT = V CC or GND @ VCC = 6.0V Maximum Quiescent Supply Current VIN = VCC or GND , IOUT = 0uA, @VCC = 6.0V VIN = VCC or GND, Pin 14 Open, @V CC = 6.0V SYMBOL TYP MAX UNIT 1.5 3.15 4.2 V 0.5 1.35 1.8 V 2.0 4.5 6.0 1.9 4.4 5.9 V 4.2 5.7 3.7 5.2 VIH VIL VOH VOL 0.1 0.1 0.1 V 0.4 0.4 IIN +1.0 100 uA +10 uA 160 3000 uA IOZ ICC 30 600 Note: 1. For a power supply of 5V ± 10% the worst case output voltages (V OH and VOL) occur at 4.5V. Thus the 4.5V values should be used when designing with this supply. Worst case VIH and VIL occur at VCC = 5.5V and 4.5V respectively. The worst case leakage current (I IN, ICC, and IOZ) occur for CMOS at the higher voltage and so the 6.0V values should be used. 2 --9.9-- 4031 Sorrento Valley Blvd. San Diego, CA 92121 (619) 452-4167 Fax (619) 452-5499 Email: [email protected] http://www.spaceelectronics.com SEi - Radiation Hardened 54HC4046RP Phase-Locked Loop PARAMETER 54HC4046RP AC ELECTRICAL CHARACTERISTICS 2/ SYMBOL TYP 3/ AC Coupled Input Sensitivity, Signal In C(series) = 100 pF, fIN = 500 kHz VCC = 2.0V VCC = 4.5V VCC = 6.0V Maximum Output Rise and Fall Time VCC = 2.0V VCC = 4.5V VCC = 6.0V MAX UNIT 200 250 350 mV 110 22 19 ns 300 60 51 ns 340 68 57 ns 360 72 61 ns 360 72 61 ns 380 75 64 ns 300 60 51 ns tr, tf PHASE COMPARATOR I tPHL, tPLH Maximum Propagation Delay VCC = 2.0V VCC = 4.5V VCC = 6.0V PHASE COMPARATOR II Maximum Tri-State Enable Time VCC = 2.0V VCC = 4.5V VCC = 6,0V Maximum Tri-State Enable Time VCC = 2.0V VCC = 4.5V VCC = 6,0V Maximum Tri-State Disable Time VCC = 2.0V VCC = 4.5V VCC = 6,0V Maximum Propagation Delay High to Low to Phase Pulses VCC = 2.0V VCC = 4.5V VCC = 6,0V tPZL tPZH, tPHZ tPLZ tPHL, tPLH PHASE COMPARATOR III Maximum Propagation Delay VCC = 2.0V VCC = 4.5V VCC = 6.0V Maximum Power Dissipation Capacitance All comparators, V IN = VCC and GND tPHL, tPLH CPD 130 pF 7 11 MHz VOLTAGE CONTROLLED OSCILLATOR (operate @ VCC = 3.0v to 6.0V) Maximum Operating Frequency C1 = 50pF, R1 = 100Ω , R2 = ∞ VCC = 4.5V VCC = 6.0V VCOin = VCC, C1 = 0pF, R1 = 100Ω , VCOin = V CC VCC = 4.5V VCC = 6.0V Duty Cycle fMAX 12 14 50 % DEMODULATOR OUTPUT Offset Voltage (VCOin - Vdem) RS = 20kΩ , VCC = 4.5V Offset Variation RS = 20kΩ , VCC = 4.5V VCOin = 1.75V VCOin = 2.25V VCOin = 2.75V Note: 2/ VCC = 2.0 to 6.0V, CL = 50pF, tr = tf = 6ns (unless otherwise specified.) 3/ TA = 25oC. 1.6 0.65 0.1 0.75 V V 3 --9.9-- 4031 Sorrento Valley Blvd. San Diego, CA 92121 (619) 452-4167 Fax (619) 452-5499 Email: [email protected] http://www.spaceelectronics.com SEi - Radiation Hardened 54HC4046RP Phase-Locked Loop 54HC4046RP Package Ordering Guide Package Style Case Outline Description D F D-16 F-16A 16 Pin Dual In Line Package 16 Pin Flat Package Note: 1/ For outline information, see Appendix A (Package Information - Outline Dimension) 54HC4046RP PINOUT PIN 1 2 SIGNAL DESCRIPTION PHASE PULSES Phase Comparator Pulse Output PHASE COMP 1 OUT Phase Comparator 1 Output 3 COMPARATOR IN 4 VCO OUT VCO Output 5 INHIBIT Inhibit Input 6 C1A C1B 7 8 9 10 Comparator Input Capacitor C1 Connection A Capacitor C1 Connection B VSS VCO IN Ground VCO Input DEMODULATOR OUT Demodulator Output 11 R1 Resistor R1 Connection 12 R2 Resistor R2 Connection 13 14 15 PHASE COMP II OUT Phase Comparator 2 Output SIGNAL IN Signal Input PHASE COMP III OUT Phase Comparator 3 Output VDD Positive Supply Voltage 4 --9.9-- 4031 Sorrento Valley Blvd. San Diego, CA 92121 (619) 452-4167 Fax (619) 452-5499 Email: [email protected] http://www.spaceelectronics.com SEi - Radiation Hardened 54HC4046RP Phase-Locked Loop 5 --9.9-- 4031 Sorrento Valley Blvd. San Diego, CA 92121 (619) 452-4167 Fax (619) 452-5499 Email: [email protected] http://www.spaceelectronics.com SEi - Radiation Hardened 54HC4046RP Phase-Locked Loop 6 --9.9-- 4031 Sorrento Valley Blvd. San Diego, CA 92121 (619) 452-4167 Fax (619) 452-5499 Email: [email protected] http://www.spaceelectronics.com SEi - Radiation Hardened 54HC4046RP Phase-Locked Loop 7 --9.9-- 4031 Sorrento Valley Blvd. San Diego, CA 92121 (619) 452-4167 Fax (619) 452-5499 Email: [email protected] http://www.spaceelectronics.com SEi - Radiation Hardened 54HC4046RP Phase-Locked Loop 8 --9.9-- 4031 Sorrento Valley Blvd. San Diego, CA 92121 (619) 452-4167 Fax (619) 452-5499 Email: [email protected] http://www.spaceelectronics.com SEi - Radiation Hardened 54HC4046RP Phase-Locked Loop 9 --9.9-- 4031 Sorrento Valley Blvd. San Diego, CA 92121 (619) 452-4167 Fax (619) 452-5499 Email: [email protected] http://www.spaceelectronics.com